Siemens 9200 User Manual

0 (0)

9200 Power Supply

 

This document discusses the installation and specifications for the following

 

9200 meter power supply options:

 

! Standard AC/DC power supply

 

! Low voltage DC power supply

 

! 480V power supply

 

In This Document

 

! Installing the Power Supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2

! Wiring the Power Supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

3

Wiring the Standard AC/DC or Low Voltage DC Power Supply . . . . . . . . . . . . . . 3 Wiring the 480V Power Supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Powering Up the Meter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

! Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

Additional Information

! 9200 Installation and Operation Guide

© 2003 Siemens Energy & Automation. All rights reserved. The information in this document is believed to be accurate at the time of publication, however, Siemens Energy & Automation assumes no responsibility for errors which may appear here and reserves the right to make changes without notice. ION is a registered trademark of Power Measurement Ltd. All other trademarks are property of their respective owners. Revision Date: June 3, 2003

Siemens 9200 User Manual

Replacing the Power Supply

9200 Power Supply Retrofit Instructions

 

 

Replacing the Power Supply

DANGER

Installation and maintenance of ACCESS meters and meter options should only be performed by qualified personnel that have appropriate training and experience with high voltage/current devices. Refer to Installation Considerations, and the Danger, Warning, and Limitation of Liability notices in the 9200 Installation and Operation Guide.

1.Turn off all power to the meter.

2.Ensure that all cables still connected to the meter are not live.

3.Ensure that the Line and Neutral (or DC power) wires to the power supply inputs of the meter are not live (if you are replacing an existing power supply).

4.Fit the power supply plug-in connector to the meter plug-in port.

NOTE

All 9200 power supply models are installed the same way; the diagram for the 480V power supply is included to show the greater depth dimension of that model.

5.Tighten the two (captive) screws until the power supply fits snugly against the meter. Do not overtighten the screws.

Plugging in the Power Supply

Power supply

 

9200 meter plug-

 

Captive screw

plug-in connector

 

in port

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Front of the power

Captive screw

supply

Page 2

Loading...
+ 3 hidden pages