INSTRUCTIONS FOR THE USER: these provide recommendations for
use, a description of the controls and the correct procedures for cleaning
and maintaining the appliance
INSTRUCTIONS FOR THE INSTALLER: these are intended for the
qualified engineer who is to install, commission and test the appliance
1 PRECAUTIONS FOR USE .............................................................................. 11
2 GET TO KNOW YOUR OVEN ......................................................................... 12
3 ACCESSORIES AVAILABLE .......................................................................... 12
4 BEFORE INSTALLATION ............................................................................... 13
5 DESCRIPTION OF FRONT PANEL CONTROLS ........................................... 13
6 USING THE OVEN .......................................................................................... 15
7 WATER FEEDING ........................................................................................... 16
8 SELECTING THE FUNCTION ......................................................................... 17
9 RECOMMENDED COOKING TABLES: COOKING WITH STEAM ................. 28
10 COOKING WITH THE GRILL .......................................................................... 33
11 COOKING WITH HOT AIR .............................................................................. 34
12 CARE AND MAINTENANCE ........................................................................... 36
16 BEFORE INSTALLATION ............................................................................... 44
17 POSITIONING THE OVEN .............................................................................. 48
Grounding Instructions
EN
EN
3
This appliance must be connected to a
grounded, metallic, permanent wiring
system, or an equipment grounding
conductor should be run with the circuit
conductors and connected to the
equipment grounding terminal or lead on
the appliance.
Warning! IMPROPER USE OF THE
GROUNDING CAN RESULT IN A RISK OF
ELECTRICAL SHOCK.
Please refer to the Installation
Instructions for further information.
Safety Information
EN
EN
EN
4
Carefully read the instructions before
installing and using the equipment. The
manufacturer is not liable for improper
installation and use of the equipment that
may cause injuries and damage. Always
keep the instructions at hand, so they can
be easily referred to during use.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety
precautions should always be followed
including the following:
1. Proper Installation – Be sure your
appliance is properly installed and
grounded by a qualified technician.
2. Never Use Your Appliance for Warming
or Heating the Room.
3. Do Not Leave Children Alone – Children
should not be left alone or unattended in
area where appliance is in use. They
should never be allowed to sit or stand on
any part of the appliance.
4. Wear Proper Apparel – Loose-fitting or
hanging garments should never be worn
while using the appliance.
5. User Servicing – Do not repair or replace
any part of the appliance unless
specifically recommended in the manual.
Safety Information
EN
EN
EN
5
All other servicing should be referred to a
qualified technician.
6. Storage in or on Appliance – Flammable
materials should not be stored in an oven
7. Do Not Use Water on Grease Fires –
Smother fire or flame or use dry chemical
or foam-type extinguisher.
8. Use Only Dry Potholders – Moist or damp
potholders on hot surfaces may result in
burns from steam. Do not let potholder
touch hot heating elements. Do not use a
towel or other bulky cloth.
9. Use Care When Opening Door – Let hot
air or steam escape before removing or
replacing food.
10. Do Not Heat Unopened Food Containers
– Build-up of pressure may cause
container to burst and result in injury.
11. Keep Oven Vent Ducts Unobstructed.
12. Placement of Oven Racks – Always place
oven racks in desired location while oven
is cool. If rack must be moved while oven
is hot, do not let potholder contact hot
heating element in oven.
13. DO NOT TOUCH HEATING ELEMENTS
OR INTERIOR SURFACES OF OVEN –
Heating elements may be hot even
though they are dark in color. Interior
Safety Information
EN
EN
EN
6
surfaces of an oven become hot enough
to cause burns. During and after use, do
not touch, or let clothing or other
flammable materials contact heating
elements or interior surfaces of oven
until they have had sufficient time to
cool.
This Steam Oven is for household use
Safety Information
EN
EN
EN
7
Safety of children and vulnerable adults
WARNING! Risk of choking, injury or
permanent disability.
This appliance can be used by children aged 8
years and above and persons with reduced
physical, sensory or mental capabilities or lack
of experience and knowledge if they are given
supervision or instructions concerning how to
use the appliance in a safe way and
understand the hazards involved.
Children should not play with the appliance.
Keep packaging materials away from children.
Risk of suffocation!
Keep children away from the appliance during
operation or when cooling.
Cleaning and maintenance should not be done
by children without supervision
Warnings on general safety
During installation, follow the instructions
supplied separately.
Only qualified personnel can install the
appliance and replace the cable.
WARNING: The appliance and its
accessible parts become hot during use. Care
should be taken to avoid touching heating
elements. Children less than 8 years of age
Safety Information
EN
EN
EN
8
shall be kept away unless continuously
supervised.
During use the appliance becomes hot. Care
should be taken to avoid touching heating
elements inside the oven.
WARNING: Accessible parts may become
hot during use. Young children should be kept
away.
Do not use steam cleaners to clean the
appliance.
