Vdo dayton CR 213, CD 423, CD 413, CR 223 User Manual

BEFORE YOU START ....

Thank you for purchasing this VDO product which
has been designed and manufactured to the
highest standards and subjected to rigorous
testing.
Kindly familiarise yourself with the product by
reading this user manual. Keep this manual handy
in your car for future reference.

This manual covers the following models:

Illum Supply Fuse

CR 213 Orange 12V 5A
CR 223 Green 12V 5A
CD 413 Orange 12V 10A
CD 423 Green 12V 10A
CR 213-24V Orange 24V 5A
CR 223-24V Green 24V 5A
CD 413-24V Orange 24V 5A
CD 423-24V Green 24V 5A

ENVIRONMENT

This booklet is printed on low-chlorine recyclable
paper.

IMPORTANT

This device has been designed and produced
according to applicable Safety Regulations.
Please read carefully the instruction manual and
use the device as intended.

CONTENTS PAGE

INSTALLATION ................................................ 4

PREPARATION ................................................ 4

MOUNTING ..................................................... 5

FRONT PANEL PRESENTATION................... 6

SECURITY ....................................................... 6

AUDIO .............................................................. 7

RADIO .............................................................. 8

RADIO DATA SYSTEM (RDS) ON FM ........... 8

CASSETTE PLAYER........................................ 9

CD PLAYER...................................................... 9

TROUBLE SHOOTING................................. 10

INSTALLATION

If your car is equipped with ISO connectors, simply
insert them in the connectors of the car radio. If
not, you can use an adaptor cable. Ensure all cables
are installed so that they cannot be damaged by
sharp edges or moving parts.

PREPARATION

Volta ge and polarity: The set must be connected

to a 12V/24V car battery with negative terminal to
earth (car chassis). Installation in vehicles not
fulfilling these requirements could result in
malfunction, damage or fire.

Warning: To prevent short-circuiting,
disconnect the negative car battery terminal
until the set has been mounted and
connected (fig.1 See separate installation
card).

CONNECTOR A (fig.2)
Power supply connections

• Red wire A7 : Connect to a permanent 12V/
24V supply. This is the main power supply.
Ensure this connection can handle a current of
10A/5A.

• Yellow/red wire A4 : Connect to a switched
12V/24V supply (switched on/off by car ignition).

• Brown wire A8: Connect to earth (car
chassis).

This connection set up will enable you to make
full use of the ON/OFF LOGIC function of this set
limiting the use of the set to 1 hour after removal
of the ignition key. If this feature does not appear
to be functioning as expected you may require
an adaptor cable.

• Electronic antenna/Motorised antenna
Connect pin A5 to the power supply for an

electronic antenna or the control wire for the
relay of an automatic motorised antenna.

Do not use this connection for the supply
lead of the aerial motor!

• Pilot light
When the car headlights are switched on, the
backlight to the power key remains illuminated
(even when the radio is switched off).
Connect pin A6 to the dashboard illumination
wiring of the car.
Note : In certain car (e.g. VW Passat) the
dashboard illumination is dimmed by a digitally
modulated signal (PWM - Pulse Width
Modulation). This PWM signal can disturb the
illumination display of the car radio. In this case,
connect pin A6 to the switch signal of the low
beam headlight. Please consult your car dealers
for more information.

:

:

* Depending on version

4

ｄｃｒｅｎｇｌｉｓｈ．ｐ６５ 2004-4-30, 14:384