Venturer PLV76156 User Manual

0 (0)

PLV76156

15” LCD TV

INSTRUCTION MANUAL

Need More Help?

DO NOT RETURN THIS PRODUCT TO THE STORE Please visit online help at http://www.venturer.com

E - 16

PLV76156S7_IB_UL_090727.indd 16

7/28/2009 09:44:22

SAFETY PRECAUTIONS

CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USERSERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s

enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the

literature accompanying the appliance.

The symbol for Class II

(Double Insulation)

CAUTION :

DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE.

TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT OF WALL

OUTLET, THEN FULLY INSERT.

USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

WARNING :

To reduce the risk of fire or shock hazard, do not expose this unit to rain or moisture.

Mainplugisusedasdisconnectdeviceanditshould remain readily operable during intended use.

The unit shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on unit.

In order to disconnected the unit from the mains completely, the AC power cord should be disconnected from the mains socket outlet completely.

Battery shall not be exposed to excessive heat such as sunshine, fire or the like.

WARNING:

Changes or modifications to this unit not expressly approved by party responsible for compliance could void the user authority to operate unit.

PLACEMENT INFORMATION

Do not use this unit in places which are extremely hot, cold, dusty or humid.

Do not restrict the air flow of this unit by placing it somewhere with poor air flow, by covering it with a cloth, by placing it on bedding or carpeting.

SAFETY INFORMATION

When connecting or disconnecting theAC power cord, grip the plug and not the cord itself. Pulling the cord may damage it and create a hazard.

When you are not going to use the unit for a long period of time, disconnect the AC power cord.

CONDENSATION INFORMATION

When left in a heated room where it is warm and damp, water droplets or condensation may form inside the equipment. When there is condensation inside the unit, the unit may not function normally. Let the unit stand for 1-2 hours before turning the power on or gradually heat the room and let the unit dry before use.

RATING PLATE LOCATION

The rating plate is located on the rear of unit.

FCC STATEMENTS

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This unit has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This unit generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is not guarantee that interference will not occur in a particular installation. If this unit does cause harmful interference to radio or television reception, which can be determined by turning the unit off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the unit and receiver.

-Connect the unit into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

-Shielded cables must be used with this unit to ensure compliance with the Class B FCC limit.

-This television receiver provides display of television closed captioning in accordance with Section 15.119 of the FCC rules.

E - 1

PLV76156S7_IB_UL_090727.indd 1

7/28/2009 09:41:02

IMPORTANT SAFETY INSTRUCTIONS

1)Read these instructions.

2)Keep these instructions.

3)Heed all warnings.

4)Follow all instructions.

5)Do not use this apparatus near water.

6)Clean only with dry cloth.

7)Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8)Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (Including amplifiers) that produce heat.

9)Do not defect the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10)Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

11)Only use detachments / accessories specified by the manufacturer.

12)Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart / apparatus combination to avoid injury form tip-over.

13)Unplug this apparatus during lightning storms or when unused for long periods of time.

14)Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damages, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

E - 2

PLV76156S7_IB_UL_090727.indd 2

7/28/2009 09:41:02

Venturer PLV76156 User Manual

QUICK INSTALLATION

Before turning on your television set for the first time, be sure to place it on a solid stable surface. To avoid danger, do not expose the TV to water, or a heat source (e.g. lamp, candle, radiator). Do not obstruct the ventilation grid at the rear and be sure to leave sufficient gaps around the unit as shown.

 

2

3/8"

 

2

3/8"

7

7/8"

1.Connect the TV antenna.

2.Connect the power cord.

3.Press the / ON button to turn on the unit.

4.Press the / button to highlight Antenna,

then use the ENTER or button to select “Air”, “Cable STD”, “Cable HRC”, “Cable IRC” or “Cable Auto“.

5.Use the / button to highlight Auto

Scan, then press the ENTER or button to confirm.

6.The unit will immediately search all channels for those with adequate signal strength and store those channels with signals in memory. The unit will take a few minutes to finish auto scan and after this is completed, the unit will switch to the first channel found.

Initial Setup Menu

 

OSD Language

 

English

 

Antenna

 

Air

 

Auto Scan

 

 

 

 

To Move Enter

To Select

Menu To Exit

 

 

 

 

 

 

 

 

 

 

 

Autoprogram Menu

 

 

 

 

Analog Air Channel 10

Not Found

 

 

Analog Channels Found

0

 

 

Digital Channels Found

0

 

 

Progress(%)

5

 

 

 

 

 

 

 

Menu To Stop

Turning On the Unit for the first time

The first time you turn on the unit, the unit will enter the setup mode. You can easily follow the prompt message on the screen to complete basic TV settings.

Make sure the TV antenna or CATV cable has been connected properly to the TV antenna input jack on the rear of the system.

E - 3

PLV76156S7_IB_UL_090727.indd 3

7/28/2009 09:41:04

CONTENTS

SAFETY PRECAUTIONS .............................

1

IMPORTANT SAFETY INSTRUCTIONS ...........

2

QUICK INSTALLATION ...............................

3

CONTENTS .................................................

4

ACCESSORIES ..........................................

4

GETTING STARTED .....................................

4

CONTROL REFERENCE GUIDE ..............

5 - 6

CONNECTIONS ..........................................

7 - 8

Connecting aTVAntenna ..........................

7

Connecting To A Vcr / Camcorder / Video

Game System / Cable / Satellite System ....7

Connecting the power cord ........................

8

USINGHEADPHONES/EARPHONES

...............8

INSTALLATION ............................................

9

TV SETUP .............................................

10 - 12

Picture Menu .......................................

10

Audio Menu .......................................

10

TV Menu ..............................................

11

Setup Menu .......................................

12

TROUBLESHOOTING GUIDE ...............

13

ACCESSORIES

Please check and identify the supplied accessories.

 

Remote Control (with batteries) ............................................................................................

x 1

GETTING STARTED

USING THE REMOTE CONTROL

Point the remote control at the remote sensor located on the unit.

When there is a strong ambient light source, the performance of the infrared remote sensor may be degraded, causing unreliable operation.

The recommended effective distance for remote operation is about 16 feet (5 meters).

TO INSTALL BATTERIES

1.Open the battery door.

2.Insert 2 “AAA” batteries.

BATTERY REPLACEMENT

When the batteries become weak, the operating distance of the remote control is greatly reduced and you will need to replace the batteries.

CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

NOTES

If the remote control is not going to be used for a long time, remove the batteries to avoid damage caused by battery leakage corrosion.

Do not mix old and new batteries. Do not mix ALKALINE, standard (CARBON-ZINC) or rechargeable (NICKEL-CADMIUM) batteries.

Always remove batteries as soon as they become weak.

Weak batteries can leak and severely damage the remote control.

WARNING : Do not dispose of batteries in a fire. Batteries may explode or leak.

E - 4

PLV76156S7_IB_UL_090727.indd 4

7/28/2009 09:41:05

Loading...
+ 11 hidden pages