R-600
R-600(shown)
R-650
Use and
Care Guide
30689_R-600/650_IB 8/24/06 2:42 PM Page 1
®
®
MC
IMPORTANT SAFETY
INSTRUCTIONS
3
When using an electrical appliance,
basic precautions should always be
observed, including the following. Read
all instructions before using this shaver.
DANGER
To reduce the risk of electric shock:
■ Do not reach for an appliance that
has fallen into water.Unplug it
immediately.
■ Do not use while bathing or in
the shower.
■ Do not place or drop into water or
other liquid.
■ Do not place or store this appli-
ance where it can fall or be pulled
into a tub or sink.
■ Except when charging, always
unplug this appliance from the
electrical outlet immediately
after using.
■ Use only when the shaver is in dry
condition.
■ Detach the appliance from the
power supply cord before
cleaning.
■ Do not submerge in water.
■ Do not use outdoors or operate
where aerosol (spray) products
are being used or where oxygen
is being administered.
■ Always attach the plug to the
appliance, then to outlet. To disconnect, turn all controls to OFF,
then remove plug from outlet.
■ Always pull on cord plug to unplug
from wall socket. Never pull on
electric cord.
■ Do not plug or unplug this appli-
ance when your hands are wet.
■ Do not use an extension cord
or a voltage converter with this
appliance.
■ Do not wrap the cord around the
appliance.
■ Al ways store this appliance and
cord in a moisture-free area.
Do not store it in temperatures
exceeding 140°F (60°C).
■ Detach removable power cords
from appliance for storage.
■ Do not use this appliance with
a damaged or broken head or
cutters, as facial injury may occur.
■ Shavers, including the trimmer,
are for use on facial hair only.
Should not be used for shaving
the hair on your head or any
other part of your body.
WARNING
To reduce the risk of burns,fire,
electric shock, or injury to persons:
■ An appliance should never be left
unattended when it’s plugged in,
except when charging a rechargeable appliance.
■ Close supervision is necessar y
when this appliance is used by,
on, or near children or invalids.
■ Use this appliance only for its
intended use as described in
this manual. Do not use attachments not recommended
by Spectrum Brands, Inc.
■ Never operate this appliance if
it has a damaged cord or plug
or if it is not working properly,
if it has been dropped or damaged,
or if it has been dropped into
water.If any of these things
happen, return the appliance to
Spectrum Brands, Inc.or call the
service center for assistance.
■ Keep the cord away from heated
surfaces.
■ Never drop or insert any object into
any of the appliance’s openings.
■ Household use only.
2
SAVE THESE INSTRUCTIONS
Contents
English ..............................1
Spanish ...........................13
French ............................25
30689_R-600/650_IB 8/24/06 2:42 PM Page 2
4
Titanium MicroFlex®600
Congratulations on your purchase of a premium
Remington®shaver.
The MicroFlex® 600 has Revolutionary Titanium Shaving Technology.
Product Features
(G)
(F)
(E)
(C)
(I)
(D)
(B)
(H)
(A) Head & cutter assembly
(B) On/off button
(C) Green charging indicator
(D) Low-batter y indicator (red) sho ws
when shaver needs charging
(E) Trimmer button
(F) Storage pouch
(G) Plastic head guard
(H) Cleaning brush
(I) Power Adapter
Shaver Parts
(A)
Easy-View
®
Locking trimmer
Which model is yours?
R-600
R-650
Pouch
x
x
Power
System
Rechargeable
Corded &
Rechargeable
Run
Time
60 min.
60 min.
Charge
Time
24 hours
24 hours
Locking
Trimmer
x
x
Power System
■ Corded & Rechargeable Use:
Rechargeable for cord-free shaving.
Also can be used with a cord.
■ Rechargeable Use Only:
Shaver will only operate if battery
is charged.
Indicator Lights
Charging
■ The charging indicator is a green
light that glows when the shaver
is charging.
■ The low-charge indicator is a red
light that glows when the shaver
needs recharging.You have
approximately 5 minutes of
shaving time left when the red
indicator first comes on.
5
30689_R-600/650_IB 8/24/06 2:42 PM Page 4
6
Getting a Close,
Comfortable Shave
Remington®brand shavers need no
adjustments to their heads or cutters
before you shave.The heads will
automatically adjust to the contours of
your face. It is not necessary to apply
pressure while shaving, just let the
shaver glide lightly on your skin.This
gentle touch makes shaving easier and
helps avoid possible skin irritation.
