Whirlpool ADG 150 Quick Reference Guide

3GB96001.fm Page 1 Tuesday, November 26, 2002 2:39 PM

Before using the dishwasher, read the user instructions!

ADG 150

Indicators

Quick Reference Guide

On/Off button

Press the ON button to switch on the
dishwasher.

Push Push Programme Selector knob

Press the knob and select a programme by
turning it.

GB

Add regeneration salt

Only add regeneration salt immediately
before starting a wash programme.

Programme chart

Programmes Loading instructions

Pre-Rinse cold

Intensive 65°C

Normal

1) Reference programme for energy label in compliance with
EN 50242 regulations;

2) Refer to “User instructions“;

Whirlpool is a registered trademark of Whirlpool USA

1)

Crockery to be washed later. - - 5.0 0.02 9

Recommended programme f or heavily soiled
crockery, especially suitable for pans and
saucepans.

Normally or heavily soiled crockery. X X 16.0 1.26 85

65°C

Detergent

3) Program data obtained in conformity with European standard
EN 50242. Values may vary in relation to usage, e.g.:
different loads, wa ter temperatures - above or below 15°C ­as well as water hardness and power supply voltage, etc.

2)

A B Litres kWh Minutes

X X 20.0 1.45 100

Consumption

3)

5019 396 96001

(We reserve the right to make technical modifications)

Black process 45.0° 100.0 LPI

D

3GB96001.fm Page 2 Tuesday, November 26, 2002 2:39 PM

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Close the door

How to fill the

detergent dispenser

Check the rinse aid level

Check the regeneration

salt level

Load the racks

Select a programme

Select additional options

Press the

Large compartment
With each wash cycle.
Small compartment
For programmes with pre-wash only.

Mechanical indicator C.
Electric indicator on control panel (if provided).

On models with water softener system
only.

Mechanical indicator D.
Electric indicator on control panel
(if provided).

Refer to the dishwasher loading instructions.

Press the knob and select a programme by turning it.

If necessary (and if provided).
The corresponding indicator lamp lights up.

On/Off

button .

A:

B:

A

B

C

Press the On/Off button to

start the programme

Turn on the water tap,

close the dishwasher door

Wa sh cycle

Switch off the appliance

Turn off the water

tap, unload the racks

Black process 45.0° 100.0 LPI

“Cancel”

Press the On/Off button to
switch off the appl iance.

Select Pre-rinse programme

(approx. 10 min.).

Press the On/Off button to

start the selected programme.

Press the On/Off button to switch off the appliance.

Warning: When the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

“Change programme in progress”

Press On/Off button to switch off

the appliance.
Select another programme.
Press On/Off button to start the

selected programme.

- Only open the dishwasher if necessary
(Warning: beware of hot steam).

- If the appliance is switch ed o ff d urin g a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.