Page 1
DOCUMENT ON DEMAND
DOC. NO. 10060
TOPIC: Error Codes for Pioneer A/V Products
Error Codes |
Cause |
11,12,17 |
Dirt or scratches on the disc stops |
|
the laser beam from being able to |
|
focus. |
11,17
14
14
30
80
75,90 -0,10,11,12,14,17,50,60,70,AO, A1,67,72,74,76,90,
No MAG
No MAG (flashes for 5 seconds)
NM ,(appears)
NM(flashes for 5 seconds )
Ready
U1
The disc has been inserted upside down.
The disc has been inserted upside down.
An unrecorded compact disc (CD-R), which can be recorded on once is being used.
Dirt or scratches on the disc hinder the track number search function.
There is no disc in the magazine. The door is open.
Electrical or mechanical system fault.
Removing the magazine from the CD player during CD play.
Power was turned on while the magazine was not loaded in the CD player.
Removing the magazine from the CD player.
Power was turned on while the magazine was not loaded in the CD player.
The CD player is warning up. The disc may not be loaded properly in the rack.
Treatment
Wipe off the dirt. Exchange the disc if it has been scratched.
Confirm that the disc has been inserted right side up.
Confirm that the disc has been inserted right side up
When you use a CD-R, load one that has been recorded and finalized.
Wipe the dirt off the disc. Exchange the disc if it is scratched.
Load a disc into the magazine. Close the door
Turn the car ignition switch off and on again, or press power ON/OFF button on the controller unit, and start the CD playing again. If the error indication does not disappear, contact your nearest Pioneer service center or station.
To use this system, load the magazine into the CD player and then turn on the power.
Turn on the power after loading the magazine into the CD player.
To use this system, load the magazine into the CD player and then on the power.
Turn on the power after loading magazine into the CD player.
Please wait a few moments.
∙Reload the discs properly (insert one disc only in a slot)
∙Check if there is foreign object attached onto the disc.
∙Check if there is a foreign object on the rack.
PIONEER ELECTRONICS SERVICE, INC. |
Phone: (800) |
421-1404 |
1925 E. Dominguez St. |
Fax: Customer Service (310) |
952-2821 |
Long Beach, CA 90810-1760 |
Fax: Parts Dept. (310) |
952-2247 |
|
http://www.pioneerelectronics.com |
*Note: Specification and design subject to modification without notice. Pioneer is not responsible for any typographical errors