As with every shaver,your shave will
improve over time. So allow about three
weeks to develop an effective shaving
style and for your beard to adjust to the
new shaver.The adaptation period may
take a little longer if your skin is sensitive, or if you alternate between shaving
methods.
It’s simple to get a great shave from
your new shaver.Here are a few tips:
■ Always use a clean,
dry shaver. Make
sure that the cutter
head assembly is in
the locked position.
■ Wait at least 15
minutes after getting
up before shaving, to
ensure your face is
free of puffiness that
may be present
from sleeping.
■ Make sure your face
is clean and dry
before starting.
To shave
■ Push the ON/OFF
button to activate
the shaver for
shaving.
■ Hold the shaver so
all the heads touch
your face together.
This allows the
shaver to work the
way it was designed
for the closest
shave and minimum wear.Avoid
holding the shaver at an angle so
only one head touches the skin.
This could cause skin irritation.
■ Use short,circular
strokes. Use your
free hand to stretch
your skin.This
encourages your
whiskers to stand
out, making it
easier for them to
enter the cutting chamber.
■ Never press hard.Pressing only
flattens your whiskers, which
makes it harder for them to enter
the cutting chamber.It will also
wear out the cutting surface
more quickly.
To trim
To use the EasyView™pop-up
trimmer,simply
push the trimmer
button up.The
trimmer will pop up
for ready use. Hold the shaver as
shown in the illustration.To conserve
battery energy (on rechargeable
shavers only), it is recommended to
use the trimmer only when needed for
trimming.When through using, push
the trimmer button downward to lock
into the OFF position.
NOTE: It is important to always
use the button to close the trimmer
to avoid damaging the locking
mechanism.
Trim sideburns
Simply touch the
edge of the trimmer
to the desired line
for neat, clean
sideburns.
Trim mustache
Hold shaver at
desired trim line
for a quick, easy,
professional trim.
The trimmer can
also be used to trim
the upper edge
of your mustache.
! Always keep the protective head
guard on the shaver head and keep
the trimmer in the OFF position when
the shaver is not in use.
6
12
9
3
Before using read the important
safety instruction section in front
of the manual.
To Charge
Before using your shaver for the first
time, charge it for 24 hours.
■
Slide the ON/OFF button to the OFF
position.
■ Connect the cord to the shaver
and then to the electrical outlet.
The Charging Indicator light will
glow green, indicating your
shaver is charging.
■ Your shaver cannot be over-
charged, so you can leave
it plugged in and charging
between shaves.
■ Use only the supplied cord.
The R-600 & R-650 fully recharges in
24 hours.
Once fully charged, your shaver will
run up to 60 minutes without a cord.
The R-650 has corded & cord free use.
NOTE: It may take up to 3 cycles of full
charge and discharge to maximize
battery capacity.
7
Operating Instructions
This is a washable
shaver,the head
assembly part
of which may be
cleaned under water.
30689_R-600/650_IB 8/24/06 2:42 PM Page 6
9
8
Cleaning and Maintenance
When is it Time to Replace
Your Heads and Cutters?
It is very important to replace your
heads and cutters when necessary
to ensure a close,comfortable sha ve
without irritation.We recommend
they be replaced every 12 months.
Here are some signs of head and
cutter wear,indicating that replacement is needed.
Irritation
As the heads get excessively worn you
may experience some skin irritation.
This would be especially noticeable
when you apply after-shave lotion.
Pulling
When the cutters wear you may
feel a sense of pulling and a loss of
closeness when you shave.This is
an indication that it is time to replace
your heads and cutters.
The replacement part for models
R-600 & R-650 is model #SP-27.
U.S. residents: To order, contact
us at 800-231-8793, visit us at
www.remington-products.com
or visit your local retailer.
Canadian residents: For any shaver
accessory requirements, please
call
800-268-0425 or
visit us at
www.remington-products.com
Repeat this process
for each of the 3
heads. Clean each
head and cutter set
one at a time to
prevent mixing
cutter components.
(These should be
kept as sets).After
cleaning,place
cutter retainer
assembly in the hair pocket, and
secure by turning center knob
approximately 1/4 turn clockwise.
Caution: Never put the shaver
completely under water.Do not use
any aggressive cleansing agent as
this may destroy the shaver coatings.
■ To clean and lubricate your
shaver’s cutters and head
assembly,apply Remington
®
Shaver Saver®(SP-4) Lubricant.
The lubricant helps remove hair
clippings while reducing wear.
A quick spray after each shave
keeps your shaver operating at
peak performance.