Do not use abrasive detergents or metal
scrapers to clean the appliance.
The electric connection is made via an
omnipolar switch, which is suitable for the
intensity to be tolerated and which has a
minimum gap of 3mm between its contacts,
which will ensure disconnection in case of
emergency or when cleaning the crockery
warmer. If a plug is used for the electric
connection, then it must be accessible after
installation.
The connection should include correct
earthing, in compliance with current norms.
Disconnect the appliance from the power
supply before carrying out any maintenance
operation
Safety Information
EN
EN
EN
9
WARNING!
Before connecting the appliance compare the power data (voltage and frequency)
indicated on the characteristics plate with those of the power supply in question. If
these data do not match there may be problems. In case of doubt, contact an
electrician.
WARNING!
If the electrical wire plug is removed, the appliance must be installed and connected
by a technician. Contact a qualified electrician who knows and respects current
safety standards. The manufacturer cannot be held responsible for damage
resulting from fitting or connecting errors.
WARNING!
The electrical safety of the appliance can only be guaranteed if it is earthed. The
manufacturer cannot be held responsible for damage resulting from the absence of
or defects in the installation’s protection system (e.g. electrical shock).
WARNING!
Only use the appliance once it has been fitted into its built-in position. Only in this
manner can it be guaranteed that users cannot access the electrical components.
WARNING!
Never open up the appliance’s frame. Possible contacts with electrical conducting
parts or changes to electrical or mechanical components may represent a danger to
users’ safety and prejudice the correct working of the appliance.
WARNING!
Repairs and maintenance, especially of parts carrying electrical current, must only
be done by technicians authorised by the manufacturer. The manufacturer and
retailers do not accept responsibility for any damaged caused to people, animals or
property as a result of repairs and maintenance carried out by non-authorised
personnel.
Safety Information
EN
EN
EN
10
WARNING!
Repairs undertaken during the guarantee period must only be done by technicians
authorised by the manufacturer. If this is not the case then any damage resulting
from the repair in question is excluded from the guarantee
WARNING!
The appliance must be disconnected from the electrical current when installation
and repair work is being done. To disconnect the appliance from the current, one of
the following conditions must apply:
• The switchboard fuses / circuit breakers must be disconnected.
• The plug should be removed from the socket. To remove the plug from the
socket do not pull on the electric cable but rather pull out the plug itself
directly.
Safety Information
EN
EN
EN
11
1 PRECAUTIONS FOR USE
THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE. TAKE GOOD
CARE OF IT AND KEEP IT TO HAND THROUGHOUT THE OVEN'S LIFE CYCLE.
WE URGE YOU TO READ THIS MANUAL AND ALL THE INFORMATION IT
CONTAINS CAREFULLY BEFORE USING THE APPLIANCE. INSTALLATION
MUST BE CARRIED OUT BY QUALIFIED STAFF IN COMPLIANCE WITH THE
RELEVANT REGULATIONS. THIS APPLIANCE IS INTENDED FOR HOUSEHOLD
USE AND COMPLIES WITH THE EEC DIRECTIVES CURRENTLY IN FORCE.
THE APPLIANCE IS BUILT TO PROVIDE THE FOLLOWING FUNCTION:
COOKING AND HEATING FOODS; ALL OTHER USES ARE TO BE
CONSIDERED IMPROPER.
THE MANUFACTURER DECLINES ALL LIABILITY FOR USES OTHER THAN
THOSE STATED ABOVE.
KEEP THE DOCUMENTATION OF THIS PRODUCT FOR FUTURE REFERENCE.
ALWAYS KEEP THE INSTRUCTION MANUAL HANDY. IF YOU LEND THE
STEAMER TO SOMEONE ELSE GIVE THEM THE MANUAL AS WELL!
NEVER USE THIS APPLIANCE FOR HEATING ROOMS.
NEVER LEAVE PACKAGING RESIDUES UNATTENDED IN THE HOME.
SEPARATE THE VARIOUS PACKAGING MATERIALS BY TYPE AND CONSIGN
THEM TO THE NEAREST SEPARATE DISPOSAL CENTRE.
THIS APPLIANCE IS TAGGED UNDER EUROPEAN DIRECTIVE 2002/96/EC ON
WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE).
THIS DIRECTIVE CONTAINS THE REGULATIONS GOVERNING THE
COLLECTION AND RECYCLING OF DECOMMISSIONED APPLIANCES
THROUGHOUT THE EUROPEAN UNION.
NEVER OBSTRUCT THE OPENINGS AND SLITS PROVIDED FOR
VENTILATION AND HEAT DISPERSAL.
THE NAMEPLATE WITH THE TECHNICAL DATA, SERIAL NUMBER AND MARK
IS IN A VISIBLE POSITION ON THE OVEN DOOR FRAME.
THE NAMEPLATE MUST NEVER BE REMOVED.
