Ridetech 12103699 User Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax [phone]

www.ridetech.com

Part # 12103699

67-70 Mustang Upper StrongArms

For Use w/ Shockwaves or CoilOvers

Components:

2 90000115 Upper StrongArm
2 90000930 Upper ball joint
2 90000931 Billet Aluminum drop cross shaft
4 90001589 Heim ends – ¾”-16 thread x 5/8” I.D.
2 90000113 Alignment shim

Hardware:

4 99621002 5/8”-18 x 1 ¾” Gr.8 bolt Rod end to cross shaft
4 99623001 5/8” SAE Gr. 8 Flat washer Rod end to cross shaft
4 99623002 5/8” Gr. 8 Lock washer Rod end to cross shaft
4 99501003 ½”-13 x 2 ½” Gr.5 bolt Cross shaft to body
4 99502006 ½”-13 nut Cross shaft to body
8 99503001 ½” SAE flat washer Cross shaft to body
4 99503002 ½” lock washer Cross shaft to body
2 99501026 ½”-13 x 2 ¼” Gr.5 bolt Shockwave/CoilOver to upper arm
2 99502001 ½”-13 Nylok nut Shockwave/CoilOver to upper arm
4 99752004 ¾”-16 jam nut Heim ends

1. Bolt the upper StrongArm to the

body using ½” x 2 ½” bolts, flat

washers and lock washers. A shim is
supplied and may need to be installed
between the body and the arms to
achieve proper alignment.

2. The arms are preset at the factory
so the alignment should be close, but
the vehicle must be aligned before
driving.

Note: The upper arm mounting holes
on many cars have been redrilled 1”
lower. This is done to improve the
handling. Our cross shaft has the
drop built into it, make sure to use the

factory mounting holes.

3. Bolt the upper arm to the spindle
using the hardware and cotter pin
supplied.

4. Attach the Shockwave to the upper

StrongArm using a ½” x 2 ¼” bolt and

Nylok nut.

5. This control arm is designed to
work with our MuscleBar sway bar.
The end link will attach to the rear
mounting tab on the upper arm.

Item #

Description

Qty.

1.

Control arm

1

2.

Heim ends – ¾”-16 thread x 5/8” I.D.

2

3.

Alignment shim

1

4.

Cross shaft

1

5.

Ball joint

1

6.

½”-13 x 2 ½” Gr.5 bolt

2

7.

½” SAE flat washer

4

8.

½” lock washer

2

9.

½”-13 nut

2

10.

½”-13 x 2 ¼” Gr.5 bolt

1

11.

½”-13 Nylok nut

1

12.

5/8”-18 x 1 ¾” Gr.8 bolt

2

13.

5/8” lock washer

2

14.

5/8” flat washer

2