Shurtape SF 686 User Manual
This material safety data sheet (MSDS) was prepared solely for the reference of, and as a courtesy to, Shurtape's
"article" under the OSHA Hazard Communication Standard (hereinafter “the Standard"), which exempts articles from the
customers. The adhesive tape product to which this MSDS refers is a manufactured item that meets the definition of an
requirements of the Standard, including the requirement to provide an MSDS.
Under normal conditions of use this product is not expected to release hazardous chemicals, nor pose a physical
hazard or health risk, such that the Standard would require Shurtape to provide an MSDS. However, failure to use this
product in accordance with Shurtape's recommendations or under normal conditions could result in potential physical
hazards, health risks, or other hazards.
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
SF 686 Pressure Sensitive Aluminum
General Name:
Foil Tape
SF 686 Pressure Sensitive Aluminum Foil
Shurtape Technologies, LLC Health
PO BOX 1530 Flammability
Hickory, N.C. 28603-1530 Physical Hazard
(828) 322-2700 Personal Protection
Prepared Date:
7/9/2014
HMIS III® Icons are used with permission of the American Coatings Association (ACA)
Prepared By: EHS Group
2. COMPOSITION / INFORMATION ON INGREDIENTS
Ingredient CAS Number % Weight
Aluminum Foil 7429-90-5 20-25 %
Rubber Adhesive Proprietary 70-75 %
Release Liner Proprietary 2-8 %
HMIS® III
Tape
Icons:
1
1
0
B
3. HAZARDS IDENTIFICATION
Emergency Overview
May cause skin or eye irritation by mechanical abrasion or by sensitivity to polymers.
Note: If this product is subject to combustion it will undergo hazardous decomposition that will yield the formation
and release of hazardous substances including but not limited to carbon dioxide, carbon monoxide, polycyclic
organic matter, and smoke. Exposure may cause irritation of the eyes, skin, and respiratory tract. Symptoms
such as coughing, tearing, and irritation should be regarded as potentially hazardous and measures should be
taken to avoid exposure.
Page 1 of 6
Extinguishing Media
₂
demand mode with appropriate turn-out gear and chemical resistant personal protective equipment.
handling of material.
4. FIRST AID MEASURES
Eyes
If wearing contact lenses, remove. Hold eyelids apart and immediately flush eyes with plenty of low-pressure
water for at least 15 minutes. Get medical attention if irritation persists.
Skin
Wash with soap and water. Seek medical attention if irritation develops or persists.
Ingestion:
Do not give anything by mouth to an unconscious person. Seek medical attention.
Inhalation
Not applicable.
5. FIRE FIGHTING MEASURES
Flash Point (°F) Not Determined Auto Ignition Temp (°F) Not Determined
LEL Not Determined UEL Not Determined
Hazardous Products of Combustion
If this product is subject to combustion it will undergo hazardous decomposition that will yield the
formation and release of hazardous substances including but not limited to carbon dioxide, carbon
monoxide, polycyclic organic matter, and smoke.
Fire and Explosion Hazards
Minimal fire hazard as supplied. Polymers in adhesive and polymer backed cloth will support
X Foam X X
Water Spray Dry Chemical
Fire Fighting Instruction
Wear a self-contained breathing apparatus with a full face piece operated in the positive pressure
6. ACCIDENTAL RELEASE MEASURES
Not applicable.
7. HANDLING AND STORAGE
Handling
Material will be tacky/sticky. Recommend the use of light weight cloth or leather gloves for actual
CO
X
Page 2 of 6
Loading...