TRENDnet N300 Wireless PoE Access Point, TEW-638PAP 1.01 User Manual

3.98 Mb
Loading...

Quick Installation Guide

TEW-638PAP

1.01

Table of Contents

English

1

1.

Before You Start

1

2.

Hardware Installation

2

3.

Power-over-Ethernet Installation

8

Troubleshooting

10

Version 01.08.2010

1. Before You Start

Package Contents

?TEW-638PAP

?Multi-Language Quick Installation Guide

?CD-ROM (Utility and User's Guide)

?AC Power Adapter (12V DC, 0.5A)

?Cat. 5 Ethernet Cable (0.6m / 2ft.)

System Requirements

?Web Browser: Internet Explorer (6 or higher)

?A computer with a network adapter or wireless adapter properly installed

?A router with an available network LAN port

?An available DHCP Server – routers usually have a built-in DHCP server

?Power over Ethernet (PoE) Switch (e.g. TPE-80WS) (Optional)

?Injector (e.g. TPE-111GI) (Optional)

Note: The TEW-638PAP only works with Power over Ethernet (PoE) devices that follow the IEEE 802.3af standard.

1

2. Hardware Installation

Note:

1.Locate an optimum location for the Access Point. The best place for the Access Point is usually at the center of your wireless network.

2.Disable any anti-virus and firewall programs before starting hardware installation.

3.For Power-Over-Ethernet installation instructions, please refer to section

3.Power-Over-Etherent installation.

For Windows Users

1.Insert Utility CD-ROM into your computer's CD-ROM drive.

2.Click Run Setup.exe (Windows 7/Vista only)

3. Click Setup Wizard.

4.Click I accept the terms in the License

Agreement and then click Next.

2

5.Connect the provided RJ-45 cable from a LAN port on your Router to the LAN port on the TEW-638PAP. Then click Next.

6.Connect a RJ-45 cable from a LAN port on your Router to the Ethernet port on your computer.

7.Connect the Power Adapter to the Access Point and then to a power outlet. Verify that the power switch is set to the on position. and then click Next.

8.Select the TEW-638PAP from the list and then click Configure.

3

9. Enter a password and then click Login. The default password is admin.

10.Select Access Point and then click Next. Note: For AP Client setup, please refer to the User's Guide for step by step instructions. The User's Guide can be found on this product's CD-ROM.

11.Select Dynamic IP Address Configuration and then click Configure.

12. Select Manual setup and then click Next.

4

+ 11 hidden pages