Model:CD7106Vi
CDMicroSystem orfPodi
INSTRUCTION MANUAL
SAFETY PRECAUTIONS
FCC Information
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to operate the equipment.
|
|
|
|
|
|
|
|
|
|
|
CH |
THE LE |
|
|
|
|
|
|
|
|
|||
|
|
|
|
|
|
|
OTTOU |
|
|
|
|
|
|
|
|
||||||||
|
|
|
|
|
N |
|
|
|
|
|
|
|
N |
|
|
|
|
|
|
|
|||
|
|
|
O |
|
|
|
|
|
|
|
|
|
|
S |
|
|
|
|
|
|
|||
|
|
D |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
ND |
INTERL |
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
|
|
O |
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
A |
|
|
|
CK |
|
|
|
|
|
|
|
|
|
|||
|
|
|
|
|
|
N |
|
|
|
|
|
|
S |
D |
|
|
|
|
|
|
|||
|
|
|
|
E |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||||
|
|
|
P |
|
|
|
|
OSURE |
|
|
|
|
E |
|
|
|
|
|
|||||
|
|
O |
|
|
|
|
|
|
T |
|
|
|
|
F |
|
|
|
|
|||||
N |
|
|
|
|
|
|
XP |
|
|
|
|
|
|
|
E |
|
|
|
|||||
|
|
|
|
|
E |
|
|
|
O |
B |
|
|
|
|
|
A |
|
|
|||||
E |
|
|
|
ID |
|
|
|
|
|
E |
|
|
|
|
T |
|
|||||||
H |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||||||||
|
|
O |
|
|
|
|
|
|
|
|
|
A |
M |
|
|
|
E |
. |
|||||
W |
A |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|||||
|
|
V |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
D |
This product contains a low power laser device.
WARNINGS:
•TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE UNIT TO RAIN OR MOISTURE.
•TO AVOID ELECTRICAL SHOCK, DO NOT OPEN THE CABINET. REFER SERVICING TO QUALIFIED PERSONNEL ONLY.
•THE APPARATUS SHALL NOT BE EXPOSEDTO DRIPPING OR SPLASHING AND THAT NO OBJECTS FILLED WITH LIQUID, SUCH AS VASES, SHALL BE PLACED ON THE APPARATUS.
For the Customers in Canada
This apparatus complies with the Class B limits for radio noise emission set out in radio interference regulations.
This Class B digital apparatus complies with Canadian ICES-003.
Warnings:
•The AC adaptor is used as disconnect device and it should remain readily operable during intended used. In order to disconnect the apparatus from the mains completely, the AC adaptor should be disconnected from the mains socket outlet completely.
•Minimum 10 cm (4 inches) distances around the apparatus for sufficient ventilations.
•The ventilation should not be impeded by covering the ventilation openings with items such as newspaper, table-cloths, curtains, etc.
•No naked flame sources such as lighted candles should be placed on the apparatus.
- 1 -
SAFETY PRECAUTIONS
On Safety
As the laser beam used in this compact disc player could be harmful to the eyes, do not attempt to disassemble the casing. Refer servicing to qualified personnel only.
•Do not put any foreign objects in the disc compartment. If you do so, the laser beam interlock may be defeated allowing the laser to remain on when the lid is opened.
•Do not put any foreign objects in the DC IN jack. Should any objects or liquids fall into the unit, disconnect the power supply and have the unit checked by qualified personnel before any further operation.
On Operation
Since the CD system offers a wide dynamic range, the peaks of the high level inputs are recorded with high fidelity, and the noise level is very low. Do not turn up the volume while listening to a part of the disc with no audio signals or very low level inputs. If you do so, the speakers may be damaged when the peak level of the sound is played. The lens of the laser should be kept clean. Do not touch the lens. If you do so, the lens may be damaged and the unit will not operate correctly.
On Use
Never use the unit where it would be subject to:
-Heat sources such as radiators or air ducts.
-Direct sunlight.
-Excessive dust.
-Moisture or rain.
-Mechanical vibration or shock.
-Uneven surface.
•Do not place any heavy objects on top of the unit.
•When the unit is used with an AC power adapter, do not wrap the unit in a cloth, blanket, etc. If you do so, the temperature inside and outside the unit may rise considerably, resulting in malfunctioning of the unit.
•If the unit is brought directly from a cold to a warm location, or is placed in a very damp room, the moisture may condense on the lens inside the unit. Should this occur, the unit will not operate. In this case, remove the disc and leave the unit in a warm place for several hours until the moisture evaporates.
•For the unit to operate at its best, it should not be subject to temperatures below 41°F (5°C) or above
95°F (35°C).
- 2 -
SYSTEM CONNECTIONS
Speaker Connections
Connect the right speaker to the R terminal and the left speaker to the L terminal.
NOTE: Connecting speakers other than the speakers supplied with the unit may damage the unit.
RIGHT |
LEFT |
SPEAKER |
SPEAKER |
BOX |
BOX |
To AC outlet
To “DC IN 13.5V” jack
AC adapter
Using the AC Adapter
Using an AC adapter other than the one supplied with the unit may damage the unit. This AC adapter operates on AC 100-120V~50/60Hz.
CAUTIONS:
•Before use, ensure the rated voltage of the adapter matches your local voltage.
•The included AC adapter is for use with this unit only. Do not use it with other equipment.
•If you are not going to use the unit for a long time, disconnect the AC adapter from the wall outlet.
•Whenever the AC adapter is plugged in to a wall outlet, electricity is running through the unit, even when the power switch is turned off.
FM ANTENNA
•Do not connect the FM antenna to an outside antenna.
- 3 -
REMOTE CONTROL
1 |
|
1. |
PRESET EQ Button |
|
|
|
2. |
ON/STANDBY Button |
|
2 |
8 |
3. |
SLEEP Button |
|
|
9 |
|||
|
4. |
/PROG/MEM Button |
||
3 |
10 |
|||
4 |
11 |
5. |
RANDOM Button |
|
6. |
/MEM.UP Button |
|||
|
|
|||
5 |
|
7. |
STOP/BAND Button |
|
|
12 |
|||
|
8. |
FUNCTION Button |
||
6 |
|
|||
7 |
13 |
9. |
TIMER Button |
|
|
|
10. |
DISPLAY Button |
|
|
|
11. |
/ Button |
|
|
|
12. |
VOLUME +/- Buttons |
|
|
|
13. |
PLAY/PAUSE Button |
Using the Remote Control Correctly
•Point the remote control at the REMOTE SENSOR located on the unit.
•When there is a strong ambient light source, the performance of the infrared REMOTE SENSOR may be degraded, causing unreliable operation.
•The recommended effective distance for remote operation is about 19 feet (6 meters).
To Change Battery
ATTENTION
Remove the plastic sheet before operating the remote control.
1. Open the battery door.
2. Insert one CR2025 (3V) size battery.
Battery Replacement
When the battery becomes weak, the operating distance of the remote control is greatly reduced and you will need to replace it.
Note: If the remote control is not going to be used for a long time, remove the battery to avoid damage caused by battery leakage corrosion.
WARNINGS:
•Do not dispose of battery in fire; battery may explode or leak.
•Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
•Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
CAUTION: When discarding batteries, environmental problems must be considered and local rules or laws governing the disposal of these batteries must be strictly followed.
- 4 -