Press it to detach the front panel when you want to take away.
2.CDP (CD PLAY,PAUSE)BUTTON
At CD mode,press it to pause the CD playing and press it again to
resume CD playback.
3.LCD FREQUENCY DISPLAY
4.CD COMPARTMENT
5.LED DISPLAY
This is to show the track no.of CD.
Page 3
6,17. TRACK UP/DOWN BUTTONS
a. During CD mode, press button to allow you to choose track forward.
Hold the button to allow you to skip forward.
b. During CD mode, press button to allow you to choose track backward.
Hold the button to allow you to skip backward.
7,18.VOLUME CONTROL
Press the“+”or ”-” to increase or decrease the volume level.
8. EJECT BUTTON
Press it to eject the CD DISC.
9. TUNING KNOB
Rotate it to select your desired broadcasting station.
10.POWER BUTTON
Press it to turn on or off the unit.
11.BAND BUTTON
Press it to select your desired radio band.
12.MODE BUTTON
Press it to select between CD or radio function.
Page 4
13.MUTE BUTTON
Press it to reduce the volume level immediately.
14.LOC BUTTON
Press it to select distance reception or local reception. Local control is
no effect at AM band.
15.REPEAT BUTTON
During CD mode, Press RPT button to repeat a single track.
16.TOP BUTTON
Press this Button to go to the start of the CD (CD will start again from
Track 1).
19.HOUR BUTTON
Press it to adjust HOUR of clock.
20.MINUTE BUTTON
Press it to adjust MINUTE of clock.
IMPORTANT:
MEMORY WIRE (FOR BACKUP) AND POWER WIRE CAN NOT BE SWITCHED
OFF AT THE SAME TIME, ONCE IT HAPPENS, ALL THE FUNCTION WILL BE
TOTALLY IN DISORDER (DISTORTED DISPLAY IS ALSO INDICATED).
IF IT REALLY HAPPENS, PLEASE FOLLOW THE INSTRUCTIONS AS MENTIONED
BELOW:
5 MINUTES LATER, PLEASE SWITCH ON THE MEMORY WIRE FIRST (CAN NOT
PASS THROUGH IGNITION SWITCH) AND THEN SWITCH ON THE POWER. IT WILL
RETURN TO NORMAL FUNCTION SOON.
Page 5
DISC PLAY:
Cleaning discs
Before playing ,clean the disc with a clean, lint-free,
Flip the disc in the direction of the arrow.
Note:
Do not use so solventssuch as benzine, thinners, commercially available
cleaners or anti static spray damage the unit:
insert a disc with the label surface down.Doing so may damage the unit.
Label
surface up
Note:
Do not try to insert another disc when one has been already inserted.
Doing so may damage the unit.
Handle the disc by its edge.And to keep the disc clean do not touch
the surface.
Do not stick paper or tape on the disc.
Do not expose the disc to direct sunlight or heat sources such as hot air
Ducts, or leave it in a car parked in direct sunlight where there can be a
considerable rise in temperature.
Page 6
TROUBLE SHOOTING
Before going through the check list, wiring connection, should any of the
problem persist after check list has been made, consult your nearest service
dealer.
SymptomCause
The car ignition is not on.
No power
The fuse is blown
Presence of CD disc inside
Disc cannot
be loaded or
ejected
No sound
Sound skips
the player
Inserting the disc in upside
down.
Compact disc is extremely
dirty or defective
Temperature inside
the car is to high
Condensation
Volume is in minimum
Wiring is not properly
connected
The installation angle
is more than 30 degrees
Solution
If the power supply is properly
connected to the car accessory
switch the ignition key to “ACC”
Replace the fuse
Remove the disc in the player
then put a new upward
Insert the compact disc with
the label facing upward
Clean the disc or try to play a
new one
Cool off until the ambient
temperature returns to normal
Leave the player off for an
hour or so, then try again
Adjust volume to a desired level
Check wiring connection
Adjust the installation angle
to less than 30 degrees
The disc is extremely
dirty or defective
The antenna cable is not
The radio does
not work
connected
the signals are to weak
Clean the compact disc/try to
play a newone
Insert the antenna cable firmly
Select a station manually
Page 7
SPEAKER CONNECTION
ANTENNA PLUG
RCA LINE OUT PLUG
MEMORY BACKUP
POWER SUPPLY
AUTO ANTENNA
WHITE (L)
RED (R)
3A
FUSE
0.5A
FUSE
YELLOW
ORANGE
RED
+GREEN
GREY+
L
LEFT
-GREEN/WHITE
+GREEN
GREY/WHITE-
GREY+
L
-GREEN/WHITE
NOTE:
In spite of having any kinds of speaker system, must use 4ohms
impedance of speaker to reduce the distortion during high volume
level.
GREY/WHITE-
SPECIFICATION
GENERAL
BLACK GROUND
R
RIGHT
R
Power requirement
Current consumption
Maximum output power
FM SECTION
Frequency range
Usable sensitivity
IF Frequency
AM SECTION
Frequency range
LINE -OUT(OPTION)
Output
Impedance
CD PLAYER
System
Usable disc
Signal to noise radio
Chassis dimensions
DC 13.8V negative ground.
3A MAX.
High Power
87.5MHz-108MHz
10uV.
10.7MHz
520KHz-1710KHz
250mV@FM10%THD POWER.
600ohm.
compact disc audio system.
compact disc.
70dB[1KHz] [IEC-A net work].
183[W]X53[H]X160[D].
Page 8
INSTALLATION
DASH BOARD
METAL MOUNTING STRAP
SPRING WASHER
TAPPING
SCREW
CONSOLE
SLIDE BRACKET HOUSING
HEX BOLT
PYRAMID STEREOS
KEY PLATE
PLASTIC TRIM OUT
KEY PLATE
CAR STEREOS
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.