TRSYS ER1004, ER1004, ER1000, ER1000, ER1002 Datasheet

ER1000 THRU ER1004

SUPERFAST RECOVERY RECTIFIERS

VOLTAGE - 50 to 400 Volts CURRENT - 10.0 Amperes

FEATURES

TO-220AC

•Plastic package has Underwriters Laboratory Flammability Classification 94V-O utilizing Flame Retardant Epoxy Molding Compound

•Exceeds environmental standards of MIL-S-19500/228

•Low power loss, high efficiency

•Low forward voltage, high current capability

•High surge capacity

•Super fast recovery times, high voltage

•Epitaxial chip construction

MECHANICAL DATA

Case: TO-220AC molded plastic

Terminals: Lead, solderable per MIL-STD-202, Method 208

Polarity: As marked

Mounting Position: Any

Weight: 0.08 ounces, 2.24 grams

MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS

Ratings at 25 ambient temperature unless otherwise specified.

Single phase, half wave, 60Hz, Resistive or inductive load.

For capacitive load, derate current by 20%.

	ER1000	ER1001		ER1001A		ER1002		ER1003		ER1004	UNITS
Maximum Recurrent Peak Reverse Voltage	50	100		150		200		300		400	V
Maximum RMS Voltage	35	70		105		140		210		320	V
Maximum DC Blocking Voltage	50	100		150		200		300		400	V
Maximum Average Forward Rectified			10								A
Current at TC=100
Peak Forward Surge Current,			150								A
8.3ms single half sine-wave superimposed
on rated load(JEDEC method)
Maximum Forward Voltage at 10.0A per		0.95						1.30			V
element
Maximum DC Reverse Current at Rated Ta=25			10								A
DC Blocking Voltage per element Ta=125			500
Typical Junction capacitance (Note 1)			62								PF
Maximum Reverse Recovery Time(Note 2)			35						50		ns
Typical Thermal Resistance(Note 3) R JC			3.0								/W
Operating and Storage Temperature Range TJ				-55 to +150

NOTES:

1.Measured at 1 MHz and applied reverse voltage of 4.0 VDC

2.Reverse Recovery Test Conditions: IF=.5A, IR=1A, Irr=.25A