Ultravation 90-028, 90-030, 90-029, 90-031, 90-032 Owner's Manual

...
0 (0)
Ultravation 90-028, 90-030, 90-029, 90-031, 90-032 Owner's Manual

Complete Whole House Air Cleaning System

Equipment Support Box Air Cleaner

OWNERS GUIDE

Models: 90-028, 90-029, 90-030, 90-031 (Small)

Models: 90-032, 90-033, 90-034, 90-035 (Large)

Table of Contents:

Page 2- Shipping and Packaging list, Introduction and Application, Installation Requirements, Maintenance, Air Conditioning

Page 3- Photronic Upgrade Options, Filter Specifications, Replacement Filters

Page 4- Warranty

LEAVE FOR HOMEOWNER

DC-IH-0213

Shipping and Packaging List:

Filter Housing including 2 Access Doors

MERV-11 Media Air Filter

Adjustable Tops

8’ x 1/2” Installation foam

2- Phillips head screws

9- ¾ inch 5/16 self tapping sheet metal screws

1- Door Handle with hardware

Introduction and Applications:

This Ultravation Media Air Cleaner is a high efficiency air filtration unit designed to remove dirt, dust, pollen, and other microscopic particles from the air that circulates through it. By adding this device to your HVAC system, you are helping to create a cleaner indoor living environment for your whole household.

The filter works by trapping particles in the pleats of the media filter. With an extra large surface area, the filter allows for maximum dirt holding capacity and a long, useful filter life with minimum air flow restriction.

This media air cleaner is to be installed in a forced air heating, cooling and ventilation system.

It should be installed so that all the system air is circulated through the filter. The air cleaner will only filter the air that is circulated through it. For maximum filtration effect, set your bower to operate continuously.

Installation Requirements:

The desired location for installation of the Ultravation Support System Media Air Cleaner is in the return air under the blower compartment. In this location, the blower motor and internal components will be kept clean.

By installing the air cleaner in this location (upstream from the cooling coils) you also will assure that the cooling coils of the air conditioning system will be kept clean. This increases coil life, improves system efficiency, and reduces maintenance costs.

Once the Ultravation Support System Media Air Cleaner is installed, it is very important to maintain the unit by changing the filter periodically (typically in 6 mo intervals) so as not obstruct airflow, damage components or increase energy costs.

The Ultravation Support System Media Air Cleaner has been designed for use in conjunction with virtually any HVAC system.

The inlet duct opening of this unit is adjustable for either an 8” x 24” duct, or 10” x 24” duct. Just remove the three sheet metal screws on the top, adjust the flange, and reattach.

Do not install this unit in the supply duct.

Be sure to plan adequate space for filter replacement.

Before installation is complete, seal all joints and seams with duct tape or caulking.

Maintenance:

The filter media in your air cleaner must be changed periodically. The frequency of filter replacement is best determined by visual examination. However, an annual replacement of the filter is strongly recommended. Replacement filters can be obtained through your installing contractor or local dealer.

Steps for replacing filter:

1.Open the access door by lifting up on the handle and pulling the bottom of the door toward you. Then slide the top of door down, removing the door completely.

2.Remove spacing block (do not discard) to allow the filter to be removed through door opening. Pull out used filter and discard accordingly.

3.Slide new filter into cabinet with “airflow label pointing in the direction of the airflow. Be sure to replace the filter spacing block.

4.Replace access door.

Air Conditioning:

The air cleaner should be installed upstream of the cooling coil. This will keep the coil clean and reduce air conditioning coil maintenance. Improved cooling efficiency is the result, which directly affects energy costs. A clean coil will reduce utility costs. Failure to replace media can cause damage to the cooling system.

Note: Handle fits either door. A Phillips screw driver will be required to install the handle. Handle holes are behind the label on either door, depending on the orientation of the installation.

Loading...
+ 2 hidden pages