Shindaiwa 82010, 41RS User Manual

TM

41RS
BROADCAST

OWNER’S MANUAL

ASSEMBLY

Remove the spreader and com-1.
ponents from the carton. Turn
spreader upside down. Insert (2)
1/4-20 x 1 1/2” hex bolts through

the attened end of handle brace,

frame and leg as shown. Install hex
nuts but do not tighten. Repeat on
opposite side. Make sure braces
are parallel and tighten all nuts.

5/32 x 2”
Cotter Pin

1/4-20 x 1 1/2”
Hex Bolt

1/8 x 1”
Cotter Pin

Frame

Handle Brace

Slide wheels onto axle with 2.

the longer portion of the wheel
facing the frame. The wheels
are identical to ease assembly.
Secure free turning wheel with
(1) 1/8 x 1” cotter pin and (1)
5/32 x 2” cotter pin on the drive
wheel.

Leg

1/4-20
Hex
Nut

Drive
Wheel

VIEWED FROM REAR OF SPREADER

Turn spreader upright and 3.
install handle tube between
braces. Secure with (2) 1/4­20 x 2” hex bolts and nuts.
Tighten handle brace nuts
installed in step 1.

Free Turning
Wheel

Handle Tube

1/4-20 x 2”
Hex Bolt

1/4-20 Hex
Nut

Feed control knob/wire through 4.
the T-handle until spring touches
the round hole. CAUTION: Do Not
Compress Spring At This Time.
Feed wire through the square
handle tube. Be sure wire passes
above the bolts in the handle
brace. Secure T-handle to the tube
with (1) 1/4-20 x 2” hex bolt. (2)

washers, and (1) hex nut in the
bottom hole, and (1) 1/4-20 x 2
1/4” hex bolt, (2) washers, and (1)

hex nut in the top hole as shown.
Remove caution label and push
the thumb release toward the
center and push down knob and
shutoff spring until knob latches.

Wire Clip

Remove Caution
Label

Thumb
Release

1/4-20 x
2 1/4” Bolt &
Washer

CAUTION: ONCE KNOB IS LATCHED, DO
NOT MOVE THUMB RELEASE UNTIL YOU
HAVE COMPLETED STEP #5.

Control Knob &
Wire Assembly

Spring

1/4-20 Hex Nut
& Washer

Slide wire retaining clip onto 5.
wire as shown. Insert wire
through hole shutoff plate. Slide
wire retaining clip over shutoff
plate and wire until the clip
locks into place.

Wire

Shutoff Plate

Install gear cover assembly over gears 6.
and secure with (2) #6-32 screws. The
41RS spreader should now be com­pletely assembled and ready for use.
Slide handle grips onto handle. Soapy
water will ease installation. (Do not use
petroleum based products.)

Handle Grip

#6-32 Screw

Handle Grip

#6-32 Screw