ULTRAMAX UME REMOTE LAMP
AIR DISINFECTION SYSTEMS w/ ODOR REDUCING TECHNOLOGY (PCO)
OWNERS GUIDE
Models: UME-1200T/ UME-1900T / UME-1202T/ UME-1902T – 120VAC Power Input with Remote Mount Lamps
Table of Contents:
Page 2 – Shipping and Packing List, Safety Precautions
Page 3-4 – General Application Guidelines and Recommended Installation
Page 5 – Installation Steps for External Remote Lamp Mounting, Remote Lamp Replacement, and External Mounting of Power Supply
Page 5 – Installation Steps for Internal Remote Lamp Mounting
Page 6 - Installation Steps for Re-Fresh PCO Module, Remote Lamp Replacement
Page 7 - Maintenance and Troubleshooting, Lamp Replacement, Power Consumption, Replacement Parts Page 8 - Warranty
LEAVE FOR HOMEOWNER
DC-IH-0217
Shipping and Packaging List:
•UME Electrical Housing
•Ultra-Ion Re-fresh PCO module w/ gasket and mounting Hardware
•6- ¾ inch 5/16 self tapping sheet metal screws
•Warning Label
•Residential Warranty Card
UME1200T, 1202T, 1900T, 1902T
•**1200T and 1900T SeriesOne 12” or 17” T3 Lamp
•**1202T and 1902T SeriesTwo 12” or 17” T3 Lamp
•*1 or 2 T3 Lamp mounting plate w/ mounting Hardware
*Number depends on 1 or 2 T3 Lamps
**T3 Lamp gasket included
Safety Precautions:
It is recommended that this unit be installed and maintained by a trained technician:
WARNING: UV Hazard. Always protect eyes from ultraviolet light. NEVER look at UV lamps in operation. Unplug or disconnect power before relamping or servicing.
WARNING: Severe eye damage or temporary blinding may occur.
WARNING: DO NOT operate outside of Air Handler. Mount lamp base to duct first.
WARNING: No openings in duct are allowed which would give direct line-of-sight to the UV light.
In the event of accidental breakage or replacement of the ultraviolet lamp, please ensure that the lamp is disposed of in accordance with local and state environmental laws regarding fluorescent lamps containing mercury.
Notice:
All wiring inside of the duct or air handling system in direct line of site of the UV lamp must be shielded with aluminum foil tape or equivalent non-combustible material. When installing this unit, select a mounting location that prevents ultraviolet light exposure to plastic flexible duct liner or other plastic components with unknown resistance to ultraviolet light. Ultraviolet light may cause color shift or structural degradation of plastic HVAC components
2 |
www.ultravation.com |
General application guidelines for Ultramax Economy Ultraviolet air purification systems
Ultravation manufactures several configurations of Ultraviolet disinfection products to meet any installation criteria. Ultravation two lamp ultraviolet systems are designed to adequately treat up to a 5 ton system or 3,500 sq ft.
Whenever possible use a two lamp configuration with the longest lamp length possible for the installation.
Ultravation suggests mounting on the exit side of the HVAC system before the ductwork branches off. This will ensure that the airborne contaminants reaching the ultraviolet purification system and the Re-Fresh Odor reduction module have been reduced to an acceptable Micron size by the HVAC systems filter.
Ultravation Ultramax products have been designed for peak performance in the cooler temperatures commonly found in the supply plenum of a typical HVAC system.
3 |
www.ultravation.com |
Loading...