T-35
............ www.truemfg.com ............
TABLE OF CONTENTS
Safety Information
Safety Precautions 1
TSD Do’s and Don’ts 2
Proper Disposal 3
Connecting Electricity 4
Adapter Plugs 4
Installation / Operation Instructions
Ownership 5
Required Tools 5
Uncrating 5
Leveling Cabinet 6
Installation of Castors or Optional Legs 7
Installing Optional Castors on a T-12FG 8
Slide Door Operation Instructions 9
Wire Gauge Chart 10
Sealing Cabinet to Floor & Electrical Inst. 11
Start-up 12
Shelving Install/Operation & Light Switches 13
Grasslin Defrost Timer (Freezer Units Only) 14
Field Troubleshooting (Freezer Units Only) 15-16
Light Cover Install for T-12FG 17
Maintenance, Care & Cleaning
Cleaning Condenser Coil 18-19
Temperature Control Adjustment 20
Stainless Steel Equipment Care & Cleaning 21-22
Light Bulb Replacement 22
Warranty (U.S.A. & CANADA ONLY!) 23
INSTALLATION MANUAL FOR T-SERIES FREEZER /
REFRIGERATOR (SWING AND SLIDE DOOR)
T-SERIES
FREEZER / REFRIGERATOR SWING
& SLIDE DOOR
TRUE FOOD SERVICE EQUIPMENT, INC.
2001 East Terra Lane • O’Fallon, Missouri 63366-4434
(636)-240-2400 • FAX (636)272-2408 • INT’L FAX (636)272-7546 • (800)325-6152
Parts Department (800)424-TRUE • Parts Department FAX# (636)272-9471
CONGRATULATIONS!
You have just purchased the finest commercial
freezer / refrigerator available. You can expect many
years of trouble-free operation.
T-23
TSD-47G
TSD-69
T-35
4/30/10 -500 SB #897001
*Spanish, German, French, Dutch, and Arabic versions included.
............ www.truemfg.com ............
True Food Service Equipment, Inc.
............ www.truemfg.com ............
True Food Service Equipment, Inc.
1
1
............ www.truemfg.com ............
SAFETY INFORMATION
1
1
This refrigerator must be properly installed and
located in accordance with the Installation
Instructions before it is used.
Do not allow children to climb, stand or hang
on the shelves in the refrigerator. They could
damage the refrigerator and seriously injure
themselves.
Do not touch the cold surfaces in the freezer
compartment when hands are damp or wet.
Skin may stick to these extremely cold surfaces.
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
Keep fingers out of the “pinch point” areas;
clearances between the doors and between the
doors and cabinet are necessarily small; be
careful closing doors when children are in the
area.
NOTE: We strongly recommend that any
servicing be performed by a quali ed
individual.
Unplug the refrigerator before cleaning and
making repairs.
Setting temperature controls to the 0 position
does not remove power to the light circuit,
perimeter heaters, or evaporator fans.
WARNING!
Use this appliance for its intended purpose as described
in this Owner Manual.
This cabinet contains fluorinated greenhouse gas covered by the Kyoto Protocol
(please refer to cabinet’s inner label for type and volume,
GWP of 134a= 1,300. R404a= 3,800).
How to Maintain Your Freezer
/ Refrigerator to Receive the Most
Efficient and Successful Operation
You have selected one of the nest commercial refrigeration units made.
It is manufactured under strict quality controls with only the best quality
materials available. Your TRUE cooler when properly maintained will give
you many years of trouble-free service.
SAFETY PRECAUTIONS
When using electrical appliances, basic safety precautions should be followed, including the following:
............ www.truemfg.com ............
True Food Service Equipment, Inc.
2 2
............ www.truemfg.com ............
True Food Service Equipment, Inc.
3
3
SAFETY INFORMATION
PROPER DISPOSAL OF THE FREEZER /
REFRIGERATOR
DANGER!
RISK OF CHILD ENTRAPMENT
USE OF EXTENSION CORDS
NEVER USE AN EXTENSION CORD! TRUE will not warranty any refrigerator that has been
connected to an extension cord.
Child entrapment and suffocation are not problems
of the past. Junked or abandoned refrigerators are
still dangerous… even if they will sit for “just a few
days.” If you are getting rid of your old refrigerator,
please follow the instructions below to help
prevent accidents.
Before You Throw Away Your Old Refrigerator
or Freezer:
Take off the doors.
Leave the shelves in place so that children may
not easily climb inside.
Refrigerant Disposal
Your old refrigerator may have a cooling system
that uses “Ozone Depleting ” chemicals. If you are
throwing away your old refrigerator, make sure the
refrigerant is removed for proper disposal by a
qualified service technician. If you intentionally
release any refrigerants you can be subject to
fines and imprisonment under provisions of the
environmental regulations.
............ www.truemfg.com ............
True Food Service Equipment, Inc.
4 4
WARNING!
SAFETY INFORMATION
The power cord of this appliance is equipped with a
3-prong (grounding) plug which mates with a standard
3-prong (grounding) wall outlet to minimize the possibility
of electric shock hazard from this appliance.
Have the wall outlet and circuit checked by a qualified
electrician to make sure the outlet is properly grounded.
If the outlet is a standard 2-prong outlet, it is your personal
responsibility and obligation to have it replaced with the
properly grounded 3-prong wall outlet.
The refrigerator should always be plugged into it’s own
individual electrical circuit, which has a voltage rating
that matches the rating plate.
