Sharp AN-PH20EZ, AN-PH40EZ, AN-PH30EZ, AN-PH10EX, AN-PH50EZ User Manual

Installation Manual

AN-PH10EX

AN-PH20EZ

AN-PH30EZ

AN-PH40EZ

AN-PH50EZ

AN-PH60EZ

WARNING: This installation manual is for use by service personnel. Please be aware that the manufacturer cannot be responsible for breakage or damage incurred due to improper installation of this lens or use of the projector.

When replacing the lens, please have the lens replaced by the store of purchase or a Sharp Engineering certified service workshop. The inside of the projector contains highvoltage parts that can be extremely dangerous. Never attempt to replace the lens by yourself.

Always make sure to turn off the main power and unplug the power cord before replacing the lens.

Be careful not to allow any screws to drop inside the projector while working. This can cause a fire, electrical shock or malfunction.

Do not attempt to replace the lens while the projector is suspended from the ceiling. The lens may fall out of the projector resulting in injury.

Before replacing the lens, return the lens shift to the position shown below. (The lens shift is adjusted to the position shown below when shipped from the factory.)

•V (vertical) shift: Uppermost position

•H (horizontal) shift: Middle position

When replacing the lens, use a commercially available screwdriver that satisfies all of the conditions indicated below.

•Type 2 Philips head screwdriver

•Length of protruding section: min. 180 mm (10")

•Magnetized

1	2
Loosen the lamp replacement	Remove the mounting screws of
screw (1) that fastens the lamp	the top cover.
unit cover, and remove the lamp
unit cover by sliding in the direc-

tion shown by the arrow (2).

		Lamp replacement	Top cover
	Lamp unit cover	screw
		2
		1
			Mounting screws

3	4	5	6
Unplug the cable connector (1)	Release the tabs while pulling up	(When the lens being removed is the AN-	Unplug the cable connector.
and remove the top cover (2).	on the lens cover, and then pull	PH30EZ (XG-PH50X standard lens))
		Remove the lens ring by turning
	it out towards you.
		in the direction shown by the ar-
		row.

1	Cable	2	Cable connector
	connector
			Tabs

Lens cover