Roland M 512G Service Manual

0 (0)
Roland M 512G Service Manual

Use only in the products which M-512E is designated.

This card can also be used which instruments with use M-256E, M-256D or M-128D. (However, the amount of data that can be saved onto this card will be the same as when using a card originally specified for the instrument.)

INSTRUCTIONS

Copyright © 2002 ROLAND CORPORATION

All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION.

Before using this card, make sure to read the instructions below.

NOTES

Never touch terminals. Also, avoid getting terminals dirty.

Do not expose the card to direct sunlight, place it near devices that radiate heat, leave it inside an enclosed vehicle, or otherwise subject it to temperature extremes. Excessive heat can deform or discolor the card.

To avoid possible breakdown, do not use the card in a wet area, such as an area exposed to rain or other moisture.

To avoid the risk of damage to internal components that can be caused by static electricity, please carefully observe the following whenever you handle the card. •Before you touch the card, always first grasp a metal object (such as a water pipe), so you are sure that any static

electricity you might have been carrying has been discharged.

•Save the bag and the box in which the card was originally shipped, and put the card back into them whenever you need to store or transport it.

Be sure that you are holding the card with the face up, and insert it slowly until it is securely in place.

How to use the Memory Card is fully explained in the owner’s manual of each device.

Battery Replacement

When the display of your device using M- 512G indicates a message such as “MEMORY CARD Battery Low” or “DATA Card Battery Low,” the battery in M-512G card is nearly worn out. Please contact Roland Service Station for the battery replacement, referring to the owner’s manual of your device.

Be sure to load all the data from the M-512G onto your device before the battery replacement. The data stored in your M-512G card may be lost while replacing the battery.

Protect Switch

The Protect Switch is provided to prevent accidental erasure of data. Please be sure to keep it in the ON position except when writing new data.

*In the interest of product improvement, the specifications and/or appearance of this card are subject to change without prior notice.

として、M-512E

M-256E/M-256D/M- 128D

© 2002

 

● MEMORY CARD Battery

 

 

 

 

Low DATA Card Battery Low

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Loading...
+ 1 hidden pages