This appliance has a polarized plug. (One blade is wider than the
other.) To reduce the risk of electrical shock, this plug is intended to fit
in a polarized outlet only one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
WARNING – To reduce the risk of fire or electrical shock, do not use
this product with any solid state speed control device. To reduce
the risk of fire or electric shock and injury to persons, do not use in a
window.
This product employs overload protection (fuse). A blown fuse indicates an overload or short-circuit situation. If the fuse blows, unplug
the product from the outlet. Replace the fuse as per the user servicing
instructions (follow product marking for proper fuse rating) and check
the product. If the replacement fuse blows, a short-circuit may be
present and the product should be discarded or returned to an authorized service facility for examination and/or repair.
Do unplug your circulator before cleaning.
Do clean your Vornado Air Circulator regularly. Refer to the CLEAN-
ING instructions provided. Never clean the air circulator in any manner other than as instructed in this manual.
Do Not use gasoline, thinners, solvents, ammonias or other chemi-
cals for cleaning.
Do Not immerse this product in water or allow water to drip into
the motor housing.
Do Not use near furnaces, fireplaces, stoves or other high-temper-
ature heat sources.
Do Not position this product too close to draperies because they
may be drawn into the rear grill, cutting off airflow.
Do Not use this product outdoors.
Do Not use this product on wet surfaces.
Do Not use this product in a bathtub or shower.
Do Not operate any fan with a damaged cord or plug. Discard fan
or return to an authorized service facility for examination and/or
repair.
Do Not carry this product by the cord, or use the cord as a handle.
Do Not attempt to repair or replace parts.
Do Not run cord under carpeting. Do not cover cord with throw
rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where
it will not be tripped over.
Do use common sense when using this product and/or any electri-
cal appliance.
User Servicing Instructions
Grasp plug and remove from the receptacle or other outlet device.
Do not unplug by pulling on cord. Open fuse cover (A.) by sliding
access cover on top of attachment plug towards blades. Remove fuse
carefully (B.) by gently prying out the ends of the fuse from the receptacle.
Risk of fire. Replace fuse only with 2.5 Amp, 125 Volt fuse.
4 English
IMPORTANT INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING.
Contact Vornado customer service for replacement fuse.
Phone: 1-800-234-0604, email: consumerservice@vornado.com
Install replacement fuse (C.) by first placing the end of the fuse into
the fuse receptacle which is opposite of the blades of the plug, then
carefully push in the other end. Only push against the metal end of
the fuse, not the glass center portion. Close the fuse access cover (D.)
by sliding the cover back into the plug until it is completely closed,
latches and is flush with the face of the plug. Risk of fire. Do not replace attachment plug. Contains a safety device (fuse, AFCI, LCDI)
that should not be removed. Discard product if the attachment plug is
damaged.
A.B.C.D.
Models 660 & 270 only
Note: This equipment has been tested and found to comply with the
limits for Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) his device must accept any interference
received, including interference that may cause undesired operation.
This Class B digital apparatus complies with Canadian ICES-003. Cet
appareil numérique de la classe B est conforme à la norme NMB-003
du Canada.
SAVE THESE INSTRUCTIONS
English
5
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.