V3SOUND Yammex PSR S670-675, Yammex TYROS 2, Yammex TYROS 4, Yammex TYROS 3, Yammex TYROS 5 User Manual
...
SOUNDEXPANDER
Yammex
GENOS
TYROS 2-3-4-5
PSR S970-975
PSR S770-775
PSR S670-675
and kompatible
manual - midi implementation - sound list
V3SOUND.COM
1
The recordings used in this device are protected by copyright. V3SOUND alone has been given the
right by all musicians involved to use this material. Any duplication, editing or any other copy by or
given to a third party in any form (audio sampling CD, data storage device, download of any file, etc.)
is strictly forbidden.
Copyright © 2018 by V3SOUND GmbH www.v3sound.com
HPF High Pass Filter: Use the cutoff parameter to set the low frequency limit. When you do this,
the sound will naturally be brighter and thinner. A cutof f value over 64 usually needs to be
selected just so you notice the change.
Notch Filter - take some frequencies out
SL 116 Velocity zone 116 - 127 Slide up sound variation
SP 116 Velocity zone 116 - 127 Split variation
velo. Velocity split
AV Auto variation with grace notes
+ Small variation in sounds
56/57 Controller 56 main tone - controller 57 over tone - specially created for MIDI files
MEGA Voice special for Styles
The sound board will just give sound, when you call up a sound with a bank and program number
from this sound list. Sending a bank message with another value - NO SOUND!
PROGRAM LIST SOLO SOUNDSPROGRAM LIST SOLO SOUNDSPROGRAM LIST SOLO SOUNDS
PROGRAM LIST SOLO
SOUNDS
PROGRAM LIST SOLO SOUNDS
BANK CONCEPTSAFETY PRECAUTIONS COPYRIGHT
SPECIFICATIONS
LEGENDE
PROGRAM LIST SOLO SOUNDSCOPYRIGHT
SAFETY INSTRUCTIONS
• Read the user manual before using the device
• Do not allow any liquid to come in contact
with the device
• Do not place anything on top of the device
• Do not handle the power supply with wet hands
• Turn off all connected devices before you
connect any new devices
Do not use or store the device where it is
exposed to:
• dampness or wetness
• extreme temperature changes
(i.e. do not store in a vehicle in winter)
• strong vibrations or jolts
HANDLING
• Use only the original cables and power supply
• Remove the cable only by pulling on the plug,
not on the cable
• Do not expose the power adapter to any
mechanical stress
CUSTOMER SERVICE
Do not carry out any repairs at home, as this may result
in permanent damage to the electronics. Any guarantee
claims are no longer valid in this case.
ACCESSORIES
Manual and power
POWER REQUIREMENT
9VDC / 1.0A
HUMIDITY
max. 80%, non-condensing
OPERATING TEMPERATURE
10 to 40 degrees Celsius
!
All the audio recordings V3SOUND uses on
the sound boards are protected by copyright.
V3SOUND alone has been given the right by all
musicians involved to use this material. Any duplication, editing or any other copy of individual sounds
by or given to a third party in any form (audio sampling CD, data storage device with individual sounds,
download of any file, etc.) is strictly forbidden.
Copyright © 2017 V3SOUND - Austria
• Master Volume
• Master Reverb
• 4GB flash memory
• 16 MIDI channels
• 4 audio out (2 stereo)
• Polyphony 256 voice
• Ports available for 1 sustain foot pedal
• Dimensions: 12cm (L) x 12cm (W) x 6cm (H)
• Weight: 0,2kg
• USB Host
The CE certification is available at
http://www.v3sound.com/support/
V3SOUND GMBH
Kirchplatz 7 - 6114 Kolsass - Austria - Europe
This prod uct confo rms to the
FCC 47 CFR PART 15
SUBPART B
2
The V3 unit can be connected to any USB Audio
Class 1 compatible keyboard. The V3 unit can
supply your USB keyboard with a maximum of
500mA. If your keyboard requires more than
500mA, you will need an external power supply.
The polarity of the sustain foot pedal is set up automatically when you turn on the V3. The pedal
only works on MIDI channel 1.
MIDI-THRU
MIDI-IN
POWER ON/OFF
USB-HOST
PEDAL
MAIN REVERB
LED - POWER ON
LED - MIDI
MAIN VOLUME
PROGRAM LIST SOLO SOUNDSUSER INTERFACE PORTS
CONNECT - USB FOOT PEDAL
!
To avoid possible damage to the loud speakers or
other connected electronic devices, always connect all cables before turning on the units.
Plug the power adapter that came with the
YAMMEX into the DC port on the back of the unit.
Plug the other end of the power adapter into a
power outlet.
Connect the MIDI-cable
MIDI-OUT Keyboard (MIDI OUT A)
MIDI-IN YAMMEX
You can also use a USB cable in place of the
MIDI cable.
Connect the audio outputs
OUT L & R YAMMEX
AUX-IN Keyboard
You can also connect the YAMMEX AUDIO-OUT
to a mixer and adjust the volume there.
Move up the V3 YEMMEX
MAIN VOLUME potentiometer to
maximum.
Turn on YAMMEX first,
then power on the keyboard.
