Model No. GM-PAC-10E2
10,000 BTU Portable Air Conditioner
Operating Instructions
Thank you for choosing a Soleus Air Powered by Gree Portable Air Conditioner. This owner’s manual will provide you with valuable information necessary for the proper care and maintenance of your new product. Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new Portable Air Conditioner.
For your own records, please attach a copy of your sales receipt to this manual. Also, write the store name/location, date purchased, and serial number below:
Store Name: ____________________________________________________
Location: ______________________________________________________
Date Purchased: _________________________________________________
Serial Number (located on back of unit): ______________________________
IMPORTANT INSTRUCTIONS
Before installing and using your portable air conditioner, please read this owner’s manual carefully. Store this manual in a safe place for future reference.
1)Always place the unit on a level surface.
2)Never use or store gasoline or other flammable vapor or liquid near this unit unless instructed by this manual.
3)Maintain at least 10 inches (25 cm) clearance space around this unit. Do not block or cover air inlet or outlet grilles.
4)The unit must be connected to a correctly grounded power supply.
5)Do not start or stop the unit by inserting or pulling out the power plug.
6)Do not use an adapter plug or extension cord.
7)Do not use the unit in the immediate surroundings of a bath, a shower or a swimming pool.
8)Do not insert anything into the air outlet. Do not obstruct air inlet or outlet grills unless instructed by this manual.
9)Do not let children play near this unit.
10)Always inspect the cord for signs of damage before use. If the power cord is damaged, it must be replaced by the manufacturer or a qualified service technician.
11)When cleaning the unit, always turn the unit off and unplug the power cord.
12)Avoid using heating appliance near the air conditioner.
2
LCDI POWER CORD AND PLUG
This air conditioner is equipped with an LCDI (Leakage Current Detection and Interruption) power cord and plug as required by US National Electric Code 440.65. This cord consists of a length of shielded flexible cord with no termination on the load side and a LCDI attachment plug on the line side.
The LCDI power cord and plug will remove the supply source via electrical disconnect (circuit trip) if the nominal current leakage between the cord shield and either load conductor exceeds a predetermined value. The cord will remain de-energized until the devise has been manually reset. This is intended to reduce the risk of a fire in the power cord or combustible materials nearby. The cord shields are not grounded and they must be considered a shock hazards if exposed. The cord shield must not be connected to ground or to any exposed metal.
The test and reset buttons on the LCDI Plug are used to check if the plug is functioning properly. To test:
1.Plug power cord into wall outlet
2.Press TEST Button, circuit should trip, cutting power to the air conditioner
3.Press RESET button for use
If a test is performed and the indicator light remains ON, current leakage has been detected. Do not use the air conditioner or attempt to reset the LCDI Plug. Contact Soleus Air Powered by Gree Customer Service for troubleshooting recommendations.
RESET
TEST
WARNING:
1. DO NOT press the TEST button while the air conditioner is operating.
2. The TEST and RESET buttons should not be used as ON and OFF switches.
3.The cord and plug are not intended to offer protection to externally connected loads or supply circuits.
4.The cord and plug are intended for indoor use only.
3
INCLUDE
PARTS INCLUDED
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Window Exhaust Adapter A |
Exhaust Hose |
Window ExhaustAdapter B |
Window Exhaust Adapter C |
Adjustable Window Slider |
(3) |
Power cord |
Drain hose |
Hose Clamp |
Screw (7 ) |
|
|
|
|
hook(2)
|
|
|
|
|
|
|
|
|
|
|
|
|
Battery (2 ) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|
|
Remove control |
|
||||||||||||
Hose clip(2) |
Rubber plug |
Manual |
|||||||||||||
(AAA.1.5V) |
SUGGESTED TOOLS FOR WINDOW PANEL INSTALLATION
1. Screwdriver(medium size Phillips) |
2. Tape measure or ruler |
3. Knife or scissors |
4.Saw (In the event that the window panel needs to be cut down in size because the window is too narrow for direct installation.)
4
STRUCTURE
1
Front |
2 |
|
|
|
|
|
|
|
|
1, Control panel and display lamp |
|
|
|
2, Remove control signal receiver window |
|
|
3 |
3, Handel |
|
|
|
4, Remote controller box |
|
|
|
5, Air outlet |
|
|
|
6, Vertical louvers |
|
|
4 |
7, Horizontal louvers |
|
|
|
8, Wheel |
|
|
|
9, Air inlet |
|
|
|
10, Grille |
|
|
5 |
11, Air outlet |
|
|
|
12,Air inlet |
|
|
6 |
13,Power cord hook |
|
|
14, Power cord |
|
|
|
|
|
|
|
7 |
15, Window exhaust adapter A |
|
|
|
16, Exhaust hose |
|
|
|
17, Window exhaust adapter |
B |
|
|
18, Window exhaust adapter |
C |
|
|
19, Remove control |
|
|
8 |
|
|
Rear
9
10
18 |
17 |
16 |
15 |
11
19
12
14
13
5
PACKAGE CONTENTS
Portable Air Conditioner
Exhaust Hose (1)
Window Exhaust Adapter A (1)
Window Exhaust Adapter B (1)
Window Exhaust Adapter C (1)
Remote Control & AAA Batteries (2 batteries)
Window Kit - 3 Sliding Panels (1 single hose panel, 2 extension panels)
Drain Hose Assembly (drain pipe, hose clamp, hose clip, rubber plug, & screw)
Power cord hooks (2hooks & screws)
Owner’s Manual
SPECIFICATIONS
The cooling capacity is measured at an ambient temperature of DB 95 °F, WB 83 °F.
Noise level is measured at a distance of 3.28 ft away from the front of the unit, when the unit is in cooling mode.
Power consumption is measured when the fan runs at the highest speed setting.
These specifications are for reference only. For actual data, please refer to the rating label on the back of the unit.
If the environment temperature is higher than the max operating temperature or lower than the minimum operating temperature, the air conditioner may not work properly.
|
Model Number |
GM-PAC-10E2 |
|
|
Power Supply (Ph/V/Hz) |
1/115/60Hz |
|
|
Dehumidifying Capacity (Pints/Day) |
60 |
|
|
Rated Cooling Capacity (BTU/h) |
10,000 |
|
|
Rated Heating Capacity (BTU/h) |
/ |
|
|
Cooling Power Input (Watts) |
1120 |
|
|
Heating Power Input (Watts) |
/ |
|
|
Rated Current Cooling (Amperage) |
9.9 |
|
|
Rated Current Heating (Amperage) |
/ |
|
|
EER/C.O.P |
/ |
|
|
Noise Level db (A) H/L |
<=53 |
|
|
CFM |
176 |
|
|
Design Pressure (PSIG) (H/L) |
/ |
|
|
Dimensions (W” x H” x D”) |
13.375X30.75X15.5 |
|
|
Package Dimensions (W” x H” x D”) |
15.75 X 32X 21.75 |
|
|
Net/Gross Weight (Lbs) |
53/66 |
|
|
Refrigerant Type |
R-410A |
|
|
Refrigerant Charge (Oz) |
17 |
|
|
|
|
|
6