Toshiba MK6022GAX, HDD2184 User Manual

0 (0)

TOSHIBA AMERICA INFORMATION SYSTEMS STORAGE DEVICE DIVISION

IRVINE, CALIFORNIA

MK6022GAX (HDD2184) 2.5-INCH HARD DISK DRIVE USER MANUAL

Rev 02

11/2006

CONTENTS

 

Introduction..............................................................................

1

Setup ........................................................................................

2

Using the HDD .........................................................................

4

Troubleshooting.......................................................................

5

Specifications ..........................................................................

6

Drive Connectors.....................................................................

8

INTRODUCTION - MK6022GAX (HDD2184)

General Features

Rotational speed of 5,400rpm

2.5" sized drive

Fluid Dynamic Bearing (FDB) Motor

2 Platter

60 Gigabytes*

9.5mm High

12ms Average Seek Time

ATA-2,3,4,5 Interface

Supports high transfer rates of 100 MB/sec

16MB Buffer

MTTF 300,000 Hours

*Toshiba defines a megabyte (MB) as 1,000,000 bytes and a gigabyte (GB) as 1,000,000,000 bytes.

1

Toshiba MK6022GAX, HDD2184 User Manual

SETUP – MK6022GAX (HDD2184)

Caution: Your Hard Disk Drive is a precision device and even a small drop onto any surface can cause damage. Electronstatic discharge can also damage the drive. You should ground yourself prior to handling the drive.

Master/Slave Settings

Your Toshiba Hard Disk Drive can be configured as either a "Master" or "Slave" unit. Master configuration is used for all single drive applications, and master or slave configuration (only one of each per port) is used for two drive applications. Use the information in the following table before setting drive as Master or Slave.

Master configuration is obtained by setting jumpers A, B, C & D open (no jumper present). Slave configuration is obtained by setting jumpers C-D. When B-D jumper is installed, the drive is configured as cable select. If pin 28 = Low, the drive is "Master", if pin 28 - High, the drive is "Slave".

Figure 1.HDD Jumper Locations

JUMPER

P28

DRIVE

No Jumper

-

Master Drive

 

 

 

C-D Jumper

-

Slave Drive

 

 

 

B-D Jumper

LOW

Master Drive

 

 

 

B-D Jumper

HIGH

Slave Drive

 

 

 

Prohibit A-B Jumper

-

-

 

 

 

Prohibit A-C Jumper

-

-

 

 

 

2

Loading...
+ 7 hidden pages