Roland 420321A User Manual

0 (0)

Owner’s Manual

Guitar Amplifier

KATANA-AIR

KATANA-AIR

3 inch x 2 speaker

Transmitter

For the U.K.

WARNING: THIS APPARATUS MUST BE EARTHED

IMPORTANT: THE WIRES IN THIS MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE.

GREEN-AND-YELLOW: EARTH, BLUE: NEUTRAL, BROWN: LIVE

As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the plug which is marked by the letter E or by the safety earth symbolor coloured GREEN or GREEN-AND-YELLOW.

The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.

For the USA

 

DECLARATION OF CONFORMITY

 

Compliance Information Statement

Model Name :

KTN-AIR

Type of Equipment :

Guitar Amplifier

Responsible Party :

Roland Corporation U.S.

Address :

5100 S. Eastern Avenue Los Angeles, CA 90040-2938

Telephone :

(323) 890-3700

For the USA

This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

(FCC Part15 Subpart C §15.247, 15.253, 15.255)

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment has very low levels of RF energy that are deemed to comply without testing of specific absorption ratio (SAR).

(FCC Part15 Subpart C §15.247, 15.253, 15.255)

For Canada

This device complies with Industry Canada licence-exempt RSSs. Operation is subject to the following two conditions:

(1)This device may not cause interference, and

(2)This device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :

1)l’appareil ne doit pas produire de brouillage;

2)l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

(RSS-Gen §8.4)

The available scientific evidence does not show that any health problems are associated with using low power wireless devices. There is no proof, however, that these low power wireless devices are absolutely safe. Low power Wireless devices emit low levels of radio frequency energy (RF) in the microwave range while being used. Whereas high levels of RF can produce health effects (by heating tissue), exposure of low-level RF that does not produce heating effects causes no known adverse health effects. Many studies of low-level RF exposures have not found any biological effects. Some studies have suggested that some biological effects might occur, but such findings have not been confirmed by additional research. WL-T has been tested and found to comply with IC radiation exposure limits set forth for an uncontrolled environment and meets RSS-102 of the IC radio frequency (RF) Exposure rules.

Les connaissances scientifiques dont nous disposons n’ont mis en évidence aucun problème de santé associé à l’usage des appareils sans fil à faible puissance. Nous ne sommes cependant pas en mesure de prouver que ces appareils sans fil à faible puissance sont entièrement sans danger. Les appareils sans fil à faible puissance émettent une énergie fréquence radioélectrique (RF) très faible dans le spectre des micro-ondes lorsqu’ils sont utilisés. Alors qu’une dose élevée de RF peut avoir des effets sur la santé (en chauffant les tissus), l’exposition à de faibles RF qui ne produisent pas de chaleur n’a pas de mauvais effets connus sur la santé. De nombreuses études ont été menées sur les expositions aux RF faibles et n’ont découvert aucun effet biologique. Certaines études ont suggéré qu’il pouvait y avoir certains effets biologiques, mais ces résultats n’ont pas été confirmés par des recherches supplémentaires. WL-T a été testé et jugé conforme aux limites d’exposition aux rayonnements IC énoncées pour un environnement non contrôlé et respecte les règles d’exposition aux fréquences radioélectriques (RF) CNR-102 de l’IC.

(RSS-102 §2.6)

KATANA-AIR

3 inch speaker x 2

Transmitter

Owner’s Manual

Guitar Amplifier

KATANA-AIR

An“all-wireless”guitar amp that supports wireless for guitar as well

The KATANA-AIR is a guitar amp that provides wireless connectivity for your guitar as well as Bluetooth and battery operation, making it an “all-wireless” guitar amp that lets you enjoy playing without connecting any cables to it.

Main Features

5 Wireless transmitter for guitar achieves low latency. Enjoy cable-free performance.

5 Four original amp types are provided: the edgy “brown” inherited from the BOSS Waza Head, as well as clean, crunch, and lead. Additionally provided is a dedicated acoustic amp that you can also use with an acoustic guitar.

5 Built-in BOSS effects are easy to operate and provide high quality (up to three can be used simultaneously).

If you connect the dedicated app via Bluetooth, you can select from a total of 58 different types of effect.

5 You can use headphones to enjoy sound that’s as powerful as though you were hearing it from a speaker.

5 Stereo audio streaming via Bluetooth is also supported.

5 Two-way power supply allows operation using either eight AA batteries or an AC adaptor. Standby/Wakeup-On function lets the batteries last even longer.

Before using this unit, carefully read “USING THE UNIT SAFELY” and “IMPORTANT NOTES” (the leaflet “USING THE UNIT SAFELY” and the Owner’s Manual (p. 11)). After reading, keep the document(s) where it will be available for immediate reference.

Copyright © 2018 ROLAND CORPORATION

Roland 420321A User Manual

Panel Descriptions

Top Panel

1 2

1AMPLIFIER

[AMP TYPE] knob

Selects the amp type. All provided amp types are original.

Type Explanation

BROWN

A lead sound with an edge inherited from the

BOSS WAZA brown sound.

LEAD

Different gain settings allow this sound to cover a wide range from crunch to high-gain.

CRUNCH

A fat crunch sound that faithfully responds to the nuances of your picking.

CLEAN

A clean and natural sound. In conjunction with

BST (BOOSTER), it can be used for solo or lead.

ACOUSTIC

A dedicated acoustic guitar amp that supports connection of an acoustic guitar.

[GAIN] knob

Adjusts the gain (amount of distortion).

[VOLUME] knob

Adjusts the volume.

2EQUALIZER

[BASS] knob

Adjusts the sound level of the low-frequency range.

[MIDDLE] knob

Adjusts the sound level of middle-frequency range.

[TREBLE] knob

Adjusts the sound level of the high-frequency range.

11

4 5 6 7 9

3

8

10

3EFFECTS

Here you can make settings for the built-in effects. For details on the effect types and settings for each knob, refer to “Using the Effects” (p. 6).

[BST/MOD] button/knob

Controls distortion-type effects and modulation effects.

[DELAY/FX] button/knob

Controls effects such as delay, wah, tremolo, and octave.

[TAP] button

Sets the delay time. When you press this button two or more times, the delay time is set to the interval between presses.

[REVERB] button/knob

Controls the reverb.

4[MASTER] knob

Adjusts the overall volume.

5[Bluetooth] button/indicator

Registers a Bluetooth Device (p. 8). And indicates the Bluetooth connection status.

Indicator

Explanation

 

 

Lit

Connected

Blinking

Pairing mode

Unlit

Not connected

6[L] (POWER) button/indicator

Turn the power on/off. This also indicates the state of the power supply.

Indicator

Explanation

 

 

 

On

Lit green

To enter standby mode, long-press the

[L] button.

 

To turn the unit off, enter standby mode

 

and then long-press the [L] button.

 

Standby mode

Lit orange

To turn the unit on, press the [L] button.

To turn the unit off, long-press the [L]

 

 

button.

Unlit

Off

2

Loading...
+ 8 hidden pages