Loading...
Z
For Windows only
Supported products
Installation guide for the HA-P90SD USB DRIVER
3Select the language that you want to use for installation and click “OK”.
HA-P90SD |
|
|
Recommended hardware |
|
|
PC with Intel Core 2 Duo or faster processor and 1 GB or more |
|
|
memory |
|
|
Supported operating systems |
|
|
Windows 7 (32/64-bit) |
|
|
Windows 8 (32/64-bit) |
|
|
Windows 8.1 (32/64-bit) |
|
|
as of January, 2015 |
|
|
|
|
4 Click “Next”. |
Precautions before installation |
|
|
Install the dedicated driver software before connecting |
|
|
the computer by USB. |
|
|
Correct operation will not be possible if you connect the com- |
|
|
puter before installing the driver. |
|
|
|
|
|
ASIO is a trademark and software of Steinberg Media Technologies |
|
|
GmbH. |
|
|
Microsoft and Windows are either registered trademarks or trade- |
|
|
marks of Microsoft Corporation in the United States and/or other |
|
|
countries. |
|
|
Other company names and product names in this document are |
|
|
the trademarks or registered trademarks of their respective owners. |
|
|
Driver installation procedures
ATTENTION
The V1.0.0.1 driver supports HA-P90SD V1.02 and later firmware versions. If the unit is using an older firmware version, update the firmware before updating the driver.
1Uncompress the downloaded file.
2If using a 32-bit operating system, double-click the TEAC_HA_P90SD_AsioDriver32bit.exe file to open the installation wizard.
If using a 64-bit operating system, double-click the TEAC_HA_P90SD_AsioDriver64bit.exe file to open the installation wizard.
If a Software (program) use confirmation pop-up appears, click “Run” or “Yes” to continue with installation of the driver file.
5 After confirming the contents of the License Agreement, select “I accept the terms in the license agreement” and click “Next”.
D01259810B |
Continued on the next page e |
1 |
|
|
Z Installation guide for the HA-P90SD USB DRIVER
6 Click “Install”. |
Connecting with a computer |
|
7If a Windows security pop-up message appears during installation, click “Install” or “Continue Anyway”.
Windows 8.1, Windows 8 and Windows 7 Display example
8When the wizard's completion screen appears, click “Finish” to finish the installation.
The first time the unit is connected to one of the computer's USB ports, a driver will be detected automatically.
The contents of the driver software installation window will change as follows.
c
c
When “ Ready to use” appears, click “Close” to finish the installation.
2
Loading...