LAVATORY FAUCET INSTALLATION GUIDE
BEFORE YOU BEGIN
1)Shut off water supply.
2)Carefully inspect waste and supply tubing for signs of damage.
3)Replace waste or supply tubing if necessary
A) SPOUT INSTALLATION
1)Remove washer, lock nut and connect tee.
2)Apply plumbers’ putty or sealant.
3)Locate mounting hole and insert spout into deck or lavatory.
4)Screw and tighten washers, lock nut onto the shank and secure the spout
5)Screw and tighten the connect tee to the shank.
6)Remove excessive plumbers’ putty or sealant.
FLOW REGULATOR
METAL WASHER
LOCK NUT
CONNECT TEE
MODEL: F2-0013
TOOLS AND MATERIALS
Basin Wrench |
Adjustable wrench |
Teflon Tape |
|
Pipe Wrench |
Screwdriver |
Flexible Water |
|
Supply Line |
|||
|
|
B) HANDLE VALVE INSTALLATION
1)Place lower plastic washer and lock nut over valve body.
2)Insert valve body from under the sink.
3)Place upper rubber washers and escutcheon on valve spindle.
4)Adjust position of valve body. Secure valve body with lock nut and escutcheon.
5)Place handle onto spindle.
6)Tighten handle with screw.
HANDLE
ESCUTCHEON
RUBBER WASHER
PLASTIC WASHER
LOCK NUT
VALVE BODY