Sepura SER8010 Users Manual

Installation and Operation Guide

DMR Repeater

For SBR8000 / SCR8000 / SER8000

General

This guide contains the installation and basic operating
instructions for the DMR Repeater models SBR8000, SCR8000
and SER8000. This guide does not contain information relating
to the installation of accessories such as the antenna and
duplexer. Refer to the installation instructions supplied with
these accessories for further safety and installation instructions.

Disclaimer notice

Sepura’s policy is to continually improve its products. The

features and facilities described in this document were correct at
publication, but are subject to change without notice.

Contact Us

Sepura plc.
Radio House,
St Andrew’s Road,
Cambridge CB4 1GR
United Kingdom
Tel: [phone]
Fax: [phone]

© Sepura plc. 2014

SPR-DOC-03800/2

Original Instructions: ENGLISH

All rights reserved. This document is intended for the use of Sepura plc’s customers

and/or other parties only for the purposes of the agreement or arrangement under
which this document is submitted, and no part of it may be reproduced or transmitted
in any form or means without the prior written permission of Sepura plc.

Contents

Safety ................................................................................................. 2

Regulatory ........................................................................................ 3

Repeater technical specifications .................................................. 4

Duplexer technical specifications ................................................. 5

Controls, connectors and components ......................................... 7

Status indicators .............................................................................. 7

Unpacking ........................................................................................ 8

Accessory information .................................................................... 8

Installation ....................................................................................... 8

Connections .................................................................................... 10

Basic operation ............................................................................... 11

Configuring the Repeater ............................................................ 12

Caring for your product ................................................................ 12

Installation and Operation Guide 1

Safety

Read these safety instructions carefully.

Attention!

Sepura products are intended for use in occupational/controlled
conditions.

It is the responsibility of the person operating the product to
ensure that it is operated safely at all times, and that local laws
and regulations governing the usage of Radio Frequency (RF)
products are observed. Obey all signs and instructions relating
to the usage to RF wireless devices.

It is recommended that you obtain training on how to safely
operate this product. Your personal safety could be affected if
you do not understand how to operate this product correctly.

This product must not be operated in environments that exceed
those listed in the product technical datasheet and in the
Regulatory section of the product user guide.

Unauthorised modifications to the product could cause the
product to become non-operational. Always use Sepura
approved antenna, battery and accessories with this product.

Exposure to RF energy

Sepura designs and manufactures products to meet strict
guidelines and international standards relating to Radio
Frequency (RF) energy and the potential health risks associated
with using such products. If you have any concerns about
potential health risks associated with long term exposure to RF
energy, you should obtain advice from your employer.

RF energy interference with electronic equipment

Some personal medical devices, such as hearing aids and
pacemakers, can be affected by RF energy. Always consult your
service provider or the manufacturer of the medical device
before using RF wireless devices.

Important safety notes about the Antenna

NEVER touch the antenna when the repeater is transmitting,
this may cause a minor burn to the skin and may affect the
operational range of the antenna.

NEVER use your repeater without an antenna attached.
Transmitting without an antenna may damage the product.
Only use a Sepura approved antenna with your repeater.

The antenna must be installed and operated with a minimum
distance of 1.2m to any person. This distance has been calculated
based on a 2dB cable loss between radio and antenna.

Accessories

Sepura products have been tested to meet strict guidelines for
personal safety and operational conditions. Only accessories
approved by Sepura are recommended for use with this
product. Always read the instructions supplied with the
accessory for additional safety instructions.

The use of non-approved accessories may invalidate any
product warranty. If a non-approved accessory is fitted, it may
compromise the product safety ratings.

Safe installation

CAUTION! This product has double pole/neutral fusing.

2 DMR Repeater SBR8000, SCR8000, SER8000

Servicing

Do not attempt to dismantle this product. Servicing and repairs
to this product must be performed by trained service technicians
at Sepura approved service centres

Regulatory

Sepura declares that this product is complaint
with the essential requirements and other
relevant provisions of the European R&TTE

directive 1999/5/EC relating to radio and
telecommunications terminal equipment and the mutual
recognition of their conformity. This product is also compliant
with directive 2011/65/EU having been designed and
manufactured to the RoHS requirements.

Waste Electrical and Electronic Equipment
recycling

This symbol on the product or its packaging indicates
that this product must not be disposed of as
household or commercial waste. Some countries have
set up collection and recycling systems for waste

electrical and electronic products. By ensuring that
this product and its packaging is disposed of correctly, you will
help prevent potentially negative consequences for the
environment and human health, and help conserve natural
resources. Please dispose of your waste product according to
your national and local regulations. Contact your service
provider or Sepura for information about disposing of this
product in your region of the world.

US and Canadian Markets

FCC radiation exposure statement

This radio is intended for use in occupational/controlled
applications where users have been made aware of the potential
for exposure and can exercise control over their exposure. This
radio device is NOT authorized for general population,
consumer or similar use. The antenna should be installed and
operated with a minimum distance of 1.2m to any person.

This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.

IC RSS warning

The term “IC:” before the certification/registration number only

signifies that the Industry Canada technical specifications were
met.

Le terme "IC:" devant le numéro de certification / enregistrement
signifie seulement que les spécifications techniques d'Industrie
Canada ont été respectées.

Nominal antenna port impedance / Impédance nominale

antenne Port ................................................................................ 50 Ω

Nominal Ethernet port impedance / Impédance nominale

Ethernet port ............................................................................. 100 Ω

Ethernet port type / Type d’Ethernet port ..................... 100 Base T

IC radiation exposure statement

This radio is intended for use in occupational/controlled
applications where users have been made aware of the potential
for exposure and can exercise control over their exposure. This
radio device is NOT authorized for general population,
consumer or similar use.. This transmitter must not be co-

Installation and Operation Guide 3