SL CCR-CHGR Charger Kit for Closed Caption Receivers CCR-100, CCR-200, and CCH-100
Installation
1.Remove the existing batteries from the caption receiver
2.Install the supplied NiMH batteries. (Figure A.)
3.Use one of the supplied screws to lock the battery door. Receivers use one of two screw types. Each screw type is supplied in this kit. (Figure B.)
A.
B.
Operation
1.Turn the caption receiver off.
2.Plug the supplied USB cable (Figure C) into the caption receiver and the supplied USB power supply (Figure D).
D.
3.Plug the USB power supply in to a wall outlet. (Figure D.)
4.The charge LED on the caption receiver will light during charging and go out when charging is complete.
5.Receivers should be recharged when the battery voltage (as read on the display on power up) drops to 2.0V.
6.Receivers may be left on chargers when not in use to ensure they are always ready.
CCR-CHGR User Instructions v130506
www.uslinc.com
Loading...