the evolution revealed
TS12
500W RMS 26Hz(-6dB) 15Hz
2 x line level phone
2 x XLR balanced
2 x XLR balanced
(direct or 80Hz high pass) 2nd order low pass, 50Hz - 150Hz, -6dB
After approximately 12 mins. in absence of input signal
300mm (12“) Closed box
22 litre / 0.78cu.ft Phase control
Crossover defeat switch for LFE operation
Soft limiting to avoid overload LF extension control
372 x 335 x 335mm 145/8 x 131/8 x 131/8” 12.5kg / 27.5 lbs
120V nominal AC~60Hz
230V nominal AC~50Hz
120V - T5AL / 250V
230V - T2.5AL / 250V
600VA
Features
Rigid cabinet, down-firing driver BASH® digital power amplifier Stereo line level inputs
XLR input and output
Direct or switched 80Hz high pass Auto power on and sleep function Soft-clip limiting
Gain and phase controls
& |
& |
|
PERFORMANCE |
TS8 |
TS10 |
Output power |
200W RMS |
300W RMS |
Low frequency response |
32Hz(-6dB) |
29Hz(-6dB) |
Limit for usable output |
18Hz |
16Hz |
Inputs |
2 x line level phone |
2 x line level phone |
|
2 x XLR balanced |
2 x XLR balanced |
Outputs |
2 x XLR balanced |
2 x XLR balanced |
|
(direct or 80Hz high pass) |
(direct or 80Hz high pass) |
Input filter |
2nd order low pass, |
2nd order low pass, |
|
50Hz - 150Hz, -6dB |
50Hz - 150Hz, -6dB |
Auto mute |
After approximately 12 mins. |
After approximately 12 mins. |
|
in absence of input signal |
in absence of input signal |
Driver type |
200mm (8”) |
250mm (10”) |
Enclosure type |
Closed box |
Closed box |
Enclosure volume |
12.5 litre / 0.45cu.ft |
16.75 litre / 0.6cu.ft |
Additional features |
Phase control |
Phase control |
|
Crossover defeat switch for |
Crossover defeat switch for |
|
LFE operation |
LFE operation |
|
Soft limiting to avoid overload |
Soft limiting to avoid overload |
|
LF extension control |
LF extension control |
Enclosure (HxWxD) |
|
|
- including feet |
292 x 280 x 255mm |
323 x 286 x 286mm |
|
111/2 x 111/2 x 10” |
121/16 x 115/16 x 115/16” |
Enclosure weight |
7.0kg / 15.4 lbs |
9.5kg / 21 lbs |
Mains voltage |
120V nominal AC~60Hz |
120V nominal AC~60Hz |
|
230V nominal AC~50Hz |
230V nominal AC~50Hz |
Mains fuse |
120V - T2AL / 250V |
120V - T3. 15AL / 250V |
|
230V - T1AL / 250V |
230V - T1.6AL / 250V |
Maximum power |
|
|
consumption |
275VA |
416VA |
TS8, TS10 & TS12 Professional Active Subwoofers
Three powerful active subwoofers have been designed to complement the Reveal range of studio monitors for 2.1, 5.1, 7.2 configurations or in any other multi channel combination required. All are substantially constructed closed box cabinets with high power handling and long throw drive units delivering tightly controlled bass with massive impact; ensuring that the punch and drive of the mix track is faithfully reproduced.
Reveal |
66 |
Frequency response (1) |
60Hz-51kHZ |
Recommended Amplifier Power |
80 to 150W @ 8W |
Power Handling Average RMS |
80W |
Normal Impedance |
6 |
Sensitivity (3) |
92dB for 1W at 1m |
Distortion |
<0.6% |
Crossover Frequency |
2.7kHz |
Dispersion (@-6dB) |
90 degrees |
DRIVE UNITS |
|
Drive Units - LF/MID |
2 x 165mm (61/2”) multi fibre |
|
paper pulp cone |
WideBand™ HF |
25mm (1”) titanium dome |
|
neodymium magnet system |
Cabinet |
|
Type |
Optimised bass-reflex loaded |
Construction |
MDF cabinet and front baffle. |
Tongue and groove front and back |
|
Finish |
Grey cabinet |
|
Maroon painted baffle |
|
|
Reveal 66
Passive centre channel reference monitor
Optimised bass-reflex loaded cabinet with 40mm thick front baffle
Two shielded 165mm (61/2”) woofers, multi fibre paper pulp cones
Shielded 25mm (1”) titanium dome neodymium tweeter
WideBand™ HF extended to 51kHz corrects phase response
Whether you’re mixing for film, video or 5.1 audio formats, a dedicated centre-channel is a must.
The Reveal 66 is designed to fit into your production environment with minimal visual obstruction while delivering the kind of performance demanded of a centre-channel speaker.
Wide dynamic range, equal capability with vocal and music tracks and more than enough acoustic output make the Reveal 66 the perfect
Loading...