Page 1
LED
DRIVER
LEDS
0-10VDC - GRAY
LINE
NEUTRAL
0-10VDC + PURPLE
0-10V LED
DRIVER
0-10V
CONTROL
MODULE
+
-
RM-0-10V
1-Sep-2017
Install Guide
The RM-0-10V is a small module designed to be installed in lighting fixtures to enable control of the fixture by
controllers that implement Relay Dimming. The controller communicates to the RM-0-10V using a pattern of
relay open and close events to change the lighting level to one of the preselected levels or to increase or
decrease the current light level.
The RM-0-10V is installed according to the wiring diagram below.
The RM-0-10V does not contain an address or other identifying information that the transmitter must know to
communicate with it. This means that any RM-0-10Vcan be installed in any fixture and does not need to be
programmed before or after installation.
If the transmitter powers more than one LED fixture install a RM-0-10V in each fixture.
Note: When using the
communication to the
To test the RM-0-10V installation use the WS1C wall switch or KPLC keypad to verify correct
operation. The fixture should dim or brighten using the paddle of the WS1C or the keypad buttons of
the KPLC.
RM-0-10V you may hear the controller relays going on and off very quickly. That is the
RM-0-10V and is as expected.
SPECIFICATIONS
Requirements WS1C
Connections
Input Power
Input Frequency
Operating Temp
Limited Warranty
Seller warrants this product, if used in accordance with all applicable instructions, to be free from original
defects in materials and workmanship for a period of five years from the date of purchase. Refer to the
warranty information on the PulseWorx website (www.PulseWorx.com) for exact details.
19201 Parthenia Street, Suite J
Northridge, CA 91234 pcssales@pcslighting.com
P: 818.701.9831 www.pcslighting.com
16 GA, 105 C insulation
120 or 277 VAC
60 ± .3 Hz
-40 °F to 140 °F
Loading...