Sanyo LNS-W02, LNS-T02, LNS-T02K, LNS-W02K User Manual

0 (0)

LCD PROJECTOR LENS

MODEL NO. LNS-W02/T02

LNS-W02K/T02K Series

LENS REPLACEMENT AND

INSTALLATION PROCEDURE

NOTES ON LENS INSTALLATION

Lens installation should be performed by the qualified service personnel.

It should be followed by this procedure precisely.

Before attempt to install the lens, confirm the model number (both the LCD projector and the lens) and use the proper lens.

If you have any questions, contact to the dealers.

PARTS LIST

Following parts are contained in the packing.

· LENS

1 piece

· LENS MOUNTING SCREWS

6 screws (2 for spare)

· DRIVER

1 piece

· LIGHT-BLOCK SHEET

1 sheet

· LENS COVER (UPPER · LOWER )1 set

Following checks and confirmations should be taken for safety.

Check the following things by the time of the cabinet assembly after the lens installation.

1.Confirm the lens is securely fixed by 4 screws.

2.Wiring must not be tangled in the gear of the lens motor or the other mechanical part.

3.There is no missing part, or no loosing mounting part.

1AA6P1P2289-- (ICSC)

Sanyo LNS-W02, LNS-T02, LNS-T02K, LNS-W02K User Manual

LENS REPLACEMENT AND INSTALLATION PROCEDURE

Perform the steps 1 to 5 for lens replacement and installation.

First, set the lens at the center position with lens shift button.

1 REMOVE THE LENS COVER.

First check the shape of cabinet.

In case figure-1 cabinet.

1.Remove screws A (2 screws).

2.Pull down the lower lens cover while pushing the part D, then remove it.

3.Remove screws B (2 screws).

4.Remove screws C (2 screws) and remove upper lens cover.

UPPER LENS COVER

 

C

B

D

Fig-1

A

LOWER LENS COVER

LENS COVER

In case figure-2 cabinet.

Remove 4 screws of the lens cover and remove the lens cover.

2

● IN CASE OF MODEL WITHOUT LENS

REMOVE THE COVER PLATE OF THE LENS

Remove 2 screws and pull down the plate.

(At the step 5 , insert the light-block sheet in the position as the removed cover plate has been placed Two screws are not used.)

Use the light-block sheet included with lens.

Set the light-block sheet, so that the large rounder side is set over the lens.

Fig-2

LIGHT-BLOCK SHEET

Loading...
+ 2 hidden pages