S-BP (Blank Panel) Installation Manual
This guide describes how to install S-BP (Blank Panel) in your S-4000S. Before you attempt installation, please read this document carefully.
© 2006 Roland Corporation
All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION.
For the Purchaser — Please Read
When installing or detaching the S-BP, be sure to consult your RSS Authorized Service Center.
For the Installer (Service Technician)
— Please Read
After installing the S-BP, please be sure to return this document to the purchaser.
Cautions When Installing the S-BP
• Always turn the unit off and unplug the AC plug before attempting installation of the S-BP.
• Remove only the specified screws.
•When the S-BP installation is complete, double-check your work.
•Use a Philips screwdriver of the appropriate size to avoid damaging the screw heads (a number of 2 screwdriver).
• Turn the screwdriver counter-clockwise to loosen |
loosen |
tighten |
|
the screws-turn it clockwise to tighten them. |
|||
|
|
||
• Be careful not to let the screws drop inside the each |
|
|
|
unit. |
|
|
•Never leave a module uninstalled. Cover any unused slots with S-BP blank panels.
•Be careful not to cut your hand on the edge of the circuit board or the opening edge wile removing the S-BP.