9200 Power Supply |
|
This document discusses the installation and specifications for the following |
|
9200 meter power supply options: |
|
! Standard AC/DC power supply |
|
! Low voltage DC power supply |
|
! 480V power supply |
|
In This Document |
|
! Installing the Power Supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
2 |
! Wiring the Power Supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
3 |
Wiring the Standard AC/DC or Low Voltage DC Power Supply . . . . . . . . . . . . . . 3 Wiring the 480V Power Supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Powering Up the Meter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
! Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Additional Information
! 9200 Installation and Operation Guide
© 2003 Siemens Energy & Automation. All rights reserved. The information in this document is believed to be accurate at the time of publication, however, Siemens Energy & Automation assumes no responsibility for errors which may appear here and reserves the right to make changes without notice. ION is a registered trademark of Power Measurement Ltd. All other trademarks are property of their respective owners. Revision Date: June 3, 2003
Replacing the Power Supply |
9200 Power Supply Retrofit Instructions |
|
|
Replacing the Power Supply
DANGER
Installation and maintenance of ACCESS meters and meter options should only be performed by qualified personnel that have appropriate training and experience with high voltage/current devices. Refer to Installation Considerations, and the Danger, Warning, and Limitation of Liability notices in the 9200 Installation and Operation Guide.
1.Turn off all power to the meter.
2.Ensure that all cables still connected to the meter are not live.
3.Ensure that the Line and Neutral (or DC power) wires to the power supply inputs of the meter are not live (if you are replacing an existing power supply).
4.Fit the power supply plug-in connector to the meter plug-in port.
NOTE
All 9200 power supply models are installed the same way; the diagram for the 480V power supply is included to show the greater depth dimension of that model.
5.Tighten the two (captive) screws until the power supply fits snugly against the meter. Do not overtighten the screws.
Power supply |
|
9200 meter plug- |
|
Captive screw |
|||
plug-in connector |
|
in port |
|
|
|
||
|
|
||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Front of the power |
Captive screw |
supply |
Page 2