Roland OP R09C Service Manual

0 (0)
Roland OP R09C Service Manual

 

 

Before using this unit, carefully read the sections entitled: “USING THE UNIT SAFELY” and “IMPORTANT

 

 

 

NOTES.” These sections provide important information concerning the proper operation of the unit. Additionally,

 

 

 

in order to feel assured that you have gained a good grasp of every feature provided by your new unit, Owner’s

 

 

 

manual should be read in its entirety. The manual should be saved and kept on hand as a convenient reference.

 

 

Cover Stand Set for

 

OP-R09C OWNER’S MANUAL

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Attaching the Cover

 

 

 

 

 

 

 

 

 

When Attaching to a Belt

 

 

 

 

 

 

 

 

 

 

 

 

Insert the R-09.

 

Fasten the snaps to

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

close the flap.

 

 

 

 

 

 

 

 

 

 

Fasten snap

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

When Attaching to a Carrying Strap

Lash strap to metal ring

Attaching the Tripod

Completely

Attach the

Tighten

extend the

tripod to

the screw.

tripod legs.

the threaded

 

 

hole in the

 

 

 

 

 

 

rear of the

 

 

cover.

 

Grasp the R-09 with your fingers when pressing the R-09s buttons.

Spread out

Loosen the

the tripod

lever, adjust

legs to

the angle of

their fullest.

the R-09,

 

then lock

 

the lever

 

again.

Attaching the Mic Stand Adapter (Optional OP-R09M)

Tighten all of the

Attach the adapter

Rotate the (optional)

Loosen the screw as

OP-R09M (optional)

to the threaded hole

mic stand until it is

shown, adjust the angle

sections to align

in the rear of the cover.

completely tightened.

of the R-09, then tighten

the entire unit.

 

 

 

 

the screw again.

 

 

 

 

 

 

 

 

 

 

 

 

 

* Use the adapter as required

 

 

 

to match the diameter of the

 

 

 

 

 

 

mic stand’s screw.

 

 

 

 

 

 

 

Copyright ©2006 ROLAND CORPORATION

 

 

 

 

 

 

All rights reserved. No part of this publication may be reproduced in any

 

 

OP-R09C

form without the written permission of ROLAND CORPORATION.

 

 

Used for instructions intended to alert the user to the risk of death or severe injury should the unit be used improperly.

Used for instructions intended to alert the user to the risk of injury or material damage should the unit be used improperly.

* Material damage refers to damage or other adverse effects caused with respect to the home and all its furnishings, as well to domestic animals or pets.

Before using this unit, make sure to read the instructions below, and the Owner’s Manual.

..........................................................................................................

Do not open or perform any internal modifications on

the unit.

..........................................................................................................

Do not attempt to repair the unit, or replace parts within it (except when this manual provides specific instructions directing you to do so). Refer all servicing to your retailer, the nearest Roland Service Center, or an authorized Roland distributor.

..........................................................................................................

In households with small children, an adult should provide supervision until the child is capable of following all the rules essential for the safe operation of the unit.

..........................................................................................................

Protect the product from strong impact. (Do not drop it!)

Try to prevent cords and cables from becoming entangled. In addition, to prevent the equipment from toppling and falling, arrange cords and cables so they

do not become pulled or snagged. Also, all cords and cables should be placed so they are out of the reach of children.

..........................................................................................................

Keep the adapter screw included with the optional special mic stand adapter in a safe place out of children’s reach to prevent accidental ingestion.

..........................................................................................................

IMPORTANT NOTES

Be sure the tripod is spread out adequately. This allows the tripod to stand with greater stability.

Use the setup in a flat, level location.

Use the setup only after confirming the stability of all attached devices. Avoid use in locations where wind or other conditions may cause the equipment to topple and fall.

The symbol alerts the user to important instructions or warnings.The specific meaning of the symbol is determined by the design contained within the triangle. In the case of the symbol at left, it is used for general cautions, warnings, or alerts to danger.

The symbol alerts the user to items that must never be carried out (are forbidden). The specific thing that must not be done is indicated by the design contained within the circle. In the case of the symbol at left, it means that the unit must never be disassembled.

The symbol alerts the user to things that must be carried out. The specific thing that must be done is indicated by the design contained within the circle. In the case of the symbol at left, it means that the powercord plug must be unplugged from the outlet.

Always detach the device from the tripod before moving it. Carrying the device while it is still attached to the tripod may cause the device to separate from the tripod and fall.

Do not leave the device attached to the tripod. The topple and fall, resulting in unanticipated damage to the unit.

Take care not to allow fingers to become pinched when extending and retracting the tripod legs.

*Roland assumes no liability whatsoever for any damages, loss of income, or claims by any third party arising from the inappropriate use of this product.

*Roland assumes no liability whatsoever for any damage to the device resulting from the unit dropping or falling.

Placement

Do not expose the unit to direct sunlight, place it near devices that radiate heat, leave it inside an enclosed vehicle, or otherwise subject it to temperature extremes. Excessive heat can deform or discolor the unit.

Maintenance

For everyday cleaning wipe the unit with a soft, dry cloth or one that has been slightly dampened with water. To remove stubborn dirt, use a cloth impregnated with a mild, non-abrasive detergent. Afterwards, be sure to wipe the unit thoroughly with a soft, dry cloth. Do not launder or wash the entire case.

Never use benzine, thinners, alcohol or solvents of any kind, to avoid the possibility of discoloration and/or deformation.

Specifications

Tripod (two-stage extending/retracting type)

Retracted length: 98 mm

Overall height in use: Approx. 90 mm

Weight: 35 g

Max. Load: 1000 g (vertical load)

*In the interest of unit improvement, the specifications and/or appearance of this unit are subject to change without prior notice.

Loading...