INSTRUCTION MANUAL
Colour Television
CA14SE1M
CP14SE1M
CA14SE1K
CP14SE1K
CA14SE1(V)
CP14SE1(V)
CA21CF1(V)
CP21CF1(V)
CA21CF1M
CP21CF1M
CA21SE1M
CP21SE1M
CA21SE1K
CP21SE1K
CA21SE1(V)
CP21SE1(V)
CA21VF1
CP21VF1
CA21VF1K
CP21VF1K
Multi System CATV Hyper Band
256 Programmes with Automatic Tuning
Warnings and Cautions
Warning
High voltages are used in the operation of this television receiver. Do not remove the cabinet back from your set. Refer servicing to qualified service personnel.
Do not drop or push objects into the television cabinet slots or openings. Never spill any kind of liquid on the television receiver.
To prevent fire or electrical shock hazard, do not expose the television receiver to rain or moisture. The television shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the television.
Caution
Never stand on, lean on or push sud-
denly the television or its stand.
You should pay special attention to children. Serious injury may result if it should fall.
Do not place your television on an unstable cart, stand, shelf or table. Serious injury to an individual, and damage to the television, may result if it should fall.
At installation of the unit, the plug of power cord shall remain accessible and readily operable to disconnect the unit from the
wall outlet.
When the television receiver is not used for an extended period of time, it is advisable to disconnect the AC power cord from the
AC outlet.
Avoid exposing the television receiver to direct sunlight and
other source of the heat.
Do not stand the television
receiver directly on other products which give off heat. E.g. video cassette players, audio amplifiers.
Do not block the ventilation holes in the back cover.
Adequate ventilation is essential to prevent failure of electrical components.
Do not squash power supply cord under the television receiver.
Minimum distances
10cm |
10cm |
5cm |
|
|
20cm |
If the |
televi- |
|||
sion |
is |
to |
be |
||
|
|||||
|
built |
into |
a |
||
|
compartment |
||||
|
or |
similarly |
|||
|
enclosed, |
the |
|||
|
minimum |
dis- |
|||
|
tances |
must |
|||
|
be maintained. |
Heat build-up can reduce the service life of your television, and can also be dangerous.
2
Contents |
Plug & Play |
Warnings and Cautions . . . . . . . . . . . . . . 2
Contents . . . . . . . . . . . . . . . . . . . . . . . . . 3 Plug & Play . . . . . . . . . . . . . . . . . . . . . . . 3 Front Control . . . . . . . . . . . . . . . . . . . . . 4-5
Remote Control Transmitter . . . . . . . . . . 6
Battery Installation of
the Remote Control Transmitter . . . . . . . 6
General Operation
Remote Control Operation . . . . . . . . . 7
OFF TIMER . . . . . . . . . . . . . . . . . . . . 8 ON TIMER . . . . . . . . . . . . . . . . . . . . . 8
Colour and Sound System
Setting of the Colour System . . . . . . . 8 Setting of the Sound system . . . . . . . . 8-9
Picture Adjustment . . . . . . . . . . . . . . . . . 9-10
Audio Adjustment . . . . . . . . . . . . . . . . . . 10
Tuning of the Channels
Automatic Tuning . . . . . . . . . . . . . . . 11 Semi-Auto Tuning and Manual Tuning. . 11 Channel Copy . . . . . . . . . . . . . . . . . . 12
Channel Swapping . . . . . . . . . . . . . . 12
Skip Channel Set and Cancel . . . . . . . . . . .12-13
Setting of the Private Position . . . . . . . . 13 Setting of the OSD Language . . . . . . . . . 14 Connecting Other Equipment . . . . . . . . . 14
Connecting to the Rear AV1 Input
Jacks . . . . . . . . . . . . . . . . . . . . . . . . . . .14-15
Selecting the Colour System in AV Mode . . . . . . . . . . . . . . . . . . . . . . . .15
Connecting to a DVD Player with AV1(DVD) Video Component output terminal . . .15 Connection to the Front AV2 Input
Jacks . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 Connecting to the Monitor Output
Jacks . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 AV Connection to the Aerial Socket . . . . 16 Aerial Connection . . . . . . . . . . . . . . . . . . 17
Care and Cleaning . . . . . . . . . . . . . . . . . . 17 Specifications . . . . . . . . . . . . . . . . . . . . . 18
Helpful
Hints-Problems/Solutions . . . . . . . . . . . 19
Automatic setting up channels
This TV set provides a self-automatic tuning and sorting system function called “Plug & Play”. It automatically begins searching and storing of all available channels when switching-on the TV set for the first time.
Let’s start !
1 Connect power cord of the TV set to a wall outlet, and turn on the TV set by pressing the Mains ON/OFF button. Self-automatic tuning system will be started as follows;
I AM SEARCHING. |
AUTO SET-UP |
|
ALL PROGRAMMES. |
||
COMPLETED. |
||
PLEASE WAIT. |
||
HAPPY VIEWING ! |
||
|
1
After completing this procedure, the programme position 1 is selected and the ending messages on the screen.
