RVS Systems RVS-619NQ User Manual

4 (2)
RVS Systems RVS-619NQ User Manual

Table of Contents

 

Introduction ...................................................................................................

3

Safety Information ..................................................................................

4-6

Before Beginning Installation...................................................................

7

Installation Guide.........................................................................................

8

Wiring Camera & Monitor...................................................................

9-10

Replacement Installation Diagram........................................................

11

Clip-On Installation Diagram .................................................................

12

Installing The Monitor..............................................................................

13

Monitor Operation ...................................................................................

14

Splitting & Splicing ...................................................................................

15

Positioning ...................................................................................................

16

PowerHarness ............................................................................................

17

Monitor Dimensions..................................................................................

18

Monitor Specifications.............................................................................

19

Troubleshooting..........................................................................................

20

Warranty.......................................................................................................

21

Disclaimer ....................................................................................................

22

Introduction

Please read all of the installation instructions carefully before installing the product. Improper installation will void manufacturer’s warranty.

Congratulations on purchasing a Rear View Backup Camera System! With this manual you will be able to properly install and operate the unit.

The Backup Camera System is intended to be installed as a supplement aid to your standard rear view mirror that already exists in your vehicle. The Backup Camera System should not be used as a substitute for the standard rear view mirror or for any other mirror that exists in your vehicle.

In some jurisdictions, it is unlawful for a person to drive a motor vehicle equipped with a TV viewer or screen located forward of the back of the driver’s seat or in any location that is visible, directly or indirectly, to the driver while operating the vehicle.

3

Safety Information

 

Please read the entire manual and follow the instructions and

warnings carefully. Failure to do so can cause serious damage

and/or injury, including loss of life. Be sure to obey all applica-

ble local traffic and motor vehicle regulations as it pertains to

this product. Improper installation will void manufacturer’s

warranty.

 

 

 

USAGE

Camera System. If you back

The Rear View Camera System

up while looking only at the

monitor, you may cause

is designed to help the driver

damage or injury. Always

safely detect people and/or

back up slowly.

objects helping to avoid

 

damage or injury. However,

The Rear View Camera Sys-

you the driver, must use it

tem is not intended for use

properly. Use of this system is

during exstensive back-up

not a substitute for safe,

maneuvers or backing into

proper or legal driving.

cross traffic or pedestrian

Never back up while looking

walkways.

 

at the monitor alone. You

Please, always remember,

should always check behind

the area displayed by the

and around the vehicle when

Rear View Camera System is

backing up, in the same way

limited. It does not display

as you would if the vehicle

the entire panorama that is

did not have the Rear View

behind you.

INSTALLATION

Electric shock or product malfunction may occur if this product is installed incorrectly.

Use this product within the voltage range specified. Failure to do so can cause electronic shock or product malfunction.

Take special care when cleaning the monitor.

Make sure to firmly affix the product before use.

If smoke or a burning smell is detected, disconnect the system immediately.

Where the power cable may touch a metal case, cover the cable with a friction tape. A short circuit or disconnected wire may cause a fire.

Safety Information

While installing the R

View Safewithy System bear careful the wire positioning in order to avoid wire damage.

The Rear View Safety System should only be used when the vehicle is in reverse.

Do not watch movies or operate the monitor while driving; as it may cause an accident.

Do not install the monitor where it may obstruct drivers view or obstruct an air bag device.

Dropping the unit may cause possible mechanical failure.

4

REAR VIEW SAFETY

Reverse With Confidence

5

Safety Information

If you have questions about this product, contact: Customer Service:

Rear View Safety

1797 Atlantic Avenue

Brooklyn, NY 11233

Tel: 1.800.764.1028

IN NO EVENT SHALL SELLER OR MANUFACTURER BE LIABLE FOR ANY DIRECT OR CONSEQUENTIAL DAMAGES OF ANY NATURE, OR LOSSES OR EXPENSES RESULTING FROM ANY DEFECTIVE PRODUCT OR THE USE OF ANY PRODUCT.

Before You Begin Installation

Before drilling please check that no cable or wiring is on the other side of the wall. Please clamp all wires securely to reduce the possibility of them being damaged while vehicle is in use. Keep all cables away from hot or moving parts and electrical noisy components.

We recommend doing a benchmark test before installation to insure that all components are working properly.

Step 1: Choose the monitor and camera locations.

Step 2: Install all cables in vehicle, when necessary a 0.8 (20mm) hole should be drilled for passing camera cable through vehicles walls. Install split grommets where applicable.

Step 3: Once all cables and wiring have been properly routed, perform a system function test by temporarily connecting the system. If the system seems to not be operating properly see troubleshooting (page 20).

6

REAR VIEW SAFETY

Reverse With Confidence

7

Loading...
+ 9 hidden pages