PM600
PM SERIES POWERED MIXERS:
PM500 SYSTEM
PM600 SYSTEM
!Warning – read all operating and service instructions that accompany this appliance! !Varning – läs alla användaroch serviceinstruktioner som medföljer enheten! !Atenção - leia todas as instruções de manutenção e de operação
que acompanham este aparelho! !AVVERTENZA – Leggere attentamente le istruzioni per il funzionamento e la
manutenzione fornite con l'unità! !Aviso: Lea todas las instrucciones de funcionamiento y de mantenimiento que se
adjuntan a este aparato!Vaara – lue kaikki laitteen mukana toimitetut käyttö- ja huolto-ohjeet! !Advarsel – læs alle
betjenings- og serviceanvisninger, der følger med produktet! !Waarschuwing – lees alle bedienings- en onder-
houdsinstructies die bij dit apparaat horen! !Vorsicht - Lesen Sie diese Bedienungsanleitung sorgfältig durch!
!Attention: Lisez attentivement les instructions avant d’utiliser ce produit!
FORSIKTIGHET: För att minska risken för elstötar bör man inte ta bort enhetens ytterhölje (eller det bakre skyddshöljet). Reparationer får bara genomföras av kvalificerade servicetekniker.
AVISO: Para reduzir o risco de choque eléctrico, não remova a tampa (ou a cobertura traseira). O usuário não deve
efectuar a manutenção. Deve pedir aos técnicos qualificados em manutenção.
ATTENZIONE: Per ridurre il rischio di scosse elettriche, non rimuovere la copertura (o il pannello posteriore). Le
operazioni di manutenzione devono essere eseguite esclusivamente da personale qualificato.
PRECAUCION: Con el fin de reducir el riesgo de sacudidas eléctricas, no desmonte la tapa (o la tapa posterior). El
mantenimiento no deberá ser realizado por el usuario, sino por el personal de mantenimiento cualificado.
WARNING: To reduce the risk of electric shock, do not remove cover (or back). No user servicing to qualified service personnel.
VAROITUS: Tulipalo- ja sähköiskuvaaran vähentämiseksi älä irrota suojusta (tai takapaneelia). Älä huolla laitetta
itse,anna huoltotyöt ammattitaitoisen huoltohenkilökunnan tehtäväksi.
FORSIGTIG: For at mindske risikoen for elektrisk stød må du ikke fjerne beklædningen (eller bagbeklædningen).
Reparationer må kun udføres af kvalificeret servicepersonale.
PAS OP: Om de kans op elektrische schokken te minimaliseren, dient u de afdekklep (of achterkant) niet te verwijderen. Onderhoud dient alleen te worden uitgevoerd door gekwalificeerd personeel.
VORSICHT: Um diee Gefahr eines elektrischen Schlages zu vermeiden darf die Abdeckung nicht entfernt werden.
Die Wartung des Gerätes sollte qualifiziertem Fachpersonal vorbehalten bleiben.
CAUTION: Pour réduire les risques d’électrocution, ne pas démonter le capot. La manipulation doit être effectuée
par un personnel agréé.
Wharfedale Professional Limited Warranty: The PM Series of Powered Mixers are warranted to be
clear of manufacturing or materials defects for a period of one year from the original date of purchase. In
the event of malfunction, contact your authorised Wharfedale Professional dealer of distributor. Be aware
that warranty details differ from country to country.
Unpacking: All Wharfedale Pro Products are fully checked before leaving the factory. After unpacking
please inspect the units for any physical damage. Please retain the shipping carton if possible and internal packing material in case the unit needs to be returned. Please check as soon as possible that the
unit is functioning. In the event of any damage please contact your dealer immediately so that a written
claim for damages may be made.
WARNING: DUE TO THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE THIS
UNIT TO RAIN OR MOISTURE.