NO SOUND - No MIDI-LED
The YAMMEX MIDI LED only lights up when you
have correctly selected a sound. To do this, you
must send the following messages over MIDI:
MSB Bank 63
LSB Bank 80 (80 is just an example)
Prg. change 1
This will only be done automatically if you have
correctly installed the voices using the YAMAHA
YEM Editor. If this does not happen, check the
bank setting as described on page 3.
MIDI-INMIDI-OUT A - KEYBOARD
AUX-IN KEYBOARD
OR MIXER
POWER ON/OFF
USB-HOST
PROGRAM LIST SOLO SOUNDSCONNECT AND POWER UP
3
To select Yammex Sounds from your keyboard, you must first upload the data to your keyboard. The
data files are located here:
www.v3sound.com/en/e-support-yammex.html
How to install voices with the YEM Editor Version 1.51:
1. Click on „My Packs“
2. Then click on the “+” symbol
3. Select IMPORT PACK
4. Select the pack with the lowest
number (Bank 80).
5. Install the LSB bank for this pack.
Click the symbol „>“ under My Pac k
and select Change Bank Select LSB
(the name of the pack is the LSB number).
NOTE: You must manually set the LSB bank number for each sound bank.
After you have loaded all the banks,
set the correct call-up for the VOICES
on the keyboard from the LSB BANK
as shown here.
Now you can end your installation
as instructed in the YEM Editor manual.
Press Install Target ...
PROGRAM LIST SOLO SOUNDS INSTALL VOICES GENOS / T5 / PSR-S975-970-775-770
V3SOUND
An installation with the EXPANSION Manager is NOT absolutely necessary - see left side.
So that you can select the Yammex sounds on the display of your keyboard, simply copy the USER
VOICE data that we provide on our homepage for free to your keyboard.
www.v3sound.com/de/d-support-yammex.html
The USER VOICE data has b een tested on the following models:
GENOS
TYROS 2 - 3 - 4 - 5
PSR S975-970-7 75-770- 670- 675
An additional installation with EXPANSION MANAGER is NOT absolutely necessar y.
You just have to make sure that you do not assign the LSB banks 80-96 to other PACKS.
However, an additional installation of the VOICES with the EXPANSION MANAGER is possible.
In addition, you can still select the YAMMEX Voices as PRESETS in the EXPANSION Packs.
PROGRAM LIST SOLO SOUNDS
PROGRAM LIST SOLO SOUNDS
INSTALL VOICES GENOS / T2-3-4-5 /PSR-S975-970-775-770
INFORMATION FOR EXPANSION MANAGER
PIANO BANK MSB 80 TUNED MSB 63 LSB 82 E-PIANO MSB 63 LSB 81
4
V3SOUND
01 Glockenspiel
02 Musicbox
03 Musicbox & Oct.
04 Musicbox soft
05 Vibraphon Vib.
06 Vibraphon Vib. short
07
Vibraphone
08 Vibraphone short
09 Vibraphon fast Tremolo
10 Celeste
11 Tinkle
12 Tinkle HPF
13 Tinkle Atk.
14 Tinkle & Pad
15 Tinkle & Octave
16
Marimba
17 Marimba & Octave
18 Marimba & Xylophon
19 Marimba & Xylophon+
20 Xylophon
21 Xylophon & Octave
22 Tub Bell
23 Tubula detuned
24 Timpani
25 Kalimba
26 Cortales
27 Agogo
28 Steel Drums
29 Woodblock
30 Taika
31 Melo Tom
32 Synth Tom
41 E. Grand Tremolo A
42 E. Grand Tremolo B
43 E. Grand Tremolo C
44 E. Grand Tremolo D
45 E. Grand Tremolo E
46 E. Grand Tremolo Chorus
E-PIANO MSB 63 LSB 81
01 Grand Piano
02 Bright Piano
03 Honky Tonk
04 Classic Grand
05 Latin Grand
06 Rock Grand
07
Rock Bright
08 Grand & FM
09 Grand & E-Piano
10 Grand Piano Stack
11 Grand fade
12 Grand Piano & Pad 1
13 Grand Piano & Pad 2
14 Harpsichord
15 Harpsichord & Oct. A
16
Harpsichord & Oct. B
17 Harpsichord & Oct. C
01 Electric Grand
02 E. Grand Layer
03 E. Grand Tremolo
04 E. Grand & E-Piano
05 E. Grand fast
06 E. Grand Rock
07
E-Piano Wurly
08 E-Piano Wurly slow
09 E-Piano Wurly & Tine
10 E-Piano Wurly fast
11 E-Piano Wurly Tremolo
12 E-Piano Dyno
13 E-Piano & Tines
14 E-Piano & Tremolo
15 E-Piano & Bells
16
E-Piano fast
17 E-Piano slow
18 DX E-Piano A
19 DX E-Piano B
20 DX E-Piano C
21 DX E-Piano D
22 DX E-Piano & Pad
23 DX E-Piano Tremolo
24 Clavinet
25 Clavinet
26 EP Dyno clean
27 EP Dyno Tremolo A
28 EP Dyno Tremolo B
29 EP Dyno Tremolo C
30 EP Dyno Tremolo D
31 EP Dyno Tremolo E
32 EP Dyno Chorus
33 Wurly clean
34 Wurly Tremolo A
35 Wurly Tremolo B
36 Wurly Tremolo C
37 Wurly Tremolo D
38 Wurly Tremolo E
39 Wurly Tremolo Chorus
40 E. Grand clean
PIANO MSB 63 LSB 80
Loading...