Ridetech 11069000 User Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax [phone]

www.ridetech.com

Part # 11069000

59-64 Chevy Impala Panhard Bar Kit

Components:

1 90000993 Panhard bar
1 90001942 Rubber bushing – pressed into panhard bar
1 90001946 Panhard Kevlar lined Heim end – 3/4" I.D.
2 90000460 Aluminum T bushing – for heim end
1 90001946 Panhard bar rod end
1 90000461 Panhard bar stud

Hardware:

2 99603003 5/8” USS flat washer Panhard bar stud
1 99563001 9/16” USS flat washer Panhard bar stud
1 99561001 9/16” x 2 ½” SAE Gr.8 bolt Panhard bar to frame
2 99562001 9/16” SAE Nylok nut Panhard bar
1 99752004 3/4"-16 Jam nut Heim ends
1 99622006 5/8” SAE Nylok jam nut Pan hard bar stud

1. Install the ¾” jam nut onto the end
of the Heim end, then screw Heim end
into the end of the panhard bar.

2. Press the aluminum T-bushings into
the Heim end. Fasten the Heim end to

the frame bracket using the 9/16” x 2

½” bolt and Nylok nut supplied.

3. Bolt the new panhard bar stud onto
the axle in factory stud location using

the 9/16” Nylok nut and flat washer

supplied.

4. Slide the rubber end of the panhard
bar onto the stud and secure with 5/8”
thin Nylok nut and flat washer.

Installation Instructions