Caution: Do not remove or replace
the head assembly while shaver is
running or plugged into an electrical
outlet as it may cause damage to the
unit’s cutters.The shaver shall not be
used until it has dried.
■ Worn or damaged parts should be
replaced with Remington®branded
replacement parts only.
Cleaning your shaver
TO ASSURE OPTIMAL PERFORMANCE,
IT IS RECOMMENDED THAT YOU CLEAN
YOUR SHAVER AFTER EACH USE.
Before cleaning,detach the handheld
unit from the power supply cord before
cleaning.The cutting system of this
shaver was designed to be cleaned by
rinsing under warm running water or
by brushing.
Cleaning your
Remington®branded
shaver is easy.
■ Open the hair
pocket by pressing
the release button
and rotating away from the body of
the shaver.You may blow out the
stubble thoroughly,or rinse the shaver
head in water.Rinse both sides of the
head assembly.
■At Least Once a
Week:
For more complete
cleaning,remove the
cutter retainer
assembly from the
hair pocket by turning the center knob
approximately 1/4 turn counter clockwise.Hold cutter retainer assembly as
shown, and remove head by turning
approximately 1/8 turn in the direction
shown. Brush clean both the head
and the cutter.Reassemble head to
cutter retainer assembly by aligning
and turning head 1/8 turn in the
opposite direction.
30689_R-600/650_IB 8/24/06 2:42 PM Page 8
Performance Guarantee
10
Full Two-Year Warranty
Spectrum Brands, Inc. warrants this
product against any defects that are
due to faulty material or workmanship
for a two-year period from the original
date of consumer purchase.This
warranty does not include damage
to the product resulting from accident
or misuse.
If the product should become defective
within the warranty period, we will
repair it or elect to replace it free of
charge. Return your product and sales
receipt with your name, address and
day time phone number to: Spectrum
Brands, Inc.,Attention: Consumer
Services, 601 Rayovac Drive, Madison,
WI 53711. For more information call
800-736-4648 in the US or
800-268-0425 in Canada.
Warranty excludes:
■ Screens and cutters
KEEP ORIGINAL SALES RECEIPT
AS PROOF OF PURCHASEFOR
WARRANTY PURPOSES.
This warranty does not cover products
damaged by the following:
■ Accident, misuse, abuse or
alteration of the product
■ Servicing by unauthorized persons
■ Use with unauthorized
accessories
■ Connecting it to incorrect current
and voltage
■ Wrapping cord around appliance
causing premature wear &
breakage
■ Any other conditions beyond
our control
11
SPECTRUM BRANDS, INC. SHALL
NOT BE RESPONSIBLE FOR ANY
INCIDENTAL,SPECIAL OR CONSEQUENTIAL DAMAGES RESULTING
FROM THE USE OF THIS PRODUCT.
ALL IMPLIED WARRANTIES,
INCLUDING BUT NOT LIMITED TO
IMPLIED WARRANTIES OF FITNESS
AND MERCHANTABILITY, ARE
LIMITED IN DURATION TO TWO
YEARS FROM DATE OF ORIGINAL
PURCHASE.
This warranty gives you specific legal
rights and you may also have other
rights which vary from state to state
or province to province. Some states
do not allow the exclusion or limitation of incidental, special or consequential damages.
Spectrum Brands, Inc.
Money-back Offer
If within 30 days after you have
purchased your Remington®branded
product, you are not satisfied and
would like a refund, return it with the
sales slip indicating purchase price
and date of purchase to the retailer
from whom it was purchased.
Spectrum Brands, Inc. will reimburse
all retailers who accept the product
within 30 days from the date of
purchase. If you have any questions
concerning the money-back guarantee, please call 800-736-4648 in the
US or 800-268-0425 in Canada.
120 V ac, 60 Hz
3.8 V, 80mA
U.S. Patent:s 5,390,146; 5,408,749
and Patents Pending;
Questions or comments:
Call 800-736-4648 in the US
or 800-268-0425 in Canada.
or visit www.remington-products.com
Dist. by: Spectrum Brands, Inc.,
Madison,WI 53711
Dist. by: Spectrum Brands Canada, Inc.,
Mississauga, ON L4W 2T7
REMINGTON, MICROFLEX and EASY VIEW
are trademarks of ROVCAL, INC.
© 2006 ROVCAL, INC.
6/06 Job #CS30689
MADE IN CHINA
T22- 20906
30689_R-600/650_IB 8/24/06 2:42 PM Page 10
Loading...