FORM NO. G11-468 REV. 11
Supersedes Form No. G11-468 Rev. 10
GAS FURNACES
RGFDSERIES
Models with Input Rates
from 60,000 to 120,000 BTU/HR [17.58 to 35.16 kW]
(All Models 92% A.F.U.E.† or Above)
90 PLUS®
MODULATING UPFLOW GAS FURNACES
WITH CONTOUR COMFORT CONTROL®
The Rheem Prestige Series® 90 Plus High Efficiency line of upflow gas furnaces are designed for utility rooms, closets, or alcoves. Because of the low-profile 34 inch height, the
RGFDmodel can be used vertically to satisfy most applications that traditionally call for a horizontal furnace.
The design is certified by CSA.
Modulating Furnace
Thermostat
RHC-TST401MDMS
Features
■Heat exchanger is constructed of all stainless steel for maximum corrosion resistance and thermal fatigue reliability.
■Modulating Function: when used with a modulating thermostat, modulation rate between 40% and 100% of total capacity.
■Two-stage Function: when used with a two-stage thermostat, furnace operates at 40% on first stage, and stages up to 65%, then 100% for second stage.
■Multistage Function: when used with a single-stage thermostat, furnace functions as a three stage furnace operating at 40%, 65% and 100% of total capacity.
■Reduced firing rates, electrically efficient ECM2+ motor, and solid doors provide the ultimate in quiet operation.
■Low speed constant fan.
■Constant temperature rise for superior comfort.
■Seven segment LED for system diagnostics.
■Diagnostic history for troubleshooting.
■Two-speed induced draft motor.
■Direct spark ignition with remote sense.
■Top electrical connections, left or right gas and condensate drainage connections on downflow models.
■Optional indoor or outdoor combustion air.
A variety of cooling coils and plenums designed to use with the Prestige Series® 90 Plus gas furnaces are available as optional accessories.
The BEST BUY SEAL is a registered trademark of Consumers Digest Communications LLC, used under license.
A.F.U.E. (Annual Fuel Utilization Efficiency) calculated in accordance with Department of Energy test procedures.
PRESTIGE SERIES ® 90 PLUS HIGH EFFICIENCY MODULATING UPFLOW GAS FURNACE
REMOTE SENSOR |
IN-SHOT BURNERS |
DIRECT SPARK IGNITION
PRIMARY AND
SECONDARY
HEAT EXCHANGER
GAS
VALVE
PRESSURE
SWITCHES
IGNITION
CONTROL
INTEGRATED
FURNACE CONTROL
BLOWER ASSEMBLY
DRAFT INDUCER
WITH ECM MOTOR
STANDARD EQUIPMENT
Completely assembled and wired; heat exchanger; primary: 409 and aluminized 409 stainless steel, secondary: 29-4C stainless steel; induced draft; pressure switches; redundant modulating main gas control; blower compartment door safety switch; solid state time on/off blower control; limit controls; manual shutoff valve; 100% safety lock out; cool fan off delay; one hour automatic retry; power and self-test diagnostics; flame sense current diagnostics; electronic air cleaner connections; humidifier connections; humidifier on/off delay; dehumidifier connection; low speed continuous fan option; transformer; direct drive, ECM variable speed blower motor. (Please note: a thermostat is not included as standard equipment. See “Accessories”)
OPTIONAL EQUIPMENT
Side and bottom filter racks; return air cabinet for all sizes.
NOTE: Furnace is not listed for use with fuels other than natural or L.P. (propane) gas.
All models can be converted by a qualified distributor or local service dealer to use L.P. (propane) gas without changing burners. Factory approved kits must be used to convert from natural to L.P. (propane) gas and may be ordered as optional accessories from a parts distributor.
For L.P. (propane) operation, refer to Conversion Kit Index Form. Fossil Fuel Kits for use with Heat Pumps.
WARNING
2 Rheem Manufacturing Company
THIS FURNACE IS NOT APPROVED
OR RECOMMENDED
FOR USE IN MOBILE HOMES
BEFORE PURCHASING THIS APPLIANCE, READ IMPORTANT ENERGY COST AND EFFICIENCY INFORMATION AVAILABLE FROM YOUR RETAILER.
