Output Power per Channel at 1% THD (all channels driven)
Into 4 ohms @ 12.0 VDC .................................. |
24 watts x 2 |
Into 4 ohms @ 14.4 VDC .................................. |
35 watts x 2 |
Into 2 ohms @ 14.4 VDC .................................. |
60 watts x 2 |
Into 1 ohm @ 14.4 VDC .................................... |
93 watts x 2 |
Into 1/2 ohm @ 14.4 VDC ................................. |
150 watts x 2* |
Bridged into 4 ohms @ 14.4 VDC ..................... |
125 watts x 1 |
Bridged into 2 ohms @ 14.4 VDC ..................... |
185 watts x 1 |
Bridged into 1 ohm @ 14.4 VDC ....................... |
300 watts x 1* |
Frequency Response ........................................ |
±1dB from 20Hz to 20kHz |
Signal to Noise Ratio......................................... |
>100dB |
Lowest THD....................................................... |
0.02% |
Damping Factor................................................. |
500 to 1 |
Input Sensitivity ................................................. |
200 millivolts to 2 volts |
Input Impedance................................................ |
30k ohms |
Input Voltage Range.......................................... |
10.5 volts to 15.0 volts |
Typical current draw at idle................................ |
3 amps |
Continuous current draw @ full power**............ |
30 amps |
Peak current draw @ full power*** .................... |
40 amps |
Bass Boost ........................................................ |
+12 dB @ 45 Hz |
Recommended Fuse Size ................................. |
40 amps |
Dimensions........................................................ |
8.5"L x 11.4"W x 2.4"H |
*Low impedance operation requires cooling fans, large gauge power cable and at least 1 farad of capacitance. MINIMUM SPEAKER LOAD IS 1 OHMS BRIDGED OR 1/2
OHM STEREO.
**Average continuous current draw when playing typical music material
***Average peak current needed for musical peaks (<20 ms) when playing typical music material.