Form No. 3377-825 Rev A
Rock and Dirt Stakes
2024 or 4045 Directional Drill
Model No. 23802
Model No. 23804
Model No. 23827
Model No. 23829
Installation Instructions
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description |
Qty. |
Use |
|
|
|
Rock or Dirt stake |
2 |
Install the stakes for the 2024 directional drill. |
|
|
|
Rock or Dirt stake |
2 |
Install the stakes for the 4045 directional drill. |
|
|
|
Installing the Stakes for the 2024 Directional Drill
Note: Using 2 people makes it easier to install the stakes.
1.Position the thrust frame 25.4 cm (12 inches) off the ground, with the stakes in the up position.
2.Unlatch and open the stake-down cage door (Figure 2).
3.While holding the stakes, remove the o-rings and pins securing the stakes to the motors (Figure 2).
4.Remove the existing stakes.
5.Install the new stakes by aligning the hole in the stake with the hole in the motor and secure it with the o-rings and pins previously removed.
6.Close and latch the stake-down cage.
Figure 1
|
1. Thrust frame |
2. Stake-down cage |
|
|
|
|
|
|
|
|
|
© 2013—The Toro® Company |
Register at www.Toro.com. |
Original Instructions (EN) |
*3377-825* A |
||
8111 Lyndale Avenue South |
|
|
Printed in the USA. |
||
Bloomington, MN 55420 |
|
|
All Rights Reserved |