Sharp NA-953, NA-851, NA-901 DATASHEET

NA Series (1.05 m2, 600 V)

95 W | 90 W | 85 W

Microamorphous silicon thin-film photovoltaic modules

Say yes to solar power!

Because it protects the climate.

Innovations from a photovoltaic pioneer

As a solar specialist with 50 years' experience in photovoltaics (PV), Sharp makes significant contributions to groundbreaking progress in solar technology

The NA series of thin-film photovoltaic modules consists of an amorphous and a microcrystalline silicon layer. This microamorphous tandem

structure not only absorbs visible light but also the invisible portion of the solar spectrum. This makes especially efficient use of solar energy.

All Sharp NA series modules offer system integration which is optimal both technically and economically, and are suitable for installations in on and off-grid PV systems.

Brief details for the installer

■Tandem structure consisting of an amorphous and a microcrystalline silicon layer

■96 cells

■2,400 N/m2 mechanical load-bearing capacity (245 kg/m2)

■600 V DC maximum system voltage

■IEC/EN 61646, IEC/EN 61730, Class II (VDE: 40023069)

Product features

■Tandem structure with an amorphous and a microcrystalline silicon layer offering a stabilised module efficiency of up to 9.0%.

■The black appearance of the module creates a harmonious visual impression.

■Higher energy yields per watt, at both high temperatures and with diffuse light.

■Use of tempered white glass, EVA plastic, and weather protection film, as well as an anodised aluminium frame with drainage holes for long-term use.

■Output: connection cable with waterproof plug connector.

Quality from Sharp

Benchmarks are set by the quality standards of Sharp Solar. Continual­ checks guarantee a consistently high level of quality. Every module undergoes visual, mechanical, and electrical inspection. This is recognisable by means of the original Sharp label, the serial number, and the Sharp guarantee:

■5 year product guarantee

■10 year performance guarantee for a power output of 90%

■25 year performance guarantee for a power output of 80%

The detailed guarantee conditions and additional information can be found at www.sharp.eu.

■End users are required to register the modules with Sharp in order for the product and service warranty to be effective.

The registration documents will be handed out by the installation staff or supplied directly by Sharp.

Mechanical data

	Cell	Tandem cell of amorphous ( -Si) and
		microcrystalline ( c-Si) silicon
	Connection	2 sub-modules in parallel
	Dimensions	1,129 × 934 × 46 mm (1.05 m2)
	Weight	18 kg
	Connection type	Cable with plug connector (MC-3)
	Bypass diodes	1

Limit values

Storage air humidity (relative)	up to 90	%
Operating temperature (cell)	– 40 to + 90	°C
Storage temperature	– 40 to + 90	°C
Maximum system voltage	600	V DC
Maximum mechanical load	2,400	N/m2
Over-current protection	4	A

Electrical data

Maximum power

Open-circuit voltage

Short-circuit current

Voltage at point of maximum power Current at point of maximum power Module efficiency

NOCT

Temperature coefficient – open-circuit voltage Temperature coefficient – short-circuit current Temperature coefficient – power

		Initial values			Nominal values
	NA-953 (WQ)	NA-901 (WQ)	NA-851 (WQ)	NA-953 (WQ)	NA-901 (WQ)	NA-851 (WQ)
Pmax	111.8 Wp	105.9 Wp	100 Wp	95 Wp	90 Wp	85 Wp
Voc	66.3	66.6	65.0	65.3	65.2	63.8	V
Isc	2.37	2.20	2.20	2.30	2.11	2.11	A
Vmpp	52.7	53.5	52.0	48.0	49.3	49.0	V
Impp	2.12	1.98	1.92	1.98	1.83	1.74	A
m				9.0	8.5	8.1	%
				44	44	44	°C
Voc	– 0.30	– 0.30	– 0.30	– 0.30	– 0.30	– 0.30	% / °C
lsc	+0.070	+0.070	+0.070	+0.070	+0.070	+0.070	% / °C
Pmax	– 0.24	– 0.24	– 0.24	– 0.24	– 0.24	– 0.24	% / °C

The electrical data applies under standard test conditions (STCs): irradiation 1,000 W/m2 with light spectrum AM 1.5 and a cell temperature of 25 °C. The rated electrical characteristics are subject to a manufacturing tolerance of ± 10%. NOCT conditions: irradiation of 800 W/m2, ambient temperature of 20 °C and wind speed of 1 m/sec.

Characteristic curves NA-953 (WQ)

	Characteristic curves: open-circuit voltage /
Characteristic curves: current / power vs. voltage	short-circuit current vs. irradiation
(cell temperature: 25 °C)	(cell temperature: 25 °C)

2.51,000 (W/m2)

2.0800 (W/m2)

(A)	1.5
				600	(W/m		2)
Current	1.0
				400	(W/m		2)
	0.5		200		(W/m		2)
	0.0
		10				20					30	40	50	60	70
	Voltage (V)											Current vs. voltage
												Power vs. voltage

100		(%)	120
90			110
		max
80			100
		P	90
70		,		Voc
60	(W)	oc	80
		sc
			70
		V,
50	Power	voltageI	60	Pmax
30
40			50
		circuit-	40	Isc
10			20
20			30
		Open	10
			0	,
				Irradiance (W/m2)

Applications

■ On-grid PV systems

■ Off-grid PV systems

■ On-roof PV systems

■ Ground-mounted PV systems

Exterior dimensions

1,129

506

Frame Solar cell

Junction box

934

					+ 15 − 10			55
					38
	238 ± 20 Junction box Plug connector							Screw

46

100

Cross-section A-A’			Cross-section B-B’
	Glass
Side seal	Plastic	Solar cell
		Back cover
Frame
	Connection cable
			55
900 ± 30			900 ± 30
		100

Please read our detailed installation manual carefully before installing the photovoltaic modules. The instructions in the installation manual must always­

be observed (e. g. max. of 7 modules

in series, minus pole must be grounded, protection with blocking diodes/fuses).

