R Trademark
Please do not return unit to retailer.
Por favor, no devuelva el aparato al lugar de compra.
Veuillez ne pas retourner l’outil au détaillant.
1-800-554-6723
www.weedeater.com
Instruction Manual
Manual de Instrucciones
Manuel d’Instructions
BV200 / BV1650 / BV1800
BV1850 / BV2000
LE Series
IMPORTANT MANUAL - Do not throw away MANUAL IMPORTANTE - No lo descarte MANUEL IMPORTANT - À Conserver
WARNING:
Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury.
ADVERTENCIA:
Lea el manual de instrucciones y siga todas las advertencias e instrucciones de seguridad. El no hacerlo puede resultar en lesiones graves.
AVERTISSEMENT:
Veuillez lire le manuel d’instructions et bien respecter tous les avertissements et toutes les instructions de sécurité. Tout défaut de le faire pourrait entraîner des blessures graves.
WEED EATER
1030 Stevens Creek Road
Augusta, GA 30907
545137217 11/30/06
ENGLISH
ESPAÑOL
FRANÇAIS
IDENTIFICATION OF SAFETY SYMBOLS
WARNING: This unit can be dangerous! Careless or improper use can cause serious injury.
Read your operator’s manual carefully until you completely understand and can follow all warnings and safety rules before operating the unit. Failure to do so can result in serious injury. Save operator’s manual.
WARNING: The muffler is very hot during and after use. Do not
touch the muffler, muffler guard, or surrounding surfaces, or allow combustible material such as dry grass or fuel to do so.
The blower can throw objects violently. You can be blinded or injured. Always wear hearing protection and safety glasses marked Z87. Always wear heavy, long pants, long sleeves, boots and gloves.
Hazard zone for thrown objects. Keep children, bystanders, and animals away from work area a minimum of 30 feet (10 meters) when starting or operating unit. Do not point blower nozzle in the direction of people or pets.
Secure hair above shoulder length. Do not wear jewelry, loose clothing, or clothing with loosing hanging straps, ties, tassels, etc. They can be caught in moving parts.
Always stop unit and disconnect spark plug before cleaning or servicing.
-- 2 --
IDENTIFICATION OF SAFETY SYMBOLS
WARNING: Stop the engine before opening the vacuum inlet door. The engine must
be stopped and the impeller blades no longer turning to avoid serious injury from the rotating blades. Gently tilt the handle of the screwdriver toward the back of the unit to release the latch while pulling up on the vacuum inlet cover with your other hand.
When using the vacuum attachment, the unit is designed to pick up dry material such as leaves, grass, small twigs, and bits of paper. Do not vacuum stones, gravel, metal, broken glass, etc., to avoid severe damage to the impeller.
WARNING: Fire hazard. Never mix, pour, or store gasoline or
use the unit near a flame or sparks (including smoking, open flames, or work that can cause sparks).
SAFETY RULES
WARNING: Failure to follow all Safety Rules and Precautions can result in serious injury.
KNOW YOUR UNIT
SRead your instruction manual carefully until you completely understand and can follow all warnings and safety rules before operating the unit.
DRestrict unit to users who understand and will follow all warnings and safety rules in this manual.
WARNING: Inspect area before starting unit. Remove all debris and hard objects such as rocks, glass, wire, etc. that can ricochet, be thrown, or otherwise cause injury or damage during operation.
Use your unit as a blower for:
D Sweeping debris or grass clippings from driveways, sidewalks, patios, etc.
DBlowing grass clippings, straw, or leaves into piles, around joints, or between bricks.
Use your unit as a vacuum for:
DPicking up dry material such as leaves, grass, small twigs, and bits of paper.
D For best results during vacuum use, operate your unit at high speed.
DMove slowly back and forth over the material as you vacuum. Avoid forcing the unit into a pile of debris as this can clog the unit.
DKeep the vacuum tube about an inch above the ground for best results.
PLAN AHEAD
DAlways wear eye protection when operating, servicing, or performing maintenance on unit. Wearing eye protection will help to prevent rocks or debris from being blown or ricocheting into eyes and face which can result in blindness and/or serious injury.
Eye protection should be marked Z87.
D Always wear foot protection. Do not go barefoot or wear sandals.
D Always wear respirator or face mask when working with unit in dusty environments.
DSecure hair above shoulder length. Secure or remove jewelry, loose clothing, or clothing with loosely hanging straps, ties, tassels, etc. They can be caught in moving parts.
DDo not operate unit when you are tired, ill, upset, or if you are under the influence of alco-
hol, drugs, or medication.
D Keep children, bystanders, and animals away from work area a minimum of 30 feet (10 meters) when starting or operating unit. Do not point the blower nozzle in the direction of people or pets.
