Pentair Legend II User Manual

0 (0)

®

Pressure Side Pool Cleaner

Installation Guide

IMPORTANT SAFETY INSTRUCTIONS

READ AND FOLLOW ALL INSTRUCTIONS

SAVE THESE INSTRUCTIONS

LEGEND® II INSTALLATION MANUAL

Customer Service

If you have questions about ordering Pentair replacement parts, and pool products, please use the following contact information:

Customer Service (8 A.M. to 5 P.M. — Eastern and Pacific Times)

Phone: (800) 831-7133

Fax: (800) 284-4151

Technical Support

Sanford, North Carolina (8 A.M. to 5 P.M. — Eastern Time)

Phone: (919) 566-8000

Fax: (919) 566-8920

Moorpark, California (8 A.M. to 5 P.M. — Pacific Time)

Phone: (805) 553-5000 (Ext. 5591)

Fax: (805) 553-5515

Web site

visit www.pentairpool.com and www.staritepool.com to find information about our products

© 2007 Pentair Water Pool and Spa, Inc. All rights reserved.

This document is subject to change without notice.

1620 Hawkins Ave., Sanford, NC 27330 • (800) 831-7133 • (919) 566-8000

10951 West Los Angeles Ave., Moorpark, CA 93021 • (800) 831-7133 • (805) 553-5000

Trademarks and Disclaimers. Pentair Water Pool and Spa and Legend are trademarks and/or registered trademarks of Pentair Water Pool and Spa, Inc. Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Pentair Water Pool and Spa, Inc. disclaims any proprietary interest in trademarks and trade names other than its own.

11/20/07 P/N YYLXMAN REV. C

LEGEND® II INSTALLATION MANUAL

®

LX 2000G

Important Information:

The Legend® II automatic pool cleaner comes ready to connect into a female threaded 1-1/2" dedicated return line. Other connections are possible, but they require additional fittings. For more information, please contact our Technical Support Department at 1-800-831-7133. Also, if you have a chlorinator, solar system or other air inducing equipment, please contact our Technical Support Department before you install the Legend® II.

The following are important facts to remember before installing and operating the Legend® II.

1.Always disconnect the Legend® II from the pool wall when cleaning or back washing the pool filter.

2.After cleaning or back washing, let the filtration system run for at least five minutes before reconnecting the Legend® II.

3.New plumbing lines should be flushed out before installing the Legend® II.

4.The Legend® II should not be used to remove plaster dust in new pools.

5.Always remove the Legend® II before swimmers enter the pool.

6.Always handle the Legend® II with care. Do not let children or pets play with the unit: it is not a toy.

7.Always pick up the Legend® II by the Vacuum Tube especially when lifting the unit out of the water.

8.Unless checking the wheel RPM, do not handle the Legend® II while it is operating.

9.Always remove the Legend® II from the pool before chemical shock treatments. As a rule, any pool water that is unsafe for swimming is unsafe for the Legend® II.

10.Carefully cut the feed hose following the instructions on Page 3.

By following these simple guidelines, you can help protect against injury and prolong the life of your Legend® II.

Before the Legend® II is installed, please take a moment to record the serial number. This number

is located on your warranty card and on the back of the Legend® II near the rear jet. You will be asked this number when you contact our Technical Support Department.

SERIAL #__________________________________

LEGEND® II INSTALLATION MANUAL

TABLE OF CONTENTS

I.

Introduction ................................................................................................................................

1

 

A. Thank You for Choosing the Legend® II ............................................................................

1

 

B. What to Expect from the Legend® II .................................................................................

1

II.

Installation Instructions ..............................................................................................................

2

 

A. Legend® II Components ....................................................................................................

2

 

B. Pool Connections .............................................................................................................

2

 

C. Installing the Twist Lock Pressure Relief Valve (Wall Fitting)............................................

2

 

D. Pressure Testing Instructions ...........................................................................................

3

 

E. Cutting the Feed Hose......................................................................................................

3

 

F. Hooking Up the Legend® II ...............................................................................................

4

 

G. Checking Operation .........................................................................................................

4

 

H. Fine Tuning the Legend® II ................................................................................................

5

 

1.

Thrust Jet Adjustment .................................................................................................

5

 

2.

Sweep Hose Adjustment .............................................................................................

5

 

3.

Checking Wheel RPM .................................................................................................

5

III. Operation & Periodic Maintenance .............................................................................................

7

 

A. Connecting/Disconnecting the Legend® II .........................................................................

7

 

B. Turning the Legend® II On/Off ...........................................................................................

7

 

C. Cleaning the Sand & Silt Bag ...........................................................................................

