ATTENTION! Targus Wireless RF Mouse Users
Before You Begin
After your computer detects the USB receiver and the driver software is installed, you must establish a communications link between the mouse and its receiver BEFORE you can use the mouse. To establish this link, you need to set the identification code so that the mouse works properly. To do this, follow the instructions for your mouse model.
NOTE: This addendum replaces the section titled “Establishing a Communications Link (All RF Mouse Models)” in the supplied user’s guide.
Mouse Model PAUM005
Establishing a Communications Link
Make sure that your computer is turned on and has detected the USB receiver before you establish a communications link.
1 Press and release the link button on the receiver.
Link button 
Receiver link button (PAUM005)
The receiver’s status light glows blue when the receiver is activated. 2 Press and release the reset button, located on the bottom of the mouse.
CAUTION: Pressing and holding the reset button longer than 1.5 seconds may cause the mouse to enter power off mode. See “Powering the Mouse Off and On” below.
Reset button
Mouse reset button (PAUM005)
The mouse’s red light emitter diode (LED) stops glowing when you press the reset button and resumes glowing when the button is released.
You are now ready to use the RF mouse.
Powering the Mouse Off and On
To power off the mouse:
1Press any key to wake the mouse (if it’s in sleep mode).
2Press and hold the reset button for at least two seconds.
3Release the reset button when the red LED flashes one time.
The mouse is now in power off mode and cannot be used. To power on the mouse, press and release the reset button so that the red LED glows. You can now use the mouse again.
Things to Remember
Batteries
General PAUM005
Mouse Model PAUM006
Establishing a Communications Link
1 Press and release the link button on the receiver.
Link button/ 
status light 
Receiver link button (PAUM006)
2Press and release the link button, located on the bottom of the RF mouse.
Link button
Mouse link button (PAUM006)
The receiver’s status light flashes red once the mouse and receiver are activated and whenever there is mouse activity.
NOTE: You may need to press the mouse’s link button more than once if the receiver’s status light does not glow red.
The receiver’s status light flashes while it scans the identification codes for the mouse. Once a valid code is selected, the status light stops flashing.
3 To use the mouse, press any button.
PAUM006
•You must establish a communications link every time you change the batteries.
•To extend the life of your batteries, remove them from the mouse while traveling.
•You should change the batteries when the LED on the • scroller wheel glows blue.
•The mouse enters sleep mode every time the batteries are changed. To wake the mouse from sleep mode, press any button.
You should change the batteries every two to three months, depending on how often you use the mouse.
Sleep Mode
• |
The mouse’s sleep mode feature activates after 20 minutes of non-operation. |
|
• |
To wake the mouse from sleep mode, press any button. |
402-0250-001B |
Loading...