A generator box with approved blocking diodes is available from your Sharp dealer.

Note

Technical data is subject to change without prior notice. Before using Sharp products, please request the latest data sheets from Sharp. Sharp accepts no responsibility for damage to devices which have been equipped with Sharp products on the basis of unverified information.

The specifications may deviate slightly and are not guaranteed. Installation and operating instructions are to be found in the corresponding handbooks, or can be downloaded from www.sharp.eu.

This module should not be directly connected to a load.

	Sharp Energy Solution Europe	Local responsibility:		Scandinavia
	a division of Sharp Electronics (Europe) GmbH	Austria	Denmark	[e-mail]
	Sonninstrasse 3, 20097 Hamburg, Germany			Spain & Portugal
		[e-mail]	[e-mail]	[e-mail]
	Tel: + 49 (0) 40 / 23 76 - 0 · Fax: + 49 (0) 40 / 23 76 - 21 93	Benelux	France	Switzerland
	www.sharp.eu	[e-mail]	[e-mail]	[e-mail]
		Central & Eastern Europe	Germany	United Kingdom
		[e-mail]	[e-mail]	[e-mail]

The reference image on the front page shows a 4.5 kWp system of Sharp.

SolarNA_105_E0210

NA-Serie (1,05 m2, 600 V)

95 W | 90 W | 85 W

Mikroamorphe Silizium-Dünnschicht-Photovoltaikmodule

Solarstrom – ja bitte!

Weil er das Klima schützt.

Innovationen vom

Photovoltaikpionier

Als Solarspezialist mit 50 Jahren Erfahrung in der Photovoltaik (PV) trägt Sharp entscheidend zu wegweisenden Fortschritten in der Solartechnologie bei.

Die Dünnschicht-Photovol­ taikmodule der NA-Serie be-

stehen aus einer amorphen

und einer mikrokristallinen Siliziumschicht. Diese mikro-­ amorphe Tandemstruktur absorbiert nicht nur die sichtbaren, sondern auch

die nicht sichtbaren Anteile des Sonnen spektrums. Dies führt zu einer besonders

effektiven Nutzung der Sonnenenergie.

Sämtliche Modultypen der Sharp NA-Serie bieten technisch wie wirtschaftlich eine optimale Systemintegration und eignen sich für die Montage in netzgekoppelten und netzfernen PV-Anlagen.

Kurzinformationen für den Installateur

■Tandemstruktur aus einer amorphen und einer mikrokristallinen Siliziumschicht

■96 Zellen

■2.400 N/m2 mechanische Belastbarkeit (245 kg/m2)

■600 V DC maximale Systemspannung

■IEC/EN 61646, IEC/EN 61730, Schutzklasse II (VDE: 40023069)

Produktmerkmale

■Tandemstruktur aus einer amorphen und einer mikrokristallinen Siliziumschicht mit einem stabilisierten Modulwirkungsgrad von bis zu 9,0 %.

■Die schwarze Moduloptik schafft ein harmonisches Erscheinungsbild.

■Höhere Energieerträge pro Watt sowohl bei hohen Temperaturen als auch bei diffusem Licht.

■Verwendung von vergütetem Weißglas, EVA-Kunststoff und Witterungsschutzfolie sowie eines eloxierten Aluminiumrahmens mit Entwässerungsbohrungen für den Langzeiteinsatz.

■Ausgang: Anschlusskabel mit wassergeschütztem Steckanschluss.

Qualität von Sharp

Der Qualitätsanspruch von Sharp Solar setzt Maßstäbe.

Ständige Kontrollen garantieren eine gleichbleibend hohe Qualität. Jedes Modul wird optisch, mechanisch und elektrisch geprüft.

Sie erkennen es am Original Sharp Label, der Seriennummer und der Sharp Garantie:

■5 Jahre Produktgarantie

■10 Jahre Leistungsgarantie auf eine Leistungsabgabe von 90 %

■25 Jahre Leistungsgarantie auf eine Leistungsabgabe von 80 %

Die detaillierten Garantiebedingungen sowie weiterführende Informationen erhalten Sie unter www.sharp.eu.

■Zur Gewährung der Produktund Leistungsgarantie müssen die Module durch den Endkunden bei Sharp registriert werden.

Die Registrierungsunterlagen werden vom Installateur oder direkt von Sharp ausgehändigt.

Deutschland: INFO-HOTLINE Mo.–Fr. von 8–20 Uhr 01805 / 01 52 22 | INFO-FAX 01805 / 38 32 38 (0,14 € / Min. aus dem deutschen Festnetz, max. 0,42 € / Min. aus dem deutschen Mobilfunknetz) Österreich: INFO-HOTLINE Mo.–Fr. von 8–20 Uhr 0820 / 40 06 40 (0,145 € / Min.) | INFO-FAX 0820 / 24 62 59 (0,145 € / Min. aus dem Festnetz Österreichs, Anrufe aus dem Mobilfunknetz ggf. teurer)