Precor C942, C940, M9.41s, c944, M9.45 User Manual

5 (1)

C O M M E R C I A L P R O D U C T S D I V I S I O N

Precor Handrail Option Kit

Fits Precor C944, C942, C940, M9.45, M9.41s Treadmills

Thank you for purchasing the Precor Handrail Option Kit. Each kit comes complete with all the hardware required to install a handrail on one side of the treadmill. If you wish handrails on both sides of the treadmill, you must order two

(2) option kits. When you receive the Handrail Option kit, check its contents with the list below:

Note: If you purchase both handrails, check the contents of both kits with the list below:

Handrail Option Kit Contents

One handrail

One upper end clamp

One upper center clamp

Three large bolts (two 5/16 - 18 x 2.5 and one 1/4 - 20 x 2.5)

One star washer

One nut plate

One lower clamp

One 5/32" hex key

One 3/16" hex key

Note: To assemble the handrail(s), you will need a Phillips head screwdriver.

ASSEMBLY INSTRUCTIONS

The assembly of each handrail is the same on opposite sides of the treadmill. To properly install the handrail(s) on your unit, take the following steps:

CAUTION: Turn OFF the unit and unplug it from the power source before installing the handrail(s).

Precor C942, C940, M9.41s, c944, M9.45 User Manual

C O M M E R C I A L

P R O D U C T S

D I V I S I O N

Diagram 1

 

 

Installing the nut plate

 

 

into the guide rail.

 

 

End cap

 

 

Bolt

 

 

Finger guard

 

 

Rear roller

 

 

Side rail

 

 

Guide rail

 

 

Nut plate

 

 

1.To properly mount the lower handrail clamp, you need to install a nut plate into the guide rail. Remove the end cap from the rear of the treadmill using a Phillips head screwdriver. See Diagram 1.

Important: If you are installing both handrail options, avoid misalignment of the finger guard by sliding the nut plate into position on one side of the treadmill and replace the end cap before removing the other end cap.

2.With the nut plate installed and the end cap replaced, move to the front of the treadmill.

Diagram 2

Attaching the front

section of the handrail.

Electronic console

Upper frame

Handrail end cover

End clamp

Center clamp

Bolt

Upright support

Handrail

3.Locate the end covers on the upper handrails. See Diagram 2. Using the 3/16" hex key remove the two rear handrail end covers (the “covers” are large black washers). Discard the covers and the bolts. Replacement bolts and clamps are in this option package.

Important: If you are installing both handrail options, install a handrail on one side before proceeding to the other side of the treadmill. Attach the front portion of the handrail first. This helps you determine where to position the lower handrail clamp.

Loading...
+ 2 hidden pages