PM Series Instruction Manual Page 1
WHARFEDALE PROFESSIONAL PM SERIES POWERED MIXERS
CONTENTS:
PAGE 3: INTRODUCTION
FEATURES PM500 AND PM600
GETTING STARTED WITH YOUR PM SYSTEM
PAGE 4: FEATURES PT LOUDSPEAKERS
PAGE 5: CHANNEL STRIP DESCRIPTION
PAGE 6: DIGITAL DELAY SECTION
MASTER CONTROL
PAGE 7: TAPE IN AND RECORD OUT
REAR PANEL PM500
PAGE 8: REAR PANEL PM600
PAGE 9: APPLICATIONS
PAGE 10: DIMENSIONS
PAGE 11: SPECIFICATIONS PM MIXER SECTION
PAGE 12: SPECIFICATIONS PT LOUDSPEAKERS
PM Series Instruction Manual Page 2
WHARFEDALE PROFESSIONAL PM SERIES POWERED MIXERS
INTRODUCTION:
Congratulations on the purchase of your PM System from Wharfedale Professional. The PM System is
available in a choice of two versions - the PM 500 and the PM 600. The PM500 System comprises 1 x
PM 500 powered mixer, two PT10 two way 10” loudspeakers and one DM1.0 dynamic microphone (plus
one mic cable and two speaker cables).The PM600 System comprises 1 x PM600 powered mixer, two
PT12 two way 12” loudspeakers and one DM1.0 dynamic microphone (plus one mic cable and two speaker cables).
In order to get the most satisfaction from your PM System, please read this manual carefully.
GETTING STARTED:
1. Before you turn on the main power to the unit, ensure that the Master Output Control is in the OFF
position.
2. If you need to connect or disconnect any cables or units, make sure the Power is OFF before doing so.
3. Check that the voltage of the unit matches the AC voltage you will be operating with.
FEATURES OF THE PM POWERED MIXER SECTION OF YOUR SYSTEM:
FEATURES:
PM600
• Five Mic and six line input sockets
• Channel six features extra Tape In button
• Digital Delay Section
• Three Band EQ in Master Section
• Tape In
• Record Out
• EFX Return
• EFX Send
• Power On/Off on front of unit for ease of use
• Parallel speaker outputs on rear of unit
• Main line output on rear of unit
• Built in 230 watt power amplifier
• Two band channel EQ
• XLR plus 1/4” input sockets
• Fan cooling system
• Thermal protection
PM500
• Four Mic and five Line input sockets
• Channel five features Tape In Button
• Main line output on rear of unit
• Two band Channel EQ
• XLR plus 1/4” input sockets
• Digital Delay Section
• Record Out
• Built in 120 watt power amplifier
• Thermal protection
PM Series Instruction Manual Page 3
FEATURES OF THE PT LOUDSPEAKER SECTION OF YOUR SYSTEM:
An integral part of the PM Systems are the PT loudspeakers. The PM500 comes with a pair of PT10
loudspeakers whilst the PM600 comes with a pair of PT12 loudspeakers. The PT series are high output,
high efficiency loudspeakers featuring Wharfedale Pro proprietary drive unit and a purpose built high quality Electro-Dynamic high frequency driver. With built in high frequency driver overload protection, the PT
series are perfect for life on the road. The PT Series are built using a tough steel grille and tough road
tested carpet. Each loudspeaker has a pole mount top hat for use with poles or tripods.60° x 90° radial
horn featuring Wharfedale Pro proprietary components.
CHECK YOU HAVE ALL THE COMPONENTS OF YOUR SYSTEM:
Please check that you have the components listed below before setting up your PM System.
PM500 System:
1 PM500 Powered Mixer
1 Pair Wharfedale PT10 loudspeakers
2 cables (mixer to loudspeaker 1/4” jack)
1 Wharfedale DM1.0 Microphone with lead
PM600 System:
1 PM600 Powered Mixer
1 Pair Wharfedale PT12 loudspeakers
2 cables (mixer to loudspeaker 1/4” jack)
1 Wharfedale DM1.0 Microphone with lead
PM Series Instruction Manual Page 4
Loading...