NEVER USE METAL SCOURING PADS OR SHARP SCRAPERS
WHICH WILL DAMAGE THE SURFACE.
USE ORDINARY NON-ABRASIVE PRODUCTS WITH THE AID OF
WOODEN OR PLASTIC UTENSILS IF NECESSARY. RINSE
THOROUGHLY AND DRY WITH A SOFT CLOTH OR CHAMOIS
LEATHER.
EN
Instructions for the User
12
1. – Door window glass
6. – Non-perforated container
2. – Catches
7. – Rack
3. – Lamp
8. – Shelf guides
4. – Control panel
9. – Sponge
5. – Perforated container
10. – Water tank
11. – Grill
2 GET TO KNOW YOUR OVEN
3 ACCESSORIES AVAILABLE
Perforated container: suitable for cooking
fresh or deep frozen vegetables, meat and
poultry.
Non-perforated container:suitable for
steaming sensitive foods, e.g. compotes and
dumplings. You can use it with the perforated
container to catch the water.
Rack: used when cooking with small
containers, as for example, dessert bowls and
to regenerate plate dishes.
Oven accessories which may come into contact with foods are made from
materials compliant with the EC Regulation 1935-2004 and national
relevant regulations.
EN
Instructions for the User
13
Function’s
parameters
knob
This knob allows you to set
the time, select the cooking
temperature and duration
and program the cooking
start and end times. From
now on, for convenience it
will be referred to as PT1.
Functionswitch on
knob
This knob allows access to
the oven's three operating
settings, and is also used to
select a cooking function
(see point “Operating
settings”).
Current time /
Duration
display
This display shows the
current time or the cooking
duration.
Also visible are the function
cut-out light
Clock
Adjusting the cooking time
4 BEFORE INSTALLATION
Never leave packaging residues unattended in the home. Separate waste
packaging materials by type and consign them to the nearest separate
disposal centre.
The inside of the appliance should be cleaned to remove all manufacturing
residues. For further information about cleaning, see point "CARE AND
MAINTENANCE".
5 DESCRIPTION OF FRONT PANEL CONTROLS
All the appliance's control and monitoring devices are placed together on
the front panel. The table below provides the key to the symbols used.
EN
Instructions for the User
14
Child lock out function
Child lock-out function mode on
(see point “9.3.4 Child safety lock-
out function”)
Cooking duration
Setting the cooking duration
Delayed start
Setting the cooking time with a
delayed start
Temperature / Type
of food display
This display shows the
Parameters set for the function
required, or the Parameters set by
the user.
Temperature
The oven is heating up
Descale function
See point 9.3.2 Descale function
Water level indication
Indicates the existing water
quantity in the tank (see point 8.2
Water levels indication)
Function display
This display shows (illuminated) all
the cooking functions available for
selection. For instructions on how
to select a cooking function, see
point “9 Selecting a cooking
function”.
STEAM
PIZZA / BREAD FUNCTION
HOT AIR + STEAM
MEAT COOKING
HOT AIR
FISH COOKING
HOT AIR + GRILL
VEGETABLES COOKING
GRILL ELEMENT
REHEATING & STERILISING
The table below provides a list of the functions available.
Please see chapter 10 for a more detailed description of the functions
EN
Instructions for the User
15
6 USING THE OVEN
6.1 Precautions and General Advice
When the oven is used for the first time, it should be heated to the
maximum temperature for long enough to burn off any oily residues left by
the manufacturing process, which might contaminate foods with
unpleasant smells.
The accessories can contain hot water when they are taken from the oven,
therefore the use of gloves and particular attention are always
recommended
Oven accessories which may come into contact with foods are made from
materials compliant with the EC Regulation 1935-2004 and national
relevant regulations.
6.2 Operating settings
This product is programmed to provide 3 operating settings, which can
be\modified by pressing PT2.
Standby setting: activated as soon as the current time has been
confirmed, with DSP1 on and showing the current time.
ON setting: from the standby setting, press PT2 once. All the displays and
knobs light up.
OFF setting: from the ON setting, press PT2 once.
Only the symbol on DSP1 remains on.
The heating system is not activated immediately in any of these
functions, in order to improve operator safety.
6.3 First Use
At first use, or after a power failure, the oven's left hand-display, DSP1, will
show a flashing symbol. The oven will not operate until the clock,
the water hardness parameter and the calibration is set.
6.3.1 Setting the current time and the water hardness level
To set the current time, turn PT1 to the right and left to increase or
decrease the hours.
Press PT1 once to move on to setting the minutes. Turn it to the right and
left to increase or decrease the minutes.
Press PT1 again to confirm the current time and move on to water
hardness level setting. The DSP2 will show the word “Dur” and DSP1 will
show the water hardness level “MEd” (pre-set value).
Turn PT1 to the right and left to change the water hardness level value, as
described in table below
Loading...
+ 33 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.