This provides the best performance and also prevents
overloading building wiring circuits which could cause
a fire hazard from overheated wires.
Never unplug your refrigerator by pulling on the power
cord. Always grip plug firmly and pull straight out from
the outlet.
Repair or replace immediately all power cords that have
become frayed or otherwise damaged. Do not use a cord
that shows cracks or abrasion damage along its length
or at either end.
When removing the refrigerator away from the wall, be
careful not to roll over or damage the power cord.
WIRING CONVERSION
At Receptacle Box
1. Turn breaker off
2. Disconnect all wires from receptacle
3. Insulate red wire (tape or wire nut)
4. Connect black, white, and green wires
to 3 prong plug NEMA 5-20R per
instructions on receptacle
At Breaker Panel
1. With breaker turned off, remove wires
2. Remove double pole breaker
3. Install single pole breaker
4. Connect black wire to breaker
5. Insulate red wire
6. Turn breaker back on
HOW TO CONNECT ELECTRICITY
Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.
For personal safety, this appliance must be properly grounded.
USE OF ADAPTER PLUGS
NEVER USE AN ADAPTER PLUG! Because of potential safety hazards under certain conditions,
we strongly recommend against the use of an adapter plug.
T-72F WIRING CHANGES (110V Application Only)
Previous design: 4 prong plug NEMA 14-20R - 4 wire circuit (see image 1).
Current design: 3 prong plug NEMA 5-20R - 3 wire circuit (see image 2).
TRUE uses these types of plugs. If you do
not have the right outlet have a certified
electrician install the correct power source.
(North America Use Only!)
NEMA plugs
1 2
NOTE: It is the customer’s responsibility to make sure receptacle
wiring meets all local electrical codes. TRUE recommends hiring
a licensed quali ed electrician to make this change.
............ www.truemfg.com ............
True Food Service Equipment, Inc.
5
5
INSTALLATION / OPERATION INSTRUCTIONS
To insure that your unit works properly from the
first day, it must be installed properly. We highly
recommend a trained refrigeration mechanic and
electrician install your True equipment. The cost
of a professional installation is money well spent.
Before you start to install your True unit,
carefully inspect it for freight damage. If damage
is discovered, immediately file a claim with the
delivery freight carrier.
True is not responsible for damage incurred
during shipment.
OWNERSHIP
Adjustable Wrench
Phillips Head Screwdriver
Level
REQUIRED TOOLS
NOTE:
Units with a solar thermometer will experience a 15
second delay after exposed to light before it reads
the proper temperature.
The following procedure is recommended for uncrating
the unit:
A. Remove the outer packaging, (cardboard and
bubbles or styrofoam corners and clear plastic).
Inspect for concealed damage. Again, immediately
file a claim with the freight carrier if there is
damage.
B. Move your unit as close to the final location as
possible before removing the wooden skid.
C. Remove door bracket on swinging glass door models
(see image 1-2). Sliding glass door models contain
shipping blocks (three for each door). Remove
the two styrofoam blocks taped to the top of the
door tracks (see image 3). The shipping blocks
are orange in color and by opening the door a little
the blocks can be removed (see images 4-6). Do
not throw the bracket or blocks away. For future
cabinet movement the bracket and blocks will need
to be installed so the glass door does not receive any
damage. (See image for bracket and shipping block
removal)
Note: Keys for coolers with door locks are located in
warranty packets
.
UNCRATING
INSTALLATION / OPERATION INSTRUCTIONS
1 2 3
4
5
6
............ www.truemfg.com ............
True Food Service Equipment, Inc.
6 6
INSTALLATION / OPERATION INSTRUCTIONS
P
A. Set unit in its final location. Be sure there is
adequate ventilation in your room. Under extreme heat
conditions, (100°F+, 38°C+), you may want to install an
exhaust fan.
Warning
Warranty is void if ventilation is insufficient.
B. Proper leveling of your True cooler is critical to
operating success (for non-mobile models). Effective
condensate removal and door operation will be effected
by leveling.
C. The cooler should be leveled front to back and side
to side with a level.
D. Ensure that the drain hose or hoses are positioned in
the pan.
E. Free plug and cord from inside the lower rear of the
cooler (do not plug in).
F. The unit should be placed close enough to the
electrical supply so that extension cords are never used.
Warning
Compressor warranties are void if the unit is
more than 7 ft. (2.1m) from plug-in connection.
LEVELING
LOCATING
REMOTE UNITS (This section applies to
remotes only!)
• Remote cabinets must be ordered as remote.
We do not recommend converting from a
standard self contained to remote system.
• All remote cabinets must be hard wired.
• No castors available.
• All remote cabinets come standard using 404A
refrigerant.
• All remote units come standard with expansion
valve, liquid line solenoid, heated condensate
pan, and defrost timer when applicable.
• Contact True Technical Service for BTU
requirements.
• No wiring necessary between cabinet and
condensing unit.
• All remote condensing units purchased from
True are 208/230 volts single phase.
If you have any questions regarding this
section, please call True at 1-(800)-325-6152.
A. Remove louver from the front of cabinet (see page
17 for louver grill removal / reinstallation) and
backguard (if applicable) from rear of cabinet.
B. Skid bolts are located in each of 4 corners inside
cabinet bottom. (See photo A).
C. Remove skid bolts. (See photo B).
D. Cut straps if applicable. (See photo C).
E. Carefully lift cabinet off of skid.
Removing skid from
bottom of cabinet.
A
B
C
Loading...