350 S. St. Charles St. Jasper, In. 47546
Ph. 812.482.2932 Fax 812.634.6632
www.ridetech.com
Part # 12060600
61-69 Lincoln Front Black Series Shock Kit
For Use w/ CoolRide and Lower StrongArms
Components:
2 20000011 Shock absorber
2 90001619 Shock stud
2 90000471 Aluminum shock spacer
1 90000692 Driver side upper shock mount
1 90000693 Passenger side upper shock mount
Hardware:
8 99373007 3/8” x 1” self-tapping bolt Upper shock mount
1. Bolt the upper shock mount to the
subframe using four 3/8” x 1” self
tapping bolts. The bracket will locate
off of the factory bolt shown in the
picture. Drill the holes with a 5/16” bit.
2. The inner fender well must be
trimmed to allow clearance for the
shock mount. Be careful not to cut
anything inside engine bay.
3. Remove the factory brake line
bracket.
This picture is of the passenger
side.
4. Bolt the top of the shock to the
upper mount using the bushings and
hardware supplied.
5. Install the round head shock bolt
through the lower shock eye. Then
install the aluminum spacer with the
step facing the arm. Slide the bolt
through the arm and fasten with the
nut supplied.
This picture is of the driver side.
6. Install the new brake line bracket
with using the factory bolts and clip.
Loading...