HANDLE FUEL WITH CAUTION, IT IS HIGHLY FLAMMABLE
DEliminate all sources of sparks or flame (including smoking, open flames, or work that can cause sparks) in the areas where fuel is
mixed, poured, or stored.
DMix and pour fuel in an outdoor area; store fuel in a cool, dry, well ventilated place; use an approved, marked container for all fuel
purposes.
DDo not smoke while handling fuel or while operating the unit.
-- 3 --
D Make sure the unit is properly assembled and in good operating condition.
D Do not fill fuel tank while engine is hot or
running.
D Avoid spilling fuel or oil. Wipe up fuel spills before starting engine.
DMove at least 10 feet (3 meters) away from fuel and fueling site before starting engine.
D Always store gasoline in a container approved for flammable liquids.
OPERATE YOUR UNIT SAFELY
WARNING: Stop the engine before
opening the vacuum inlet door. The engine must be stopped and the impeller blades no
longer turning to avoid serious injury from the rotating blades.
D Inspect unit before each use for worn, loose, missing, or damaged parts. Do not use until unit is in proper working order.
D Keep outside surfaces free of oil and fuel. D Never start or run engine inside a closed
room, building or other unventilated area. Breathing exhaust fumes can kill.
D To avoid static electricity shock, do not wear rubber gloves or any other insulated gloves while operating unit.
D Do not set unit on any surface except a
clean, hard area while engine is running. Debris such as gravel, sand, dust, grass,
etc. could be picked up by the air intake and thrown out through discharge opening, damaging unit, property, or causing serious injury to bystanders or operator.
DAvoid dangerous environments. Do not use in unventilated areas or where explosive vapors or carbon monoxide build up could
be present.
DDo not overreach or use from unstable surfaces such as ladders, trees, steep slopes,
rooftops, etc. Keep firm footing and balance at all times.
D Never place objects inside the blower tubes; always direct the blowing debris away from people, animals, glass, and solid objects such as trees, automobiles, walls,
etc. The force of air can cause rocks, dirt, or sticks to be thrown or to ricochet which can
hurt people or animals, break glass, or cause other damage.
DNever run unit without the proper equipment attached. When using your unit as a blower, always install blower tubes. When using your unit as a vacuum, always install vacuum tubes and vacuum bag assembly.
Make sure vacuum bag assembly is completely zipped.
DCheck air intake opening, blower tubes, vacuum tubes, and elbow tube frequently, always with engine stopped and spark plug disconnected. Keep vents and discharge tubes free of debris which can ac-
cumulate and restrict proper air flow.
DNever place any object in the air intake opening as this could restrict proper air flow and cause damage to the unit.
DNever use for spreading chemicals, fertilizers, or other substances which may contain toxic materials.
DTo avoid spreading fire, do not use near leaf or brush fires, fireplaces, barbecue
pits, ashtrays, etc.
D Use only for jobs explained in this manual.
MAINTAIN YOUR UNIT PROPERLY
DHave all maintenance other than the recommended procedures described in the instruction manual performed by an autho-
rized service dealer.
D Disconnect spark plug before performing
maintenance except for carburetor adjustments.
DUse only recommended WEED EATER replacement parts; use of any other parts may void your warranty and cause damage
to your unit.
DEmpty fuel tank before storing the unit. Use up fuel left in carburetor by starting engine and letting it run until it stops.
D Do not use any accessory or attachment other than those recommended by manufac-
turer for use with your unit.
DDo not store the unit or fuel in a closed area where fuel vapors can reach sparks or an
open flame from hot water heaters, electric motors or switches, furnaces, etc.
D Store in a dry area out of reach of children.
SPECIAL NOTICE: Exposure to vibra-
tions through prolonged use of gasoline powered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or abnormal swelling. Prolonged use in cold weather has been linked to blood vessel damage in otherwise healthy people. If symptoms
occur such as numbness, pain, loss of strength, change in skin color or texture, or
loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An antivibration system does not guarantee the avoidance of these problems. Users who operate power tools on a continual and regular basis must monitor closely their physical condition and the condition of this tool.
SPECIAL NOTICE: For users on U.S. For-
est Land and in some states, including California (Public Resources Codes 4442 and
4443), Idaho, Maine, Minnesota, New Jersey, Oregon, and Washington: Certain internal
combustion engines operated on forest, brush, and/or grass covered land in the above areas are required to be equipped with a
spark arresting screen, maintained in effective working order, or the engine must be constructed, equipped, and maintained for the prevention of fire. Check with your state or local authorities for regulations pertaining to these requirements. Failure to follow these requirements is a violation of the law. This unit is not factory equipped with a spark arresting screen; however, a spark arresting screen is
available as an optional part. If a spark arresting screen is required in your area, contact
your authorized service dealer for the correct kit. The spark arresting screen, blower tubes, and nozzles must be assembled to unit to be in full compliance with regulations.
-- 4 --