TDS8000
Table of contents
Loading...
Reference
CSA8000 Communications Signal Analyzer
TDS8000 Digital Sampling Oscilloscope
071-0437-00
*P071043700*
071043700
To Use the Screen Controls
Use the mouse to select waveforms, menus, and buttons. You can also
drag with the mouse to do the following operations.
Click a measurement icon to
take a measurement of the
currently selected waveform.
Drag the horizontal reference to move
the point around which horizontal scaling
expands and contracts the waveforms.
Drag waveform icon vertically to
position the waveform vertically.
Drag the zero-reference indicator
to add offset to a waveform.
Drag across a waveform segment
and click the Zoom button to expand
the selected waveform segment
horizontally to full-screen width.
Other Navigation Tips:
H
Right click on display items and readouts to find set-up
shortcuts and additional options.
H
Use the touch screen to make selections if a mouse is not
available. Push the front-panel
the touch screen on and off.
H
When using the touch screen, you can use your finger or the
touch-screen stylus that shipped with the product.
TOUCH SCREEN button to toggle
Copyright E Tektronix, Inc.
To Use Instrument I/O
On the Front Panel
Floppy disk drive accessible
from Windows 98
Accommodates optical and
electrical modules:
Compartments for large
modules, up to two channels
Compartments for small
modules, up to eight channels
Antistatic connection for wrist
strap, 1 MW to ground
Trigger
Prescale
Input
Trigger
Direct
Input
Trigger
Probe
Power
Internal Clock Output
DC Calibration Output
External 10 MHz Reference Input
On the Rear Panel
Removable hard disk drive to provide
individual environment for each user or to
secure data, press to release
CDROM drive accessible from
Windows 98, press to open
USB connector for mouse or
keyboard and mouse
PS-2 connectors for mouse and keyboard
Upper VGA port to connect a
monitor for side-by-side display
Lower VGA port to connect a
monitor for instrument display
Parallel port (Centronics) to
connect printer or other device
GPIB port to connect to controller
RJ-45 connector to connect to network
COM1 serial port
PCMCIA slots for two type-1 cards,
two type-2 cards, or one type-3 card
To Access the Setup Dialog Boxes
Click the Setups icon to access
the setup dialog boxes with the
one last active selected.
Access any setup dialog
box from the Setup menu.
Push the
button to access the last
access the setup dialog box
SETUP DIALOG
active setup dialog box.
Push a MENU button to
for that control group.
Click on the tabs to
select among the
setup dialog boxes.
Loading...