Note: The Plug & Play can be cancelled at any time by pressing the MENU button.
2 Press any of the control buttons to make the ending message disappear. Or will automatically return to normal TV display after 10 seconds.
This procedure only appears at the first switch-on time.
If no TV stations are found, the display shown below will appear. Please check if the antenna is connected properly.
NO STATION.
PLEASE CONNECT
ANTENNA PLUG.
If it isn’t connected properly, connect antenna and Automatic Tuning will be reset.
3
Front Control |
Each button listed in this section has the same function as it’s corre- |
sponding button on the remote control. |
|
|
|
Model CA14SE1(V), CP14SE1(V), CA21SE1(V), CP21SE1(V), CA21VF1, CP21VF1,
CA21VF1K, CP21VF1K
Remote Control Detector
VIDEO |
L- |
AUDIO-R |
TV/AV |
MENU |
- |
|
|
|
|
|
Video Input Jack (AV2) |
|
Audio Input Jack-Left (AV2) |
MENU |
+ CH
POWER
Mains ON/OFF Button
Audio Input Jack-Right (AV2) |
Stand-by and Power Indicator |
TV/AV Selector |
Programme UP/DOWN |
|
VOLUME |
Model CA21CF1(V), CP21CF1(V)
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Video Input Jack (AV2) |
|
|
|
|
|
|
|
|
|
|
|
|
|
Mains ON/OFF Button |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Audio Input Jack-Left (AV2) |
|
|
|
|
|
|
|
|
|
|
Remote Control Detector |
||||
|
|
|
|
|
|
|
|
|
|
|
|
Stand-by and Power Indicator |
|||
Audio Input Jack-Right (AV2) |
MENU |
|
|
|
|
|
|||||||||
|
|
|
|
Programme UP/DOWN |
|||||||||||
|
|
|
|
|
|
|
|
|
|
|
|||||
|
TV/AV Selector |
|
|
|
|
||||||||||
|
VOLUME |
||||||||||||||
|
|
|
|
|
|
|
4
Front Control |
Each button listed in this section has the same function as it’s corre- |
sponding button on the remote control. |
|
|
|
Monaural Model
Model CA14SE1M, CP14SE1M, CA14SE1K, CP14SE1K, CA21SE1M, CP21SE1M,
CA21SE1K, CP21SE1K
Remote Control Detector
VIDEO |
AUDIO |
Video Input Jack (AV2)
Audio Input Jack (AV2)
TV/AV |
MENU |
- |
+ |
|
|
|
|
CH |
|
|
|
|
|
POWER |
MENU |
Mains ON/OFF Button |
|
|
Stand-by and Power Indicator |
TV/AV Selector |
Programme UP/DOWN |
|
VOLUME |
Model CA21CF1M, CP21CF1M
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Video Input Jack (AV2) |
|
|
|
|
|
|
|
|
|
|
|
Mains ON/OFF Button |
|||
Audio Input Jack (AV2) |
|
|
|
|
|
|
|
|
|
Remote Control Detector |
|||||
|
|
|
|
|
|
|
|
|
|
|
Stand-by and Power Indicator |
||||
|
|
|
MENU |
|
|
|
|
|
|||||||
|
|
|
|
|
|
|
Programme UP/DOWN |
||||||||
|
|
|
|
|
|
|
|
|
|
||||||
TV/AV Selector |
|
|
|
|
|||||||||||
VOLUME |
|||||||||||||||
|
|
|
|
|
|
5
Remote Control Transmitter
TV / AV
TV / AV Selector button
RECALL/COLOUR SYSTEM button
Programme Selector button
-/- -
DIGIT button
SWAP
SWAP button
VOLUME - button
STEREO/MONO button (This button is not used)
A•B
Programme DOWN button
BASS
* BASS EXPANDER button
* SOUND MODE button
* For monaural models this button is not used.
TIMER button
Power ON/OFF button
TIMER
MUTE button
|
P P |
|
|
|
|
ALTERNATE button |
|
CH |
CH SCAN |
Programme UP button |
|
CHANNEL SCAN button |
|||
|
|
||
MENU |
VOLUME + button |
||
|
|||
|
|
PICTURE MODE button |
|
CH |
PICTURE |
MENU button |
|
SOUND |
S. SYS |
SURROUND
* SURROUND button
SOUND SYSTEM button
JXPSC
Battery Installation of the Remote Control Transmitter
1.Open the battery cover.
2.Install two “AA” 1.5 volt batteries so that the “+” and “-” marks on the batteries match the “+” and “ - ” marks inside the unit.
3.Close the battery cover.
Note: Replace the batteries when the TV set is showing the following symptoms:
Operation is unsteady or erratic, sometimes the TV set does not work with transmitter. Discharged batteries may leak and damage the unit. The normal life of batteries should be from nine to ten months.
6