PHYSICAL DATA AND SPECIFICATIONS—UPFLOW MODELS
U.S. and Canadian Models
MODEL NUMBERS |
RGFD-06EMCK |
RGFD-07EMCK |
RGFD-09EZCM |
RGFD-10EZCM |
RGFD-12ERCM |
|||||||
INPUT–MAXIMUM (BTU/HR) [kW] |
60,000 [17.58] |
75,000 [21.98] |
90,000 |
[26.38] |
105,000 |
[30.77] |
120,000 |
[35.17] |
||||
|
|
|
|
|
|
|
|
|
||||
HEATING CAPACITY–MAXIMUM [kW] |
55,800 [16.35] |
72,000 [21.10] |
86,000 |
[25.20] |
100,000 |
[29.31] |
115,000 |
[33.70] |
||||
|
|
|
|
|
|
|
|
|
|
|
||
INPUT–MINIMUM (BTU/HR) [kW] |
24,000 |
[7.03] |
30,000 |
[8.79] |
36,000 |
[10.55] |
42,000 |
[12.31] |
48,000 |
[14.07] |
||
|
|
|
|
|
|
|
|
|
|
|
||
HEATING CAPACITY–MINIMUM [kW] |
22,560 |
[6.61] |
28,200 |
[8.26] |
33,840 |
[9.92] |
39,000 |
[11.57] |
45,120 |
[13.22] |
||
HEATING EXT. STATIC PRESSURE [kPa] |
0.12 |
[.029] |
0.12 |
[.029] |
0.15 |
[.037] |
0.20 |
[.049] |
0.20 |
[.049] |
||
BLOWER (D X W IN.) [mm] |
11 x 7 [279 x 178] |
11 x 7 [279 x 178] |
12 x 11 [305 x 279] |
12 x 11 [305 x 279] |
11 x 10 [279 x 254] |
|||||||
ECM MOTOR HP [W] |
1/2 [373] |
1/2 [373] |
1 [746] |
1 [746] |
1 [746] |
|||||||
UNIT AMPS |
8.7 |
8.7 |
12.0 |
12.0 |
12.0 |
|||||||
MAXIMUM OVERCURRENT PROTECTION |
15 |
15 |
15 |
15 |
15 |
|||||||
|
|
|
|
|
|
|
|
|
||||
HEATING CFM–MAXIMUM [L/s] |
795 |
[375] |
995 |
[470] |
1195 |
[564] |
1395 [658] |
1595 [753] |
||||
HEATING CFM–MINIMUM [L/s] |
320 |
[151] |
430 |
[203] |
515 |
[243] |
600 |
[283] |
685 |
[323] |
||
COOLING CFM–RANGE [L/s] |
600-1200 [283-566] |
600-1200 [283-566] |
1200-2000 [566-944] |
1200-2000 |
[566-944] |
1200-2000 |
[566-944] |
|||||
MAXIMUM EXT. STATIC PRESSURE [kPa] |
0.80 |
[0.20] |
0.80 |
[0.20] |
0.80 |
[0.20] |
0.80 |
[0.20] |
0.80 |
[0.20] |
||
|
|
|
|
|
|
|||||||
TEMPERATURE RISE RANGE °F [°C] |
40-70 [22.2-38.9] |
40-70 [22.2-38.9] |
40-70 [22.2-38.9] |
40-70 [22.2-38.9] |
40-70 [22.2-38.9] |
|||||||
|
|
|
|
|
|
|||||||
MAX OUTLET AIR TEMPERATURE °F [°C] |
170 [76.7] |
180 [82.2] |
180 [82.2] |
180 [82.2] |
180 [82.2] |
|||||||
RETURN AIR CABINETS–RXGR- |
C17B |
C17B |
C21B |
C21B |
C24B |
|||||||
|
|
|
|
|
|
|
|
|
|
|
||
FILTER SIZE (IN.) [mm] BOTTOM |
153/4 x 25 |
[400 x 635] |
153/4 x 25 |
[400 x 635] |
191/4 x 25 |
[489 x 635] |
191/4 x 25 |
[489 x 635] |
223/4 x 25 |
[578 x 635] |
||
FILTER SIZE (IN.) [mm] SIDE |
153/4 x 25 |
[400 x 635] |
153/4 x 25 |
[400 x 635] |
153/4 x 25 |
[400 x 635] |
153/4 x 25 |
[400 x 635] |
153/4 x 25 |
[400 x 635] |
||
APPROX. SHIPPING WEIGHT (LBS.) [kg] |
127 [57.6] |
133 [60.3] |
158 [71.7] |
162 [73.5] |
170 [77.1] |
|||||||
|
|
|
|
|
|
|||||||
AFUE |
93.4% |
92.8% |
94.1% |
92.4% |
93.2% |
|||||||
MODEL IDENTIFICATION
R |
G |
F |
D |
— |
|
07E |
|
|
|
|
M |
|
C |
|
K |
|
S |
||||||
Rheem |
Gas |
Modulating |
Design |
|
|
Heating Input |
|
|
|
Blower Size |
Variations |
Heat/Cool |
Fuel Code |
||||||||||
|
|
Furnace |
Prestige |
Series |
|
|
Designation |
|
|
M = 11 x |
7 |
|
C = Single/ |
Designation |
S = U.S. and |
||||||||
|
|
|
|
Series ® |
|
|
|
|
Electric |
|
|
|
|
|
[279 x 178 mm] |
Multi Zone |
K = 600-1200 CFM |
Canadian |
|||||
|
|
|
|
90 Plus |
|
|
|
|
|
|
|
|
R = 11 x |
10 |
|
|
|
[283-566 L/s] |
Natural Gas |
||||
|
|
|
|
|
|
Electric |
Ignition— |
|
Input |
|
|
|
|||||||||||
|
|
|
|
Gas Furnace |
|
|
|
|
[279 x 254 mm] |
|
|
M = 1200-2000 CFM |
|
||||||||||
|
|
|
|
|
|
Ignition |
Nox Models |
|
BTU/HR |
|
|
|
|
|
|||||||||
|
|
|
|
|
|
|
|
|
Z |
= 12 x |
11 |
|
|
|
[566-944 L/s] |
|
|||||||
|
|
|
|
|
|
|
|
|
06E |
06N |
60,000 |
[17.6 kW] |
|
|
|
|
|||||||
|
|
|
|
|
|
|
|
|
|
[305 x 279 mm] |
|
|
|
|
|
||||||||
|
|
|
|
|
|
|
|
|
07E |
07N |
75,000 |
[20.5 kW] |
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
09E |
09N |
90,000 |
[26.4 kW] |
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
10E |
10N |
105,000 |
[30.7 kW] |
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
12E |
— |
120,000 [35.2 kW] |
|
|
|
|
|
|
|
|
|
|||
[ ] Designates Metric Conversions
Rheem Manufacturing Company |
3 |
Loading...