7

 

D. Periodic Maintenance .......................................................................................................

7

 

1.

Wall Fitting Screen ......................................................................................................

7

 

2.

Tires & Bearings .........................................................................................................

8

 

3.

Roller Rings ................................................................................................................

8

 

4.

Debris Bags ................................................................................................................

8

 

5.

Sweep Hose................................................................................................................

8

 

6.

Debris Valve................................................................................................................

8

 

E. Back Washing the Pool Filter............................................................................................

8

 

F. Storage and Winterizing ...................................................................................................

9

 

G. Accessories .....................................................................................................................

9

 

1.

Leaf Bag .....................................................................................................................

9

 

2.

Step Adapter ...............................................................................................................

9

IV. Troubleshooting and Performance Tips ................................................................................

10-12

 

Legend® II Parts List ......................................................................................................

13-14

 

Legend® II Exploded View....................................................................................................

15

LEGEND® II INSTALLATION MANUAL

I. Introduction

A.Thank You for Choosing the Legend® II Pool Cleaner

Congratulations on the purchase of your new automatic pool cleaner. The Legend® II is designed to give you years of dependable and efficient service. With the Legend® II, you and your family will spend more time relaxing and enjoying your pool and less time cleaning it.

The Legend® II has been designed and built with time proven features and patented innovations to create an automatic pool cleaner that will give you years of dependable service. The Legend® II is built with pride by people who care about the product using state of the art materials and backed by a limited warranty that protects against defects in parts and construction.

Like any mechanical device, the Legend® II requires some preventative maintenance and the replacement of certain working parts. We recommend that you have your Legend® II checked annually. For best results have your Legend® II installed by a qualified swimming pool professional.

For pool owners with plumbing and mechanical experience, installation instructions are included in this manual.

Please put safety first! Be sure to take your Legend® II out of your pool and store it carefully in a shaded area before anyone enters the pool.

B. What to Expect from the Legend® II

When operating correctly, the Legend® II will travel randomly throughout the pool, vacuuming and sweeping the bottom. The climbing ability of the Legend® II is dependent on the pools shape. It will climb better in pools without sharp angles or curves in the transition from the pool floor to the pool wall.

The Legend® II comes equipped with a Wall Fitting (Part# LXW22) that features a Twist Lock Automatic Pressure Relief Valve. If the Legend® II is receiving too much water pressure to the unit, the relief valve will automatically reduce water pressure.

Approximately every three minutes and 30 seconds the Legend® II will go into a back up mode. At this time the Back Up Valve will pull the Legend® II away from problem areas.

Occasionally some vinyl pools have steps installed so the unit may not climb and remains stationary until the Back Up Valve pulls the unit away from the steps. When this occurs you need to use the optional Step Adapter (Part# EU13) to prevent wearing the vinyl liner.

The Sweep Hose operates in a gentle sweeping motion to prevent debris from becoming trapped in hard to reach corners of the pool.

1

LEGEND® II INSTALLATION MANUAL

Pentair Legend II User Manual

II. Installation Instructions

A. Legend® II Components

The Legend® II Box Contains:

1.Cleaner Head

2.Sand & Silt Bag

3.Sweep Hose

4.Complete Feed Hose

a.1 - 18 in. hose

b.1 - 2 ft. hose

c.1 - 4½ ft. hose

d.3 - 6 ft. hoses

e.1- Back-Up Valve

f.4 - Swivels

g.1 - Wall Fitting

h.12 - Mender Nuts

i.7 - Hose Floats

j.1 - Pressure Tester

2

B. Pool Connections

The Legend® II comes equipped to connect to a female threaded 1-1/2" dedicated return line. An adjustable gate valve with a pressure gauge should be installed to allow a regulated amount of water flow from your pool system to the Legend® II. For more information contact our Technical Support Department at 1-800-831-7133.

Also, if the pool doesn't have a dedicated cleaner line please contact our Technical Support Department also.

C.Installing the Twist Lock Pressure Relief Valve (Wall Fitting)

1.Take out any existing pool cleaner and/or wall fitting.

2.Turn on the filtration pump and flush out the plumbing line.

3.Turn off filter pump

4.Remove the Wall Adapter from the Wall Fitting and screw Adapter by hand into the dedicated line. Turn until tight.

5.Take the Wall Fitting and Twist Lock the Wall Fitting into the Wall Adapter 1/4 turn; to a snug fit. Once the Wall Adapter is secure you can now twist lock and unlock to remove Wall Fitting with ease from the Wall Adapter.

LEGEND® II INSTALLATION MANUAL

Loading...
+ 14 hidden pages