Vulcan-Hart VCM36, VCM24, VCM72, VCM60, VCM34 User Manual

INSTALLATION & OPERATION MANUAL FOR

Cheesemelters

MODELS

MLS

VCM24

ML-135124

VCM34

ML-135123

VCM36

ML-135126

VCM48

ML-135127

VCM60

ML-135128

VCM72

ML-135129

www.vulcanhart.com

MODELS

MLS

CMJ24

ML-135124

CMJ34

ML-135123

CMJ36

ML-135126

CMJ48

ML-135127

CMJ60

ML-135128

CMJ72

ML-135129

www.wolfrange.com

ITW Food Equipment Group, LLC

An Illinois Tool Works Company

701 South Ridge Avenue, Troy, OH 45374

FORM F-36954 (06-06)

IMPORTANT FOR YOUR SAFETY

THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO

INSTALL GAS EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD

START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS

MANUAL.

POST IN A PROMINENT LOCATION THE INSTRUCTIONS TO BE FOLLOWED IN

THE EVENT THE SMELL OF GAS IS DETECTED. THIS INFORMATION CAN BE

OBTAINED FROM THE LOCAL GAS SUPPLIER.

IMPORTANT

IN THE EVENT A GAS ODOR IS DETECTED, SHUT

DOWN UNITS AT MAIN SHUTOFF VALVE AND

CONTACT THE LOCAL GAS COMPANY OR GAS

SUPPLIER FOR SERVICE.

FOR YOUR SAFETY

DO NOT STORE OR USE GASOLINE OR OTHER

FLAMMABLE VAPORS OR LIQUIDS IN THE VICINITY OF

THIS OR ANY OTHER APPLIANCE.

WARNING: IMPROPER INSTALLATION, ADJUSTMENT,

ALTERATION, SERVICE OR MAINTENANCE CAN

CAUSE PROPERTY DAMAGE, INJURY OR DEATH.

READ THE INSTALLATION, OPERATING AND

MAINTENANCE INSTRUCTIONS THOROUGHLY BEFORE

INSTALLING OR SERVICING THIS EQUIPMENT.

IN THE EVENT OF A POWER FAILURE, DO NOT

ATTEMPT TO OPERATE THIS DEVICE.

- 2 -

- 3 -

INSTALLATION, OPERATION AND CARE OF

CHEESEMELTERS

GENERAL

Cheesemelters are produced with quality workmanship and material. Proper installation,

usage and maintenance of your Cheesemelter will result in many years of satisfactory

performance.

Model Number of Burners BTU/hr Input Rating

VCM24, CMJ24 1 18,000

VCM34, CMJ34 1 24,000

VCM36, CMJ36 1 24,000

VCM48, CMJ48 2 18,000

VCM60, CMJ60 2 18,000 & 24,000

VCM72, CMJ72 2 24,000

INSTALLATION

Before installing, verify that the type of gas supply (natural or propane) agrees with the

specifications on the rating plate located underneath the grease drip pan. If the supply

and equipment requirements do not agree, do not proceed with the installation. Contact

your dealer immediately.

UNPACKING

Immediately after unpacking, check for possible shipping damage. If the cheesemelter is

found to be damaged, save the packaging material and contact the carrier within 15 days

of delivery.

Before installing, verify that the type of gas (natural or propane) and the clearance

dimensions (see page 4) agree with the specifications on the rating plate which is located

under the crumb tray on the right side.

LOCATION

The equipment area must be kept free and clear of combustible substances .

Minimum Clearances

Combustible Construction Non-Combustible Construction

Back 2" 0"

Sides 20" 0

Bottom 10" 4"