OVERLAY PANEL GUIDE
®
2000 SERIES DRAWER MODELS
The American Built-In Undercounter Leader Since 1962 |
U-LINE.COM |
|
|
Safety Precautions
Safety Alert Definitions
Throughout this guide are safety items labeled with a Danger, Warning or Caution based on the risk type:
! DANGER
Danger means that failure to follow this safety statement will result in severe personal injury or death.
! WARNING
Warning means that failure to follow this safety statement could result in serious personal injury or death.
! CAUTION
Caution means that failure to follow this safety statement may result in minor or moderate personal injury, property or equipment damage.
Models Covered
This guide covers the following list of models.
U-2275DWRCOL-00
U-2275DWRCOL-02
U-C2275DWROL-00
Overlay Drawer Panel
Drawer Panel Preparation
A full overlay drawer panel completely covers the drawer frame and handle to give you a built-in appearance.
NOTICE
•The drawer panel must not weigh more than 10 lbs.
•It is important to ensure that all drilled holes are drilled to the correct depth in order to avoid splits in the wood when hardware is installed.
•Appliance will need up to 34-1/2" to the under side of the counter to leave room for leveling adjustments.
1.Determine cabinet toe kick height, measure the difference between the surface the appliance will sit on and the bottom of the adjacent cabinetry. Adjust lower panel height according to the height of your cabinetry’s Toe Kick.
2.The upper overlay has a fixed width and height, cut the upper overlay to the dimension in the table below.
Upper Overlay
Height Width 14-3/4" 23-3/4"
3.The lower overlay width is fixed at 23-3/4", the height will vary depending on the height of your cabinetry’s Toe Kick. Use the table below to determine the proper height.
Note: Dimensions will vary based on the levelness of the floor. If floor is uneven, cut panel to the next longer dimension and adjust level legs to achieve proper fit.
Lower Overlay |
|
|
|
|
Toe Kick |
Height |
|
Toe Kick |
Height |
|
||||
3-3/4" |
14-3/4" |
|
4-1/4" |
14-3/8" |
3-7/8" |
14-3/4" |
|
4-3/8" |
14-1/4" |
4" |
14-5/8" |
|
4-1/2" |
14-1/4" |
4-1/8" |
14-1/2" |
|
|
|
|
|
|
|
|
1.If user-supplied cabinet handles or knobs will be used, attach this hardware to the overlay panel at this time.
NOTICE
User-supplied cabinet handles MUST be counter-bored to make sure mounting hardware is below surface of overlay panel. Failure to do so can cause damage to overlay panel.
Drawer Panel Installation
Removing Existing Drawer Fronts
1. Open drawer. Pull drawer gasket out of groove (top edge of drawer only). Start in the middle and pull outward, moving toward the edge. This may take some force.
2.Remove the two screws located at the ends of the handle. Remove the handle.
3.Remove existing vinyl panel and cardboard spacer. Discard the spacer.
4.Reinstall handle.
5.Repeat for both drawers.
Preparing the Drawer Frame for Overlay
You have received your drawers with or without holes pre-punched into the galvanized steel. If your door does not have the punched holes please use diagram below for hole location dimensions.
Preparing Steel Insert
1.With the drawer open and braced, drill 6 holes into the steel plate and through the frame using the pre-punched holes as a guide. If your panel is not pre-punched, see diagram below for hole locations. Repeat for both drawers.
u-line.com |
1 |
Loading...